Smith's Heating First ECOVECTOR PH 1300, ECOVECTOR PH 1600 Installation & User Manual

ELECTRICAL: ALL ELECTRICAL INSTALLATIONS AND CONNECTIONS MUST COMPLY WITH THE IEE REGULATIONS.
CHECK THE VOLTAGE ON THE HEATER IS CORRECT FOR YOUR SUPPLY. IF IN DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.

Dear Installer,

The following items should be included in the carton:

 Product complete with cable
 Fixing screws (2)
 One pair flexible installation hoses.

In the event of items missing or visible damage please
contact us on 01245 324560. We would be most grateful if
you would leave this Installation & User Guide and the
Guarantee Registration Card with the owner of the property.

Thank you for your co-operation.

Steve Russell
Technical Services Manager

Warning:

This appliance is not intended for use by persons (including children) with reduced physical
knowledge, unless they have been given supervision or instruction concerning use of the appliance
by persons responsible for their safety. Children should be supervised to ensure that they do not
play with the appliance

If supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or similarly
qualified persons in order to avoid a hazard.

Products with this symbol (crossed out wheelie bin) cannot be disposed as household waste. Old electrical and
electronic equipment must be recycled at a facility capable of handling these products and their waste by-products. If you
are purchasing replacement equipment your retailer may offer a 'take back' scheme, or will be able to give details of the
nearest approved authorised treatment facility. Proper recycling and waste disposal will help conserve resources whilst
preventing detrimental effects on our health and the environment.

WEEE Registered Code : WEE/ED0093VW

Versatile, energy efficient heating

ECOVECTOR®

Plinth Heater

Models

PH 1300
PH 1600

INSTALLATION & USER GUIDE

8

Plinth Heater – PH1300 & PH1600

Note:
If required the front grille can be
removed to ease installation. To remove
the grille tilt the bottom of the grille
outwards and lift off grille, to refit carry
out reverse procedure.

(The grille can only be removed with the
screws holding the grille to the plinth
removed)

7

2