Smittybilt 51036 User Manual

Installation Instructions

Bull Bar (#51035&51036)

PARTS LIST
(1) BULLBAR
(2) BRACKETS (DR.-PASS.)
(6) 7/16X1 ¼ HEX HEAD BOLTS
(6) 7/16 HEX NUTS
(12) 7/16 FLAT WASHERS
(2) 1/2X4 ¾ HEX HEAD BOLTS
(2) 1/2 HEX NUTS
(4) 1/2 FLAT WASHERS

PROCEDURE

1. REMOVE CONTENTS FROM BOX AND CHECK FOR DAMAGE. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.

2. REMOVE FRONT LICENCE PLATE AND LICENCE PLATE BRACKET. IT IS NOT REQUIRED BUT
STRONGLY RECOMMENDED. IF LOCAL/STATE LAW REQUIRES A LICENCE PLATE, LICENCE PLATE KIT
IS AVAILABLE.

3. DETERMINE PASSENGER AND DRIVER SIDE BRACKETS. REMOVE TOW HOOKS AND PLASTIC
RETAINER ( SEE FIG 1). INSERT BRACKET ONTO FRAME, USING 1-7/16X1 1/4 HEX BOLT 2-7/16 FLAT
WASHERS AND 1-7/16 HEX NUT. NOTE: 7/16 X 1 ¼ BOLT SHOULD BE FASTENED AT FAR END OF
BRACKET FIRST

4. INSERT 1-1/2X4 ¾ HEX BOLT 2-1/2 FLAT WASHERS AND ½ HEX NUT THROUGH FRONT PART OF
BRACKET (SEE FIG 2.). LEAVE LOOSE

5. ATTACH BULL BAR ON OUTSIDE OF BRACKETS USING 2-7/16 X 1 ¼ HEX BOLT 4-7/16 FLAT WASHERS
AND 2-7/16 HEX NUT ( SEE FIG. 3)

6. LEVEL AND ADJUST BULL BAR AS DESIRED. TIGHTEN AND TORQUE BOLTS.

2007 CHEVROLET TAHOE

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Page 1 of 3

½ X 4 ¾ HEX BOLT

7/16 X 1 ¼ HEX BOLT

Installation Instructions

Bull Bar (#51035&51036)

2007 CHEVROLET TAHOE

7/16 X 1 ¼” HEX BOLT

( BACK END HOLE)

Fig 1 (Passenger Side) Fig 2 (Driver Side)

Fig 3 ( Driver Side)

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Page 2 of 3