REPLACING THE REFRIGERATOR AND FREEZER LIGHT BULB ................... 12
TRANSPORTATION AND CHANGING OF INSTALLATION POSITION .............. 12
BEFORE CALLING YOUR AFTER SALES SERVICE .......................................... 13
THE PARTS OF THE APPLIANCE AND THE COMPARTMENTS ....................... 14
UK - 1 -
PART- 1. BEFORE USING THE APPLIANCE
Special Instructions
If this appliance is to replace an old refrigerator with a lock; break or remove the lock
as a safety measure before storing it, to protect children while playing might lock
themselves inside.
Old refrigerators and freezers contain insulation gases and refrigerant, which must
be disposed of properly. Please ensure that the refrigeration tubing is not damaged.
IMPORTANT NOTE:
Please read this booklet before installing and switching on this appliance. The manufacturer assumes no responsibility for incorrect installation and usage as described in
this booklet.
Recommendations
Warning: Do not use mechanical devices or other artificial means to accelerate the
defrosting process. Do not use electrical appliances in the food storage of the appliance.
Keep the appliance ventilation openings free. Do not damage the refrigerators refrigerant circuit.
Do not use adopters or shunts which could cause overheating or burning.
Do not plug old, warped power supply cables.
Do not twist and bend the cables.
Do not allow children to play with the appliance. Children must
NEVER sit on drawers/shelves or hang from the door.
Do not plug the power supply with wet hands.
Do not place containers (glass bottles or tin containers) of liq-
uids into the freezer especially gassy liquids as they could cause
the container to burst during freezing.
Bottles, which contain a high percentage of alcohol must be
sealed well and placed vertically in the refrigerator.
Do not touch the cooling surfaces, especially with wet hands as
you could be burnt or hurt.
Do not eat ice, which have just been removed from the freezer.
If the supply cord is damaged it must be replaced by the manu-
facturer or service agent or appointed qualified person.
The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
dont play with the appliance. If the supply cord is damaged it must be replaced by the
manufacturer or service agent or appointed person.
UK - 2 -
Installation and Switching On The Appliance
This appliance is connecting to 220-240V and 50 Hz.
You can offer help from the service to install and switching on the appliance without
any cost.
Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
If the socket does not match the refrigerator plug, replace the plug with a suatible
one (at least 16 A)
Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact, we suggest you call an electrician for assistance.
Manufacturer is not responsible for failure to complete the ground connection as
described in this booklet.
Do not place the appliance in direct sunlight.
Do not use in open air and shall not be exposed to the rain.
Place the refrigerator far from heat sources and in a well-venti-
lated position. The refrigerator should be at least 50 cm from
radiators,gas or coal stoves and 5 cm far from electrical stoves.
Keep the top free for at least 15 cm.
Do not place heavy and lots of things on the appliance.
If the appliance is installed next to another refrigerator or freezer,
observe a miminum distance of 2 cm to prevent condensation.
Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good performance.
The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in lukewarm water. After drying replace all the accessories.
Supply cable must be changet by technical supporters.
Before Switching On
Wait after 3 hours before plugging the appliance in to the main power
to ensure proper performance.
There can be an odor when you first switch on the appliance. It will
disappear after the appliance starts to cool.
UK - 3 -
PART- 2.
THE VARIOUS FUNCTION AND POSSIBILITIES
Thermostat Setting
FREEZER THERMOSTAT
Freezer and refrigerator thermostat automatically regulates the inside temperature of
the compartments. By rotating the knob from position 1 to 5, colder temperatures can be
obtained. In cold seasons, you can set lower positions in order to decrease the energy
consumption.
Freezer Thermostat Setting;
1 2 : For short-term storage of food in the freezer compartment, you can set the
knob between minimum and medium position.
3 4 : For long-term storage of food in the freezer compartment, you can set knob
medium position.
5 : For freezing the fresh food. Th appliance will work longer. After you get the
cold condition you must position to its original position.
Refrigerator Thermostat Setting;
1 2 : For less coldly conditions.
3 4 : For normal conditions.
5 : For colder conditions.
REFRIGERATOR THERMOSTAT
Note that; the ambient temperature, temperature of the freshly stored food and how
often the door is opened, affects the temperature in the refrigerator and freezer compartment. If required, change the temperature setting.
When you first switch on the appliance, for starting a suitable cooling, the appliance
should work 24 hours continuously until it cools down to sufficient temperature.
In this time do not open the door so often and place a lot of food inside the appliance.
If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting or re-plugged the unit in order not to damage the compressor.
UK - 4 -
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.