Smeg KTS75, KTS75AC-1, KTS75BC, KTS75C, KTS75NC User Manual

Libretto d’istruzioni
Instruction manual
Mode d’emploi
Gebrauchsanweisung Manual de instrucciones Instruções de instala ção
Bruksanvisning
KTS75/KTS75C
Fig.1
Installation of glass panels
Take the two 200x750 hood glass panels out of the box.
Remove them from the box with care.
Open the hood upper glass panel (Fig.1).
Take the glass panel with the SMEG logo close to the hood and centre the four hinges in their seats (Fig.2).
Fig.4
Get the glass panel with no logo and place it near the hood 2, centre the four pins in the remaining four hood seats (Fig.4).
(2) For proper positioning, check the position of the metal frame on the back (Fig.4.1).
Fig.4.1 – Rear view.
EN
Fig.2
Fig.3
Let the glass panel slide downwards along the pin guides (Fig.3.2).
Fig.3.1 - Initial position (Pins high)
Fig.3.2 - Final position
01
Let the glass panel slide along the pin guides (Fig.5 and Fig.3.2)
Fig.5
Glass removal
To remove the glass panels, follow the procedure in the reverse order.
EN
02
Removal of filter panels
To remove the filters, use the key included in the supply (Fig.5).
Turn the key downwards and pull (Fig.8).
Fig.8
Fig.5
Fig.6
Place the key as shown in Fig.6.
Insert the key prongs in the holes on the upper central part of the panel (Fig.7) .
Fig.9
NB.: To remove the upper panel pair, remove the glass panels as described on page 2 .
Pull the panels up to remove them (Fig.9).
Fig.7
EN
03
EN
04
Fig.10
Fig.11
Installation of the filter panels
Take the panels close to the hood.
Insert the filter pins in the seats as shown in Fig.10
Rotate the panels and take them close to the hood (Fig.11 and Fig,12).
Adjustment of glass-closed position
Fig.13
Adjust the glass closed position after installing the hood.
Adjust the closing position of the glass by loosening/tightening the adjustment screws.
Adjust the LH and RH sides.
Use a size-3 Allen key for the adjustment (Fig.13).
Fig.12
EN
05
EN
06
Installation instructions
Height of the holes for the bracket
Level of the
EN
Fig.14 Fig.15
a) Fix the hood in the center over the hob; b) Maintain the distances shown at fig. 14 and fig. 15.
Reference height for the center of the exhaust hole
07
Loading...