Smeg LSA649WSA User manual

INSTRUCTION MANUAL

GGUUIIDDEE FFOORR UUSSIINNGG TTHHEE DDIISSHHWWAASSHHEERR AANNDD TTHHEE WWAASSHHIINNGG PPRROOGGRRAAMMSS

Contents

1. Description of the controls ________________________________ 2

2. Operating instructions ___________________________________ 15

3. Cleaning and maintenance _______________________________ 30

4. Troubleshooting _______________________________________ 34

Thank you for choosing one of our products. You are advised to read this manual carefully; it contains all the information you need to use your dishwasher safely, correctly and in the most satisfactory manner. Following the cleaning instructions provided here will keep your dishwasher's performance at peak levels in the long term.

USER INSTRUCTIONS: these consist of recommendations for using the appliance, a description of its controls and of the correct cleaning and maintenance procedures.

1

1. Description of the controls

User instructions

1.1 Front panel

The ON/OFF is on the top edge of the panel, and all the dishwasher’s other controls and monitoring devices are on the central display. Programming and option selection are only possible with the door

closed.

NOTA:

The displays illustrated in the instruction manual are purely guideline; symbols, programs and options may vary depending on the model purchased.

2

User instructions

VERSION WITHOUT OPTIONS

1 ON/OFF BUTTON 2 SELECTION PROGRAMS BUTTON 3 START/PAUSE BUTTON 4 PROGRAMS LIGHTS 5 PHASES/PROGRAM LIGHTS

WATER HARDNESS ADJUSTMENT ON INDICATOR LIGHT

The light flashes to indicate that the appliance is in “water hardness adjustment” mode.

6

SALT WARNIN LIGHT

Illumination of this light denotes a regenerating salt warning level.

7 NO RINSE AID LIGHT

3

User instructions

VERSION WITH OPTIONS

1 ON/OFF BUTTON 2 SELECTION PROGRAMS BUTTON 3 START/PAUSE BUTTON 4 PROGRAMS LIGHTS 5 PHASES/PROGRAM LIGHTS +

PROGRAM DELAY (if the option is included) WATER HARDNESS ADJUSTMENT ON INDICATOR LIGHT

The light flashes to indicate that the appliance is in “water hardness adjustment” mode.

6

SALT WARNIN LIGHT

Illumination of this light denotes a regenerating salt warning level.

7 NO RINSE AID LIGHT 8 OPTIONS (on some models only)

4

User instructions

PROGRAMS TABLE

Depending on the model, this zone may contain one or more of the following options, identified by the relative symbols and described in more detail in the relevant sections of the manual. It is not possible to select any options when the soak program is being used. All options except "Flexi Tabs" are disabled at the end of the wash cycle. To disable the “Flexi Tabs” option, press the relative button (the light goes out).

Flexi Tabs

Specifically for the use of products which contain salt and rinse aid as well as detergent.

HYCLEAN

Adds a final antibacterial rinse to the selected program.

Spread HALF LOAD WASH

Allows washing of just a few dishes placed in both baskets.

PROGRAM DELAY

Allows the program to be set to start with a delay of 3, 6, 9 or 12 hours.

The manual contains the programs table for several models. To find the table for your dishwasher, compare the program symbols at the top of the table with those on your control panel.

<<OPTIONS (8)>>

5

PROGRAMS TABLE

5

ULTRA CLEAN

User instructions

PROGRAMME

NUMBER

& SYMBOL

1 SOAK

2 RAPID

3 ECO (*)

EN 50242

4 NORMAL

IEC/DIN***

ULTRA

CLEAN

****

The

LOAD CROCKERY AND

CUTLERY

Pans and dishes awaiting

completion of the load

Dishes with light dirt,

washed immediately after

Dishes with normal dirt,

even with dried-on

residues

Dishes with normal dirt,

even with dried-on

residues

Very dirty pans and

dishes, even with dried-on

residues.

program terminate with an extra anti-bacteria rinse that ensures

use

PROGRAM

PROGRESS

Cold prewash

Wash at 38°C Rinse at 50°C

Wash at 50°C Cold rinse Rinse at 65°C Dry

Cold prewash Wash at 65°C Cold rinse Rinse at 70°C Dry

Hot prewash Wash at 70°C Cold rinse (2) Rinse at 70°C Dry

DURATION

MINUTES

(1)

CONSUMPTION

WATER LITRES

15 3,5 0,02

27

6,5 0,70

**

** **

105

13,5 1,35

155

15,5 1,60

POWER KWh (1)

a further reduction in the bacteria level. If the temperature falls during this stage of the program (e.g. because the door is opened or due to a power blackout), the program lights (4) flash to warn that the anti-bacteria effect is not guaranteed.

IMPORTANT: see “NOTES AND REFERENCES” table on the following pages.

If the dishwasher door is open or not properly closed, the washing cycle will not start.

6

User instructions

PROGRAMS TABLE

5

ULTRA CLEAN

PROGRAMME

NUMBER

& SYMBOL

1 SOAK

2 RAPID

3 ECO (*)

EN 50242

4 HALF LOAD

ULTRA

CLEAN

****

The

LOAD CROCKERY AND

CUTLERY

Pans and dishes awaiting

completion of the load

Dishes with light dirt,

washed immediately after

Dishes with normal dirt,

even with dried-on

residues

Half load of dishes with

normal dirt, washed

immediately after use.

Very dirty pans and

dishes, even with dried-on

residues.

program terminate with an extra anti-bacteria rinse that ensures

use

PROGRAM

PROGRESS

Cold prewash

Wash at 38°C Rinse at 50°C

Wash at 50°C Cold rinse Rinse at 65°C Dry

Wash at 65°C Cold rinse Rinse at 70°C Dry

Hot prewash Wash at 70°C Cold rinse (2) Rinse at 70°C Dry

DURATION

MINUTES

(1)

CONSUMPTION

WATER LITRES

15 3,5 0,02

27

6,5 0,70

**

** **

90

11 1,20

155

15,5 1,60

POWER KWh (1)

a further reduction in the bacteria level. If the temperature falls during this stage of the program (e.g. because the door is opened or due to a power blackout), the program lights (4) flash to warn that the anti-bacteria effect is not guaranteed.

IMPORTANT: see “NOTES AND REFERENCES” table on the following pages.

If the dishwasher door is open or not properly closed, the washing cycle will not start.

7

PROGRAMS TABLE

User instructions

DURATION

PROGRAMME

NUMBER

& SYMBOL

1 SOAK

2 RAPID

3 ECO (*)

EN 50242

4 HALF LOAD

5 SUPER

****

IMPORTANT: see “NOTES AND REFERENCES” table on the following pages.

LOAD CROCKERY AND

CUTLERY

Pans and dishes awaiting

completion of the load

Dishes with light dirt,

washed immediately after

Dishes with normal dirt,

even with dried-on

residues

Half load of dishes with

normal dirt, washed

immediately after use.

Very dirty pans and

dishes, even with dried-on

residues.

use

PROGRAM

PROGRESS

Cold prewash

Wash at 38°C Rinse at 50°C

Wash at 50°C Cold rinse Rinse at 65°C Dry

Wash at 65°C Cold rinse Rinse at 70°C Dry

Hot prewash Wash at 70°C Cold rinse (2) Rinse at 70°C Dry

MINUTES

WATER

(1)

LITRES

15 3,5 0,02

27

**

90

155

If the dishwasher door is open or not properly closed, the washing cycle will not start.

CONSUMPTION

6,5 0,70

** **

11 1,20

15,5 1,60

8

POWER KWh (1)

User instructions

NOTES AND

REFERENCES

Only

EN 50242

IEC/DIN

20g

dispenser

10g

run the soak program with half loads.

Options cannot be used with the soak program.

Standard programme under

*

.

** See information sheet provided

***

Reference program for laboratories: Detergent:

****

reference programme.

in the

+

the door or tablet. Configuration: see photo in “Using the baskets”.

(1) Program consumption and duration figures have been measured in

accordance with the EN 50242 standard. Values may vary depending on intake water and room temperatures and the type and quantity of dishes loaded.

(2) 1 or 2 cold rinses depending on the model.

REFERENCES for the ENERGY LABEL supplied with the dishwasher:

- Annual energy consumption is based on 280 standard wash cycles with cold water and consumption of low-energy operating modes. Actual consumption depends on the way in which the appliance is used.

- Water consumption is based on 280 standard wash cycles. Actual consumption depends on the way in which the appliance is used.

- Information refers to the EN 50242 STANDARD programme (identified in the programmes table), which is the most effective in terms of combined energy and water consumption. The programme is recommended for dishes with a normal level of dirt.

- Drying efficiency class on a scale from “G” (minimum efficiency) to “A” (maximum efficiency).

in

9

SWITCHING ON

PROGRAMMING

PROGRAM SELECTION

(2)

User instructions

1.2 Washing programs

The dishwasher is equipped with a control panel, described in chapter

"3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations.

Before starting a washing program make sure that:

• The water supply tap is open.

• The correct amount of detergent has been added to the

dispenser.

• The baskets have been correctly loaded.

• The spray arms are able to rotate freely and without

obstruction.

• The dishwasher door is securely closed.

10

When the ON/OFF button (1) is pressed, the dishwasher switches on.

Programming operations are only possible with the door closed.

Press the

button

several times until the light

of the program required comes on.

Smeg LSA649WSA User manual [GB]