Smeg LB4 User manual [GB]

-EN- LB4/DS -

LB4/DS - INSTRUCTIONS FOR ASSSEMBLY AND USE

Read the safety warnings and instructions for the thermodisinfectors in which the rack is used
withcare, together with the safety instructions of the producer of the glassware and any other item placed on

the rack. Badly positioned items or glass which shatters during washing may cause dangerous injuries. If
necessary, washing results must be checked and subjected to non-visual inspections.

1 LIST OF COMPONENTS SUPPLIED.

Qt.y

1

1

PART

NUMBER

TC40

TC40DS

DESCRIPTION

LM40 central pipe
(version without DS
only)
LM40DS central pipe
(for DS version only)

Qt.y

4

NOZZLE

ULBT4

PART

NUMBER

ULBT4

DESCRIPTION

stainless steel nozzle

19390344700_LB4-EN

1

Ed. 01 - 03/01/2012

-EN- LB4/DS -

2 BLOW-UP DIAGRAM

1

1

1

1

POSITION DESCRIPTION

1

ULBT4

19390344700_LB4-EN

2

Ed. 01 - 03/01/2012

-EN- LB4/DS -

3 ASSEMBLY SEQUENCE

This rack is supplied preassembled; therefore, only a few simple procedures are required prior to use.

ILLUSTRATION PROCEDURE

Fig.1

Fig. 2

Insert the central pipe into place and tighten
the ring-nut to fix all parts.

If your product is equipped with the DS device,
the pack contains pipe B (TC40DS) instead of
the ordinary pipe A(TC40)), in which case the
pipe B must be fitted as shown in figure 3, i.e.
with the pipe projecting towards the rear of the
rack, so that once it is inside the disinfector it
will be aligned with the connection (illustration
below).

Fig.3

Fig. 4

19390344700_LB4-EN

When inserting the rack in the disinfector, the
greatest care must be taken to ensure that the
tapered connection on the rack is aligned with
the one on the machine.

3

Ed. 01 - 03/01/2012

-EN- LB4/DS -

4 USE AND PRECAUTIONS

PROCEDURE PROCEDURE

Take care not to place pieces of glassware

touching each other.

Ensure that no glassware or any other item

for washing projects above the water intake.

Via Leonardo da Vinci, 4 – 42016 Guastalla (RE) Italy

Tel. [phone] - Fax + 0522 821 592

[e-mail] – www.smeg-instruments.com

E-Mail:

Smeg S.p.A.

Instruments Division

Glass must not rest on the nozzle; it must
stand on the base support, allowing the
water to come out of the nozzle freely.
Move the spring underneath the support to
prevent it from descending.

Ensure that no item for washing projects from
the rack after loading.

19390344700_LB4-EN

4

Ed. 01 - 03/01/2012