Smeg SA711XA User Manual
smeg 70cm highlight ceramic cooktop, touch control
size 700mmW x 520mmD x 55mmH
cutout 660mmW x 490mmD
finish black ceramic frameless surface
edge bevelled ceramic
zones four plus two expansion zones
controls touch
heat levels nine per zone
timer 1–99 minutes programmable
cooking times, simultaneous and
variable times, audible signal
residual heat hot surface ‘H’ LED warning
elements all high-speed series 8 ribbon
elements, full heat 7 seconds
warranty in-house, two years parts and
labour
kitchen timer INDEPENDENT 1-99 minute timer
with audible signal
PLEASE NOTE: smeg ceramic cooktops are highly-efficient
cooking surfaces. They are at their most efficient with flatbased cooking vessels. We recommend stainless steel exterior
based vessels — that is, the surface be of stainless steel. This
flat stainless steel surface will help preserve the unblemished
look of the ceramic surface and help avoid scratching and
permanent marking. High-quality cast-iron surfaces may also
be suitable.
“GO AND STOP”
For improved energy and time efficiencies, when a heat setting is
selected for a particular zone, full power is applied for a very brief initial
phase before it returns to the preselected heat level. This pre-emptive
heat aid is referred to as ‘go and stop’ in the cooktop’s accompanying
instruction booklet.
AUTOMATIC STOP
Each zone can be preset with an individual cooking duration (up
to 99 minutes). This timed cooking can be selected for respective
different times on different zones — that is, all zones can be operated
simultaneously and at different time settings. When the individual zone’s
timed cooking duration elapses, the controls will flash ‘00’ and an
audible signal will emit.
KITCHEN TIMER
The cooktop’s controls can also be used as an independent, variable
countdown timer with audible end signal. Range is one through 99
minutes.
THERMAL OVERLOAD PROTECTION
For safety, the cooktop will default to ‘OFF’ in any extreme conditions,
such as a continuous overflow of boiling fluids or a utensil cooking its
contents dry. Cooking can only be resumed after the fault has been
cleared from the electronic LED safeguards. Also for safety reasons,
cooking cannot resume automatically — it must be manually restarted.
WARNING: technical specifications and product sizes can be varied by the manufacturer,
without notice. Cutouts for appliances should only be by physical product measurements.
The above information is indicative only.
ID180609
Code SA711XA
smeg 70cm highlight ceramic cooktop, touch control
630
700
<
<
45
<
<
55
hard wiring
terminal
FRONT ELEVATION
A
A
B
C
700
520
PLAN
460
520
SIDE ELEVATION
483
hard-wiring terminal
>
>
4.36
7
>
>
bevelled edge
detail
2.6
A 155mm diameter zone: 1200 watts
B 125mm diameter inner zone: 700 watts
190mm diameter expansion zone: 1700 watts total
C 140mm diameter inner zone: 1000 watts
220mm diameter expansion zone: 2200 watts total
6300 watts total, 27 amps hard wired
CUTOUT: 660mmW x 490mmD
packaged dimensions 840mm x 605mm x 80mm = 0.041 cubic metres
WARNING: technical specifications and product sizes can be varied by the manufacturer,
without notice. Cutouts for appliances should only be by physical product measurements.
The above information is indicative only.
NB: THESE DRAWINGS ARE NOT TO SCALE — THEY ARE TO ASSIST ONLY.
gross weight 11.7kg
net weight 10.7kg
ID141009
Code SA711XA
Loading...