Smeg GW3060, GW4090 DATASHEET
Fogl.IT-EN GW3060-GW4090
Smeg S.p.A. - Instruments Division - instruments@smeg.it
Brief instruction sheet for basic procedures.
For all details relating to correct, safe use of the appliances concerned, the updated table of programs, interpretation of alarm
messages and installation instructions, please refer to the full version of the operator’s manual and program table.
First step
Power up the device by turning the master switch from “0” to “I”.
For models with side cabinet, the switch is accessible by opening the cabinet door.
The latest program selected appears on the display after the manufacturer’s logo.
Press “ESC” to change the preselected program.
Press “UP” (or “DOWN”) to choose the program required.
Press “ENTER” to select the program required.
Press “START” to start the selected program.
“RESET” button: starts the RESET cycle to return the device to its initial status.
The reset cycle should be used when alarms appear on the display.
Press “STOP” to halt a program. Depending from the program ad from the series of the product, not in all the
situations the door cannot be opened. In these cases, two possibilities:
- If the “START” button is pressed within 60 seconds: the cycle is restarted.
- If the “RESET” button is pressed: the reset cycle is performed.
Press “ENTER” to activate opening of the door. Do not force the door open by hand; a safety device is fitted.
The display and the buzzer alert the user to any alarms. When an alarm occurs, the device will attempt to deal with
the problem itself. When an alarm occurs, the user may: start a RESET cycle. If an alarm persists, contact the aftersales service.
There is no need to start a RESET cycle in the event of an alert such as “No salt” or “Lack of detergent”; respond as
necessary to enable the device to function correctly.
1 Prewash
11 Thermal disinfection 93°C – 10’ [ + Drying ]
2 Plastics 75°C - 3’ [ + Drying ]
12 Intensive thermal disinfection 93°C - 5’ [ + Drying ]
3 Fast Glassware 75°C - 3’ [ + Drying ]
13 Intensive thermal disinfection 93°C – 10’ [ + Drying ]
4 Medium Glassware 75°C - 5’ [ + Drying ]
14 Petroleum Dirt 93°C - 1’ [ + Drying ]
5 Standard Glassware 80°C - 5’ [ + Drying ]
15 Petroleum Dirt, Intensive 93°C - 5’ [ + Drying ]
6 Intensive Glassware 90°C - 3’ [ + Drying ]
16 Petroleum Grease 93°C - 1’ [ + Drying ]
7 Glassware 93°C - 3’ [ + Drying ]
17 Mineral Oil 93°C – 10’ [ + Drying ]
8 Agar Glassware 93°C - 3’ [ + Drying ]
18 Petrol 93°C - 5’ [ + Drying ]
9 Intensive Agar 93°C - 5’ [ + Drying ]
19 Diesel 93°C - 1’ [ + Drying ]
10 Thermal disinfection 93°C - 3’ [ + Drying ]
20 Universal Petrol 93°C – 10’ [ + Drying ]
SMEG GW3060 - GW4090
- LABORATORY GLASSWARE WASHER -
1 INSTRUCTION SHEET
THIS DOCUMENT
SELECTING AND STARTING A WASHING PROGRAM
RESET CYCLE
STOPPING THE PROGRAM
OPENING THE DOOR
ALARMS
2 LABORATORY PROGRAMS
[ + Drying ]: end-of-cycle drying phase, on models with Drying System only.
Loading...