Smeg GW0160 INSTRUCTION SHEET

GW0160

INSTRUCTION SHEET

SELECTING THE WASHING PROGRAMME

Switch on the device by pressing the On/Off key (hold down for 2 seconds). Close the door by shutting it against the

appliance until the lock clicks shut. The buttons are only enabled with the door closed.

Use the Selection buttons to select the program.

Press the Start/Stop button to start the cycle (hold it down for 2 seconds).
Once the selected program has been successfully completed, the display shows “End”.

INTERRUPTING THE CYCLE

A cycle in progress can be interrupted by pressing the Start/Stop button. After the cycle has been interrupted, the
options available vary depending on conditions in the chamber:

1. If the temperature in the chamber is below 40°C: the door can be opened. If the door is closed again within 1

minute, the cycle can be restarted from the phase where it was interrupted, by holding down the Start/Stop
button.

2. If the temperature in the chamber is above 40°C: a RESET cycle is required since the door cannot be opened.

DOOR OPENING

Press the Door opening button: the appliance gives a beep when it receives the signal. Release the button and the
door will open automatically after a few moments.

RESET PROCEDURE

Press the Functions and Start/Stop buttons and hold them down for about 2 seconds, until a beep is heard.
"P-" appears on the display and the RESET procedure starts.

+

ALARMS

LED

When an alarm occurs: Led “Warning” on and display indication.

“AF” – fatal alarm.
“A-“ – non fatal alarm. If a non-fatal alarm occurs you can press the Start/Stop button to continue using the device.

When an error occurs, generally the device manages the anomaly itself: in this case the alarm code flashes on the
display until the problem has been dealt with: no reset commands are accepted during this time.
Any RESET forced by the user will not be accepted until the problem has been dealt with and the alarm code on the
display is “steady”.

MEANING

PROGRAMS

1 Prewash
2 Plastics 50°C
3 Glassware 60°C
4 Intensive Glassware 85°C
5 Thermodisinfection 85°C - 1’
6 Thermodisinfection 85°C - 5’
7 Thermodisinfection 85°C - 10’
8 Service

THIS DOCUMENT

Instruction sheet for basic operations.
For all the details concerning the correct and safe use of the devices in question, for the updated program table, for the
interpretation of alarm messages and for the requirements for installation: Refer to the user manual - full version.

19510081200 Fogl.EN GW0160 Smeg S.p.A. - Instruments Division -

[e-mail]