Smeg FL164A User Manual

Instructions for Use
Thank you for your trust and for buying this appliance. We hope it will successfully serve the purpose for many years.
Refrigerator is for domestic use only and is intended for storing fresh foods at the temperature higher than 0°C.
141850
Refrigerator
Placing and Installation 55
Description of the Appliance 56-58
Operation Controls 59
Use 60-61
Trouble-Shooting Guide 64-66
Instructions for Use 51
Before Putting Into Use
Before connecting the appliance to the mains supply, leave it stand for about 2 hours, which will reduce a possibility of malfunctions in the cooling system due to transport handling.
Clean the appliance, and be thorough, especially in the interior (See Cleaning and Maintenance).
In case the interior accessories are not correctly placed, rearrange them as described in chapter Description of the Appliance.
Instructions for Use
These instructions for use are intended for the user. They describe the appliance and its correct and safe use. They were prepared for various types/models of refrigerators therefore you might find in it description of some functions and accesories that your appliance does not have.
Mounting Instructions
Integrated appliances are equipped with instructions for mounting the appliance into the kitchen unit. The appliance should be professionally mounted by qualified technician and instructions are for his use only.
We Care for the Environment
141850
Our products use environmentally friendly packaging, which can be either recycled or disposed of in an environmentally friendly manner. To this end, individual packaging materials are clearly marked.
These instructions are printed either on recycled paper or chlorine free bleached paper.
When your appliance finally wears out, please try not to burden the environment with it; call your nearest authorised service agent. (See Disposing of the Worn Out Appliance)
Tips for Energy Savings
Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as possible. This is especially important if you have an upright model.
Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance).
Turn the thermostat knob from higher to lower setting as soon as possible (depends on how loaded the appliance is, ambient temperature...).
Instructions for Use52
Before loading the appliance with fresh food, make sure it was cooled to ambient temperature.
Ice and frost layer increase energy consumption, so do clean the appliance as soon as the layer is 3-5 mm thick.
If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore efficiency, replace the gasket.
The condenser on the rear wall should be always clean, free of dust or any impurities.
Always consider instructions stated in sections Positioning and Energy Saving Tips, otherwise the energy consumption is substantially higher.
Important
If you have bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate.
The appliance must be correctly connected to the mains supply. (see: Connecting to the Mains Supply).
If the food has strange smell or colour, throw it away, because it is very likely that it is spoiled and therefore dangerous to eat.
Disconnect the appliance from the power supply before repairing it (only a qualified technician should repair it), before cleaning and before replacing the light bulb.
Do not defrost the appliance with other electric devices (hair dryer etc.) and never scrape the frost layer with sharp objects. Use only enclosed tools or tools recommended by the manufacturer.
For the sake of environment protection - be careful not to damage the rear wall of the appliance (the condenser unit or the tubes - for example when moving the appliance) or any part of the refrigerating system inside the appliance.
The refrigerating system of the appliance is filled with refrigerant and oil, so when the appliance is damaged, handle it with care and dispose it of in compliance with environmental protecting precautions. (See We Care for the Environment).
The rating plate is inside the appliance or outside on the rear wall.
141850
Instructions for Use 53
Disposing of the Worn Out Appliance
When your appliance finally wears out, dispose it of. If the appliance has a lock, break it, in order to prevent eventual accidents (danger of children get locked inside the appliance).
The refrigerating system of the appliance is filled with refrigerant and insulating substances which should be separately treated and processed. Call your nearest authorised service agent or specialised servicing centre. If you don't find one, contact your local authorities or your distributor. Be careful not to damage the tubes on the rear wall of the appliance (danger of pollution).
141850
Instructions for Use54
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly ventilated room. Allowed ambient temperature depends on the model (class) of the appliance and is stated on the rating plate of the appliance.
Class Ambient temparature
SN (sub-normal) from + 10°C to + 32°C N (normal) from + 16°C to + 32°C ST (sub-tropical) from + 18°C to + 38°C T (tropical) from + 18°C to + 43°C
Never place the appliance near heat emitting devices (e.g. cooker, radiator, water heater or similar devices) and do not expose it to direct sunlight. The appliance should be positioned at least 3 cm away from the electric or gas cooker and at least 30 cm away from the oil or coal stove. If this is not possible, use an appropriate insulation. Behind the appliance there should be free space at least 200 cm² wide and above the appliance the high kitchen units should be at least 5 cm away from the appliance in order to assure adequate ventilation of the condenser unit.
141850
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply socket outlet with a ground terminal (safety socket). Required nominal voltage and frequency are indicated on the rating plate. The connection to the mains supply and earthing have to be made according to current standards and regulations. The appliance resists temporary voltage tolerance up to -15 to +10 %.
Instructions for Use 55
Description of the Appliance
141850
Shelf (1)
(the number of shelves depend on model)
Shelf can be optionally placed on the guides inside the appliance. It is protected against pulling out. If you want to remove it, slightly lift up the back part and pull it out. Glass shelves (some models only have them) are protected with plastic spacers. Before pulling the shelf out, spacers must be moved towards you. Spacers can be also removed, however, it is better to keep them for any later transport. Quickly perishable food should be stored on the back i.e. the coldest part of the shelves.
Instructions for Use56
141850
Bottle rack
(in some models only)
Bottle rack (number depends on model) is intended for storing the bottles. There are two installation positions available (horizontal or lifted in the front) thus enabling the positioning of bottles on the stopper as well. It is protected against pulling out. If you want to pull it out, simply lift its rear part and pull it towards you.
Warning!
If the door contains storing shelves, install the rack in such position that the length of the bottles will not hinder the closing of the door. The rack may carry 9 bottles of 0,75 l or more at the maximum (total weight max. 13 kg) – note the label underneath the thermostat box inside the appliance.
Defrost Water Outlet (2)
The interior of the refrigerator is cooled with cooling plate incorporated in the rear wall. Under the plate there is a channel and an outlet for defrost water. Regularly check the defrost water outlet and the channel, because they should never be clogged (as for example with food rests). If clogged, use a plastic straw and clean it.
Fruit and Vegetable Container (3)
The container is on the bottom of the appliance under the glass shelf. It provides adequate humidity which has favourable effect on fruit and vegetables stored in it (less dehydration).
Door Liner
The door liner consists of various shelves or holders used for storing eggs, cheese, butter and yogurt as well as other smaller packages, tubes, cans etc. The lower shelf is used for storing bottles.
Illumination in the Interior of the Refrigerator
The light for illuminating the interior of the appliance is on, when the door is opened. The operation of the light does not depend on the position of the thermostat knob.
Instructions for Use 57
Loading...
+ 15 hidden pages