Thank you for your confi dence in buying our appliance and congratulations on the excellent choice.
We hope it will successfully serve its purpose for many years.
Upright refrigerator - freezer (hereinafter: the appliance) is combined from two parts: top part is
refrigerator and bottom part is upright freezer.
Refrigerator is used in households for storage of fresh food at temperatures above 0°C).
Freezer is used in households for freezing fresh food and storage of frozen food for up to one year
(depending on the type of food).
142468
Before fi rst operation .................................................. 3
Description of the appliance ......................................5
Installation and connection ........................................ 7
Reverse door swing ..................................................9
• The appliance is manufactured in compliance with all relevant safety standards; however, it is
recommended that persons with impaired physical, motional, or mental abilities, or persons with
inadequate experience and knowledge, do not use the appliance without due supervision. The
same recommendation applies to minors using the appliance.
• Before connecting the appliance read these instructions carefully. They describe the appliance
and provide instructions for its safe and correct use. The instructions are prepared for
different types and models of the appliance so they may contain descriptions of functions and
components your appliance may not have.
Instructions also contain the NO FROST freezer version, with integrated fan and automatic
defrost.
• Remove the wrapping protecting the appliance during transport.
• Door corners are fi tted with protective spacers. Remove the spacers and replace them with the
attached pegs (certain models only).
• Before connecting the appliance to the mains supply, leave it in upright position for about 2
hours. This will reduce possibility of malfunctions in the cooling system resulting from prior
transport and handling.
• The appliance must be connected to the mains supply in accordance with the standing
regulations and local requirements.
• The appliance must not be used in open air or exposed to weather precipitation.
• Always disconnect the appliance from power supply (pull the power cord from wall socket) before
cleaning and before replacing the light bulb.
• If the power supply cord is damaged, in order to avoid hazard it must be replaced by the service
or by qualifi ed personnel.
• In event of long periods without use, switch off the appliance off with the ON/OFF button and
disconnect it from mains supply. Empty the appliance, clean the interior and leave the door ajar.
• For the protection of environment, please contact local Borough or Council for correct disposal
arrangements.
• Wrappings contain environmentally friendly materials which can be recycled, recovered or
disposed without threat to the environment.
• Never let the children play with the appliance.
• Self closing door hinge (certain models only) pulls the door to the cabinet just before closing,
thereby preventing the door to remain ajar. Equally it limits the door opening angle and prevents
damage to adjacent elements.
• Rating plate with basic information is located in the interior of the appliance. If the sticker plate is
not suitable for your language, replace it with the attached one.
• Warning: Ventilation slots on the appliance or built-in element should always be kept clean and
unobstructed.
• Warning: Do not use any mechanical accessories when thawing the refrigerator, except for
those explicitly recommended by the manufacturer.
• Warning: To prevent any pollution be careful not to damage the insulation or refrigeration tubes
at the rear wall during the installation, cleaning and disposal of the appliance.
• Warning: Do not use any electrical devices inside the appliance, except for those explicitly
recommended by the manufacturer.
142468
3
The symbol on the product or on its packaging indicates that this product may not
be treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. By
ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of thisproduct. For more
detailed information about recycling of this product, please contact your local city
offi ce, your household waste disposal service or the shop where you purchased the
product.
142468
4
Appliance description
(equipment may vary with model)
A Refrigerator(traditional and
NO FROST appliance)
1 Control panel
2 Fan*
3 Interior illumination light
4 Shelf (adjustable height)
5 Foldable egg tray (closed 6,
open 12 eggs)
6 Crisp tray
7 Door trays (options: deep,
shallow, cover or no cover)*
8 Bottle tray with holder*
15 Leg*
16 Wheel*
B Freezer
9 Freeze drawer*
10 Storage drawer
11 Storage drawer
12 Door tray*
13 Ice tray*
14 Defrost water groove*
B Freezer
9 Storage drawer*
10 Freeze drawer
11 Storage drawer
(traditional appliance)
(NO FROST appliance)
• Interior accessories of the appliance may vary according to the model.
• Drawers are protected against accidental extraction. To extract the drawer from the appliance,
open it and lift front part upwards, then pull it out. Certain models are fi tted with pull-out slide
guides which facilitate opening. Pull-out guide drawers (or shelves) are extracted by lifting the
rear end and pulling out inclined under the 45° angle. Reinsert in opposite sequence.
• Pull-out guide drawers (or shelves) are extracted by lifting the rear end and pulling out inclined
under the 45° angle. Reinsert in opposite sequence.
* Only with some models, equipment may vary with model.
142468
5
A Refrigerator
1 Control panel
2 Fan*
3 Interior illumination light
4 Shelf (adjustable height)
5 Foldable egg tray (closed 6,
open 12 eggs)
6 Crisp tray
7 Door trays (options: deep,
shallow, cover or no cover)*
8 Bottle tray with holder*
15 Leg
16 Wheel
B Freezer
9 Freeze drawer
10 Storage drawer
11 Storage drawer
12 Door tray*
13 Ice tray*
14 Defrost water groove*
• Interior accessories of the appliance may vary according to the model.
• Drawers are protected against accidental extraction. To extract the drawer from the appliance,
open it and lift front part upwards, then pull it out. Certain models are fi tted with pull-out slide
guides which facilitate opening. Pull-out guide drawers (or shelves) are extracted by lifting the rear
end and pulling out inclined under the 45° angle. Reinsert in opposite sequence.
• Pull-out guide drawers (or shelves) are extracted by lifting the rear end and pulling out inclined
under the 45° angle. Reinsert in opposite sequence.
* Only with some models, equipment may vary with model.
142468
6
Installation and connection
Selecting the locationSelecting the location
Positioning the
Positioning the
appliance
appliance
• Place the appliance in dry and well aired room. The appliance
operates best at temperature ranges indicated in the chart
below. Relevant class of the appliance is indicated on the
rating plate.
ClassAmbient temperature
SN (subnormal)from +10°C to +32°C
N (normal)from +16°C to +32°C
ST (subtropical)from +16°C to +38°C
T (tropical)from +16°C to +43°C
Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
• Place the appliance fl atly and fi rmly on a solid base. The
appliance is fi tted with adjustable feet on the front side, used
to level the appliance. Rear side of the appliance is fi tted with
wheels (certain models only) facilitating the positioning of the
appliance at the preselected place.
• The element above the appliance must be at least 5 cm away
to allow suffi cient cooling of the condenser.
• Avoid exposing the appliance to direct sunlight or heat
sources. If this is not possible, install insulation plate between
the appliance and adjacent heat source.
• Bottom front corners of the appliance is fi tted with handles to
facilitate moving (certain models only). The appliance may
stand independently or adjacent to a furniture element or wall.
Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury. Also leave
ample space for extracting shelves (see installation diagram).
142468
7
Connecting to power
Connecting to power
supply
supply
142468
Remark:
* Applies to OLD TIMER appliances (in the model marking
…O…).
• Use the power cord to connect the appliance to the mains
power. Wall outlet must be fi tted with ground terminal (safety
socket). Nominal voltage and frequency are indicated on the
relevant label or rating plate of the appliance.
• Mains power connection and grounding must be in accordance
to standing regulations and local requirements.
The appliance is able to accommodate minor temporary voltage
fl uctuations, which do not exceed -6% to +6%.
8
Reverse door swing
Required tools: socket spanner nr. 8, screwdriver, torx 25.
Caution! After unscrewing of before fi xing hinges, hold the door
to prevent it from falling and damaging.
1. Remove upper hinge cover (save it for eventual later use),
2. Unscrew upper hinge screws and remove the upper door from
3. On the bottom side of the upper door unscrew the swing
4. Unscrew the forced door closure system (B) and fi x it to the
5. Unscrew middle hinge screws, remove the door from bottom
6. Loosen the screws fi xing the leg supports (certain models
7. Tilt the appliance backward (max. 35°) to lean to the rear
7.1. Tilt the appliance backwards (max. 35°) to lean on the
Loosen three screws holding the bottom hinge (save the
8. Repeat the procedure 3 and 4 on the bottom door. In case
9. Proceed with the assembly procedure in opposite sequence.
remove also the cover on the opposite side of the upper hinge
cover (on the opposite side you will insert the attached cover
during the assembly), and remove the cover on the opposite
side of the upper part of the door.
the middle hinge.
stopper screws and remove the stopper (A). Keep this for
eventual use later on. Fix the attached stopper with its
bearing on the opposite side of the door.
opposite side of the door (certain models only).
hinge.
only), then continue the procedure either under cf. 7 or 7.1,
depending on the model of the appliance.
side of the cabinet. Unscrew the leg support screws (C) - left
and right, and remove the leg support cover (D) and place it
to the opposite side. Unscrew and remove, then reciprocally
replace the position of end switch (E) and decorative peg (F)
(for models with forced door closing system). Unscrew three
screws fi xing the bottom hinge (save the hinge for later use),
and fi x the attached bottom hinge on the opposite side.
housing at the back.
hinge for eventual subsequent door swing change). On the
opposite side affi x the attached bottom hinge. Plug the holes
left after the replacement with relevant pegs.
there is no bottom door limit peg, transfer the bearing (G) and
washer to the opposite side of the door.
Remark:
• At OLD TIMER appliances (in the model marking …O…)
alteration of door opening direction is not possible.
142468
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.