Smeg SA950CXA User Manual

Cleaning & Maintenance

Warning: Before cleaning, please ensure that the power is
switched off by detaching the plug from the wall socket.

SA950CXA

10.1 Clean the surface of hood every week with mild soap
or detergent . Avoid solvents, acid, alkali, scouring pads
or powders that could irreparably damage the stainless
steel surface.

10.2 The grease filters may be washed using mild soap,
detergent or degreasing agent.

10.3 Charcoal filters cannot be cleaned and must be
generally replaced after 6 months of use.

10.4 There is a fire risk if cleaning is not carried out in
accordance with the instructions

RANGE HOOD
INSTRUCTION

Thank you for your purchase of this product. Please read
the manual carefully before operating the appliance.

Installation Diagram

Electrical Diagram

SA950CXA

Specifications

SA950CXA

Power Supply AC 220-240V, 50Hz
Rated Input Power 142W
Lighting Power 2W×2

Motor Power 138W
Outlet Diameter 150mm

Troubleshooting

Contents

If any problem occurs, please detach the plug from the
socket and contact the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.

Problem Cause Solution

Light on, but motor
does not work

Light does not
work, motor does
not work

Vibration The propeller is damaged or

Insufficient suction
effect

The outlet valve is blocked Detach flue and duct then turn

on the hood to check if the
valve opens

The capacitor has failed

The control switch has
failed

No power supply Plug another appliance into the

Fuse has blown Check the fuse or reset the

unbalanced
The hood is not installed

correctly

The distance between the
hood and the cooker is too
far

Call for technical service

Call for technical service

socket to confirm there is
power supply

circuit breaker
Call for technical service

Review the installation
instructions & check the
installation again for loose
screws, brackets or connections

Check that the distance is
between 650mm to 750mm for
a gas appliance and 600mm for
electric hobs

Introduction………………………….1
Features……………………………...2

Installation………………………......2

Charcoal filter (optional)………....4

How To Use………………………….5

Safety Information………………....6

Troubleshooting………………..…..7
Electrical Diagram…………………8
Specifications……………………….8
Cleaning & Maintenance………….9

The filters are saturated Clean the filters from grease

residue and replace after
drying.

Introduction

Safety Information

1.1 This appliance has been manufactured with materials
and processes that respect the environment. We hope that
you will continue this important consideration in the
operation of this appliance & the disposal of the packaging
materials, thank you.

1.2 The installation work must be undertaken by a qualified
technician experienced in cooker hood installation. Please
connect the correct power rating.

1.3 The manufacturer disclaims all liability for any damage
or injury caused as a result of not following the instructions
for installation contained in the following text.

1.4 The appliance is not intended for use by persons
(including children) with reduced physical, sensory mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.

1.5 Children should be supervised to ensure that they do
not play with the appliance.

1.6 The maximum number of hobs covered by range hood
should not exceed 4.

1.7 Any modifications to the appliance, electric wire and
plug is dangerous & voids the warranty.

1.8 If the supply cord is damaged, it must be replaced by the
manufacture, its service agent or similarly qualified persons
in order to avoid a hazard.

◆ There shall be adequate ventilation of the room when the

range hood is used at the same time as appliances burning
gas or other fuels .

◆ Do not check the status of the filters when the range hood

is operating, wait at least 30 minutes after switching off to
avoid scalding.

◆ Do not touch the light within 30 minutes after appliance

use.

◆ Avoid operating a gas cooker when there is no pan on the

stove. It is a fire hazard and may cause damage to the
hood filters.

◆ Disconnect the electrical plug prior to any maintenance.

◆ CAUTION: Accessible parts may become hot when used

with cooking appliances.

◆ Do not flambé under the range hood.

◆ The range hood is for home use only and is not suitable

for outdoor, barbecue, and other commercial applications.

◆ The range hood and its filter should be cleaned regularly

for best performance. Excessive grease will impede
airflow and may cause the motor to overheat.

◆ Before cleaning, please confirm that the power is

switched off.

◆ Building regulations concerning the discharge of exhaust

air have to be fulfilled.

◆ Don’t cook with an open flame under the range hood.

◆ For any technical issues ensure that a suitably qualified

person effects any repairs or inspection.

How To Use

Features

3 Speed

3 Speed

◆ Push the Low button, and the motor runs at low speed.

◆ Push the Mid button, and the motor runs at mid speed.

◆ Push the High button, and the motor runs at high speed.

◆ Push the Light button, and the two lighting lamps

◆ On any speed, push “T” & the delay timer will switch

adjustment

adjustment ((

adjustment

illuminate. Push it again and the lamp will turn off.

off the hood after 5 minutes. Push it again and the
motor will turn off.

see

see

see

pic 6

pic 6).

pic 6).

2.1 This appliance is manufactured from top quality materials,
and offers superb streamlined effects.

2.2 With high suction power and low noise, it is designed to
remove cooking fumes from your kitchen quietly & effectively.

Installation

3.1 The range hood should be mounted at a distance of
650mm above the highest part of the highest burner of a gas
cooking appliance or 750mm from a COMBUSTIBLE surface
directly above the gas appliance. The range hood can be
mounted 600mm above an electric cooking surface. (see pic 1a
and 1b). The air must not be discharged into a flue that is used
for exhausting fumes from appliances burning gas or other
fuels (not applicable to appliances that only discharge the air
back into the room).

3.2 To install, drill 3 holes of Φ8mm on a sturdy wall and in
line with the hood.

3.3 Insert expending screws into the holes. Then fasten the

hood by the outside of the 2 screws. Finally, fix the middle of
the hole of the hood (see pic 2).

3.4 Fix drilling template on the wall.

3.5 Attach the 150mm duct (not supplied) to the one way valve,

and connect it to the kitchen outlet vent (see pic 3). Do not
screw the duct to the flange, as this may prevent the one way
valve from opening. Use a suitable clamp

3.6 Mount the bracket (alternative part) to make sure it’s firmed

(see pic4)

3.7 Ensure that the wall to be installed on is sufficiently
sturdy to carry the weight of the hood. It should be mounted
level for best performance (see illustration).

3.8 Do not connect to a
common vent with other
appliance such as gas
heater, water heater,
laundry dryer etc.

3.9 The duct should not be
bent more than ≥120º from
the one way valve outlet to
the kitchen vent.

3.10 Check to make
sure that the electric
cord is not in contact
with sharp edges of
the appliance.

3.11 Be sure that the
plug is accessible
after installation.

pic 1a (gas
product)

Pic 2

pic4 pic5

pic 1b
(electric
product)

Pic 3

Charcoal filter (optional)

The hood can install the charcoal filter which can make your
kitchen cleaner.

Step1. Remove this label if installing
charcoal filter.

Step2. Buckle the filter on the air cabinet
and push it up.

Step3. Press the catch and push it into the
hole.

Step4. Put on the aluminium filter.

Warning: Failure to install the screws or fixing device in
accordance with these instruction may result in electrical
hazards.

Right

Wrong