Smeg MTK70X34 User Manual
MTK70X34
SMEG TRIMKIT TO SUIT SA34MX, SAM34XI SAM34CXI
MICROWAVES
Trimkit to suit:
SA34MX, SAM34XI, SAM34CXI
545
426
303
697 (70cm)
21
cupboard or void
MICROWAVE
OVEN SPACE *
700 internal width
oven, cupboard,
drawers or void
100min 100min
cupboard or
vents
●
●
MICROWAVE
OVEN SPACE
515**
426±1600
oven
void
426±1
22
FRONT
cupboard,
drawers or void
FRONT ELEVATION
cupboard,
drawers or void
SIDE ELEVATION
PLEASE NOTE: The internal width of the microwave oven/convection microwave oven cabinet must be
70cm wide for the 70cm-wide trimkit
PLEASE NOTE: drawings are not to scale. They are to assist only.
WARNING: technical specications and product sizes can be varied by the manufacturer without notice.
Cutouts for appliances should only be by physical product measurements. The above information is indicative only.
ID170828
smeg.com.au
MICROWAVES
MTK70X34
SMEG TRIMKIT TO SUIT SA34MX, SAM34XI SAM34CXI
Underbench
Microwave oven, convection microwave, oven underbench mounting with trimkit
Microwave ovens and convection microwave ovens are venting cooking appliances. They must be able to
‘breathe’, otherwise their purpose, performance and longevity are compromised.
A wall-mounted microwave unit, with an accompanying trimkit, can vent to the front via designed gaps in the
trimkit but most of the venting is actually done through the venting channel created at the rear of the kitchen
cabinet.
A freestanding microwave oven, that is, sitting on an open kitchen bench or an open raised shelf, is perfectly able
to vent and cool itself in this unrestrictive space.
An underbench-mounted microwave oven, particularly one installed with a trimkit, also needs to be able to
exchange air in its immediate vicinity and cool itself. Since rear upward venting is impossible as the enclosed
kitchen bench prohibits such venting, the air from at least one adjacent cabinet plus the air below the platform on
which the microwave oven sits must be accessed. Simply ensure long, open slots or multiple round holes access
the adjacent cabinetry through the rear side walls and oor of the microwave oven space. This venting will
alleviate the possible sweating and overheating of the microwave oven. The more access to air the microwave
unit has, the better its performance and the less damage to cabinetry due to heat and moisture.
air circulation
426±1
The depth, that is, front to back measurement of the
two vertical and the oor slots, should be as large as
practicable,
100mm minimum depth x 300mm minimum length
700
PLEASE NOTE: drawings are not to scale. They are to assist only.
WARNING: technical specications and product sizes can be varied by the manufacturer without notice.
Cutouts for appliances should only be by physical product measurements. The above information is indicative only.
smeg.com.au
ID170828
Loading...