Smith's Heating First Eco-Powerad 500, Eco-Powerad 1000, Eco-Powerad 1500, Eco-Powerad 2000 Installation & User Manual

IMPORTANT

- The appliance is not to be used by children or persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction

- Children should not be permitted to play with the appliance

- Ensure that the fan is switched off from the supply mains before

removing the guard

- If the supply cord is damaged., it must be replaced by the
manufacturer, its srvice agent or similarly qualified persons in order to
avoid hazard.

Products with this symbol (crossed out wheelie bin) cannot be disposed as
household waste. Old electrical and electronic equipment must be recycled at a
facility capable of handling these products and their waste by-products. If you are
purchasing replacement equipment your retailer may offer a 'take back' scheme, or
will be able to give details of the nearest approved authorised treatment facility.
Proper recycling and waste disposal will help conserve resources whilst preventing
detrimental effects on our health and the environment.

WEEE Registered Code: WEE/ED0093VW

This Installation and User Guide is printed on 100% re-cycled paper.

Smith’s Environmental Products Ltd.

1-2 Blackall Industrial Estate, South Woodham Ferrers,

Chelmsford, Essex CM3 5UW

Tel: [phone], Fax: [phone], After Sales: 01245 324560

E-mail: [e-mail] Web: www.smiths-env.com

For Ireland (Republic & Northern), contact MT Agencies on 00 353 1 864 3363

In light of our policy of continuous development Smith’s Environmental Products Ltd reserve

the right to alter specifications without prior notice.

04-1144 8 June 11

Versatile, energy efficient heating

Eco-Powerad

®

Models

500, 1000, 1500 & 2000

INSTALLATION & USER GUIDE

INTRODUCTION

In the event of items missing or visible damage please contact us on 01245

324560.
This heating appliance is intended for mounting on a wall at low level. The

minimum recommended installation height is 150cm (6 inches) from the floor.
There is no clearance required on either side of the heater. The maximum
installation height from the floor is 500mm.

This heater must not be used in bathrooms or other high humidity areas.
Eco-Powerad® units are designed for use on two-pipe pumped central

heating systems and are suitable for use on low temperature systems where
the hot water is generated from renewable sources. This product is not
suitable for one-pipe heating systems. Pipe connections are 15mm.

We recommend the use of 15mm compression thermostatic radiator valves
(TRV) and radiator lockshied valves for the pipe work connections.

Eco-Powerad® is classified as a fixed appliance and electrical connection
should be via a switchable double pole 3A fused spur situated no more than
1metre away from the appliance and which must be accessible after
completion of the installation. If the pre-wired mains cable is damaged, it
must be replaced by the manufacturer, its service agent or similarly qualified
persons. The appliance must be earthed.

To avoid possibility of vibration, this product must be installed on a flat, even
surface.

To comply with Building Regulations Part L (Part J in Scotland) this heater
should be fitted and controlled by a thermostatic radiator valve or zone
control thermostat.

Please note the guarantee may be invalidated if this product is not
installed and used in accordance with this guide.

MOUNTING THE UNIT

Remove both the EZ Hanger and the lower mounting bracket from the back of the
heater.

2

7