Smittybilt 54034 User Manual

Installation Instructions

Bull Bar

(Part #54033/54034)

1999-2006 Toyota Tundra

2001-2005 Toyota Sequoia

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

QTY. CONTENT
1 BULL BAR

2 BRACKETS-PASSENGER & DRIVER SIDE
2 1/2 -13 X 2.00” HEX HEAD BOLT(M12X50mm)
4 ½” FLAT WASHERS
4 ½” LOCK WASHERS
2 M12-1.25 X 30MM HEX HEAD BOLT

STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ
INSTRUCTIONS COMPLETELY BEFORE BEGINNING.

STEP 2 IT MAY BE NECESSARY TO REMOVE/RELOCATE FRONT LICENSE PLATE AND
LICENSE PLATE BRACKET. IT IS NOT REQUIRED, BUT SRONGLY RECOMMENDED.

STEP 3 DETERMINE PASSENGER AND DRIVER BRACKETS. SEE FIGURE 1. REMOVE AND
DISCARD TIE DOWN LOOP AND TOW HOOK, (SAVE SHORTER 12MM FASTNERS). ATTACH
BRACEKTS USING SHORTER EXISTING FASTENERS AND SUPPLIED 12MM BOLTS AS
SHOWN. LEAVE LOOSE.

STEP 4 ATTACH BULL BAR TO BRACKETS USING ½” FASTENERS AS SHOWN. LEVEL AND
ADJUST BULL BAR AS DESIRED. TORQUE ALL FASTENERS TO 65 FT .LBS.

FINISH PROTECTION- PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH
AS ANY OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A
NON-ABRASIVE AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS
ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO
CORROSION.

DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE
INSTALLATION AND USE OF PRODUCTS. PRODUCTS ARE SOLD AS DECORATIVE
ACCESSORIES AND SHOULD NOT BE RELIED UPON AS PROTECTION FOR THE VEHICLE OR
OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER.

Page 1 of 3