Smeg GW7010M MISCELLANEOUS INSTRUCTIONS

19510091202 Fogl.IT-EN DIS.6010 - 20160527

Smeg S.p.A. - Instruments Division - [e-mail]

WD6010 – GW6010

GETTING STARTED – REFER TO THE INSTRUCTION MANUAL FOR COMPLETENESS

When moving the appliance around, a forklift truck must be used.

Before leaving the factory, the base of the appliance is secured to a pallet, which is used for lifting and transporting it.

Do not use appliances which have been damaged in transit!

Open the lower metallic panels (both the loading side and the unloading side) to have access to the fixing screws.

The fixing screws to the pallet, both on the loading side ("unclean side") that on the unloading side ("clean side"),
must be unscrewed in order to remove the machine from the pallet.

PACKAGE REMOVAL AND PREPARATION FOR MOVEMENT

Procedure to follow to remove the package, referring to the following images:

A.1 – Remove the package.
A.2 – Check that all lower panels are not installed.
A.3 – Remove the front wooden Stop.
A.4 – Remove the machine fastening Screws from the pallet (one in the front area and another one in the back area)

A.1

A.2

A.3

A.4

19510091202 Fogl.IT-EN DIS.6010

Smeg S.p.A. - Instruments Division - [e-mail]

REMOVAL FROM PALLET

Procedure to follow to get the machine off the pallet – using the forklift truck with adjustable forks:

B.1 – With wrench Ch17 keep the foot blocked, with wrench Ch7 unscrew the four feet until the maximum extension;
B.2.1 - B.2.2 – Frontal Machine unload: insert the forks of the forklift truck frontally paying attention to the correct support of the

feet (forks width about 520mm);
B.3.1 – As an alternative, lateral machine unload: insert the forks of the forklift truck from the side, paying attention to remain
under the lateral plate (forks width about 430mm);

B.1 – specific view: foot extension.

B.2.1 – unload from the frontal side.

B.2.2 – specific frontal view forks and feet

B.3.1 – side unload

Procedure to follow to get the machine off the pallet – using the tail lift:

C.1 – Approach with the tail lift to the pallet and the machine, make the machine slide on the platform, then, carefully, place the
machine on the floor;
C.2 – The machine is now standing on the wheels and can be positioned (short paths).

C.1 – use of the tail lift to get the machine off
the pallet

C.2 - machine on wheels, for little relocations