Smittybilt 233127 User Manual
INSTALLATION INSTRUCTIONS
07 TOYOTA TUNDRA (Double Cab & Crew Max)
PART NUMBER 233100 / 233107 233120 / 233127
SIDE BARS
PARTS LIST:
1 Passenger Side Bar 1 Rear Passenger Side Mounting Bracket
1 Driver Side Bar 1 Rear Driver Side Mounting Bracket
1 Front Passenger Side Mounting Bracket 12 8-1.25mm x 30mm Hex Head Bolts
1 Front Driver Side Mounting Bracket 12 8mm Flat Washers
1 Center Passenger Side Mounting Bracket 12 8mm Lock Washers
1 Center Driver Side Mounting Bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Locate the mounting location underneath the vehicle’s body. Remove these existing bolts from
vehicle and save these for later use. NOTE: There is only one Bolt by the front flare, two by the
center of the cabin and two by the rear flare. You would need to remove one bolt from a nonmounting location to use for the front mounting location.
3. Mount the Front Passenger Side Mounting Bracket with factory bolts removed in step 2
(Figure 2). Do not tighten at this time. Repeat this step for Passenger Center and Passenger
Rear Mounting Bracket. NOTE: Refer for Figure 1, 2, 3, and 4 for bracket configuration.
4. Locate the Passenger Side Bar and carefully place it on the previously installed Mounting
Brackets. WARNING! Do not slide Side Bar back and forth on the Mounting Brackets; this may
damage the finish on the Side Bar.
5. Align the holes on the Side Bar with the holes on the Mounting Brackets. Attach Side Bar to
Brackets with the included (6) 8-1.25mm x 30mm Hex Head Bolt, (6) 8mm Flat Washers, and
(6) 8mm Lock Washers (Figure 5). Do not tighten at this time.
6. Level and adjust Side Bar and Mounting Brackets. Tighten all hardware at this time now.
7. Repeat Steps 2-6 for Driver Side
INCLUDED COMPONENTS
Front
Front
Driver Side
Mounting Brackets
Center
Center
Passenger Side
Mounting Brackets
Rear
Figure 1
Rear
Page 1 of 2 1/11/07 (AM)
Front Passenger Side Mounting Bracket Center Passenger Side Mounting Bracket
Mounting holes
towards the
front of vehicle
Factory bolts
Fig 2 Fig 3
Factory Bolts
Rear Passenger Side
Mounting Bracket
Fig 4
8mm Bolts,
8mm Lock
Washers, &
8mm Washers
Fig 5
Page 2 of 2 1/11/07 (AM)
Loading...