assembly instructions
uxl open-front desks
ADDITIONAL TOOLS NEEDED:
*PHILLIPS SCREWDRIVER*
TOOLS, HARDWARE & COMPONENTS:
A.
uxl work surface (laminated top)
B.
open front bookbox frame
wood screws (fasten top to frame)
C.
M6 x 20mm nyloc bolts (fasten legs to frame)
D.
(2 per leg)
E.
uxl leg set
A. B.
C.
º check that all components are accounted for and undamaged before assembly.
º assemble product in a clean, dry area; if cleaning is necessary, use a mild cleaner and damp cloth.
º for larger units, a second person is recommended for assistance in the assembly process.
1. begin by placing the bookbox frame
upside down.
2. place the threaded holes of the first
uxl leg against the frame’s leg bracket.
3. using a phillips head screwdriver,
insert (x2) M6 x 20mm nyloc bolts
into each leg - tighten bolts.
6. follow steps 4-5 with remaining legs
on your desk until all are installed.
D.
AL
FL
SL
*legs with casters come with 13mm wrench for
securing casters (casters packed with legset).
FC
E.
AC
SC
TL
Form # 179946
7. place your assembled frame (bookbox
& leg set) onto the laminated work
surface - lining up the pre-drilled holes
with the holes in the bookbox frame.
8. insert included wood screws into
pre-drilled holes in the laminated top
& fasten with a phillips head screwdriver
or power drill (set to low torque setting)
8b. for UXL tables / desks with casters -
see page 2.
For assistance in assembling product, missing or damaged parts or to place
an order, please contact our customer service department @ 1-800-328-1061.
assembly instructions
uxl tables (caster installation)
UXL LEG SETS WITH CASTERS
A.
uxl leg set with casters
B.
uxl caster wrench (13mm)
C.
uxl leg set caster pack
AC
FC
*legs with casters come with 13mm wrench for
securing casters (casters packed with legset).
TL
SC
A. B.
C.
º check that all components are accounted for and undamaged before assembly.
º assemble product in a clean, dry area; if cleaning is necessary, use a mild cleaner and damp cloth.
º for larger units, a second person is recommended for assistance in the assembly process.
1. insert caster into threaded hole on
bottom of each leg - proceed to hand
tighten the nut.
2. with the nut hand-tight, use the
supplied 13mm wrench to fasten &
secure the caster in place.
Continue the same assembly process
with remaining uxl legs on your table
or desk(s).
3. flip your table right-side-up (with the
help of an assistant) and your table is
ready for use.
Form # 179946
For assistance in assembling product, missing or damaged parts or to place
an order, please contact our customer service department @ 1-800-328-1061.
Loading...