Smeg GW1160C6, GW1160C1, GW4190SC1 User Manual

19510076802 Fogl.IT-EN GW1160-4060-4190

Smeg S.p.A. - Instruments Division - [e-mail]

GW1160 – GW4060 – GW4190

INSTRUCTION SHEET

SELECTING THE WASHING PROGRAMME

(GW4190 series only: give power supply by turning the main switch from position "0" to "I". The switch is located in
the

side cabinet).

Switch

on the device by pressing the On/Off key (hold down for 2 seconds).

Close the door by shutting it against the

appliance until the lock clicks shut. The buttons are only enabled with the door closed.

Use the

Selection buttons to select the program.

Pr

ess the Start/Stop button to start the cycle (hold it down for 2 seconds).

Once the selected program has been

successfully completed, the display shows “End”.

INTERRUPTING THE CYCLE

A cycle in progress can be interrupted by pressing the Start/Stop button. After the cycle has been interrupted, the
options available vary depending on conditions in the chamber:

1. If the temperature in the chamber is below 40°C: the door can be opened. If the door is closed again within 1

minute, the cycle can be restarted from the phase where it was interrupted,

by holding down the Start/Stop

button.

2. If the temperature in the chamber is above 40°C: a RESET cycle is required since the door cannot be opened.

DOOR OPENING

Press the

Door opening button: the appliance gives a

beep

when it receives the signal. Release the button and the

door will open automatically after a few moments.

RESET PROCEDURE

+

Press the Functions and Start/Stop buttons and hold them down for about 2 seconds, until a beep is heard.
"P

-" appears on the display and the RESET procedure starts.

ALARMS

LED

MEANING

When an alarm occurs: Led “Warning” on and display indication.

“

AF” – fatal alarm.

“

A-“ – non fatal alarm. If a non-fatal alarm occurs you can press the Start/Stop button to continue using the device.

When an error occurs, generally the device manages the anomaly itself: in this case the alarm code flashes on the
display until the problem has

been dealt with: no reset commands are accepted during this time.

Any RESET forced by the user will not be accepted until the problem has been dealt with and the alarm code on the

display is “steady”.

PROGRAMS

1 Prewash

9 Thermodisinfection 93°C 10’ (Grasso petrolio + Drying)

2 Plastics 75°C - 3’ + Drying

10 Custom (Petrol grease + Drying)

3 Standard Glassware 80°C - 5’+ Drying

11 Custom (Mineral Oil + Drying)

4 Intensive Glassware 90°C - 3’+ Drying

12 Custom (Petrol + Drying)

5 Intensive Agar 93°C - 5’+ Drying

13 Custom (Diesel + Drying)

6 Thermodisinfection 93°C - 3’+ Drying

14 Custom (Universal Petrol + Drying)

7 Thermodisinfection 93°C - 10’+ Drying

15 Custom (Autodisinfection 93°C – 1’)

8 Thermodisinfection 93°C - 5’ with prewash + Drying

16 Service

THIS DOCUMENT

Instruction sheet for basic operations.
For all the details

concerning the correct and safe use of the devices in question, for the updated program table, for the

interpretation of alarm messages and for the requirements for installation: Refer to the user manual - full version.