Smith's Heating First ECOVECTOR LL 1200, ECOVECTOR LL 2000, ECOVECTOR LL 2800 Installation & User Manual

IMPORTANT

The appliance is not to be used by children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction.

Children should not be permitted to play with the appliance.
Ensure that the fan is switched off from the supply mains before removing the

guard.
Any specifications with regards to dimensions of space required for the

appliance to operate effectively

Products with this symbol (crossed out wheelie bin) cannot be disposed as
household waste. Old electrical and electronic equipment must be recycled at a
facility capable of handling these products and their waste by-products. If you are
purchasing replacement equipment your retailer may offer a 'take back' scheme, or
will be able to give details of the nearest approved authorised treatment facility.
Proper recycling and waste disposal will help conserve resources whilst preventing
detrimental effects on our health and the environment.

WEEE Registered Code: WEE/ED0093VW

This Installation and User Guide is printed on 100% re-cycled paper.

Smith’s Environmental Products Ltd.

1-2 Blackall Industrial Estate, South Woodham Ferrers,

Chelmsford, Essex CM3 5UW

Tel: [phone], Fax: [phone], After Sales: 01245 324560

E-mail: [e-mail]

Web: www.smiths-env.com

04-1120 Jan 08

Versatile, energy efficient heating

ECOVECTOR™

Models

LL 1200, LL 2000 & LL 2800

PATENT PENDING

INSTALLATION & USER GUIDE

For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [e-mail] 0844 556 1818

INTRODUCTION

In the event of items missing or visible damage please contact us on 01245 324560.
This heating appliance is intended for mounting on a wall at low level. The minimum

recommended installation height is 150cm (6 inches) from the floor. There is no
clearance required on either side of the heater.

This heater must not be used in bathrooms or other high humidity areas.
Ecovector™ is designed for use on standard two-pipe pumped central heating

systems where the system hot water is generated from either a boiler or renewable
sources. This product is not suitable for one-pipe heating systems. Pipe connections
are 15mm.

We recommend the use of full flow isolating valves. These valves should be
accessible after completion of the installation.

Ecovector™ is classified as a fixed appliance and electrical connection should be via
a double pole 3A fused spur. The fused spur must not be directly above the heater
but should be accessible after completion of the installation. If the pre-wired mains
cable is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons. The appliance must be earthed.

To avoid possibility of vibration, this product must be installed on a flat, even surface.
To comply with Building Regulations Part L (Part J in Scotland) this heater is fitted

and controlled by an integral room thermostat

Please note the guarantee may be invalidated if this product is not installed
and used in accordance with this guide.

MOUNTING THE UNIT

Remove the EZ hanger from the back of the heater. Remove screws from the
underside of the front panel, carefully lift up and remove.

2

Ecovector™ includes a selectable low temperature thermostat that prevents the
fan(s) operating until the central heating system water passing through the heat
exchanger reaches a set temperature.

Heating

Ensure your central heating is ON, the heat output switch set to Low (I) and the
thermostat set to the required position (position 3 is approximately 20°C).

If you require a faster warm up set the heat output switch to High (II)

7

For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [e-mail] 0844 556 1818