Smeg EL05 User Manual

INSTRUCTION MANUAL

DISHWASHER

Contents

1. Safety and operating instructions ___________________________ 26

2. Installation and hook-up __________________________________ 28

2.1 Water supply connection _____________________________________________________ 28

2.2 Electrical connection ________________________________________________________ 29

3. Description of the controls_________________________________ 30

3.1 Front panel ________________________________________________________________ 30

3.2 Washing programs __________________________________________________________ 32

4. Operating instructions ____________________________________ 34

4.1 Using the water softening system ______________________________________________ 34

4.2 Using the rinse aid and detergent dispensers _____________________________________ 36

4.3 General warnings and recommendations ________________________________________ 38

4.4 Using the baskets___________________________________________________________ 39

5. Cleaning and maintenance ________________________________ 42

5.1 General warnings and recommendations ________________________________________ 42

Thank you for choosing this product. We advise you to carefully read all the instructions contained in this manual, in order to understand how to operate your dishwasher safely and correctly. The manual is divided into paragraphs, which provide a step by step description of the dishwasher functions, with clear instructions accompanied by detailed illustrations. Recommendations are given for the correct use of the baskets, spray arms, containers, filters, washing programs, and for operating the controls. Follow the recommended cleaning procedures to ensure that your dishwasher always remains in perfect working order. This manual provides a quick and easy reference for answering all your questions concerning the use of your new dishwasher.

INSTALLATION INSTRUCTIONS: these are intended for the out the installation, hook-up and testing of the appliance.

USER INSTRUCTIONS: these consist of recommendations for using the appliance, a description of its controls and of the correct cleaning and maintenance procedures.

qualified technician

who must carry

Safety instructions

1. Safety and operating instructions

THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE PREVENTION AND ELIMINATION OF RADIO FREQUENCY INTERFERENCE. THE APPLIANCE IS DESIGNED FOR THE FOLLOWING PURPOSE: IMPROPER.

DESCRIBED ABOVE.

THE NAME PLATE FEATURING THE TECHNICAL DATA, SERIAL NUMBER AND MARKINGS IS VISIBLY POSITIONED ON THE INNER EDGE OF THE DOOR.

REMOVED.

DO NOT LEAVE THE DISCARDED PACKAGING MATERIALS UNSUPERVISED WITHIN THE HOME. SEPARATE THE VARIOUS MATERIALS WHICH MAKE UP THE PACKAGING AND TAKE THEM TO THE NEAREST SORTED WASTE COLLECTION CENTRE.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR USES OTHER THAN THOSE

EEC DIRECTIVES 72/23, 897336 (INCLUDING 92/31)

WASHING AND DRYING OF DISHES

THE NAME PLATE ON THE INNER EDGE OF THE DOOR MUST NEVER BE

CURRENTLY IN FORCE, INCLUDING THE

; ANY OTHER USE SHALL BE CONSIDERED

THE APPLIANCE MUST BE PROVIDED WITH AN EARTH CONNECTION IN ACCORDANCE WITH THE ELECTRICAL SAFETY REGULATIONS IN FORCE.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR PROPERTY RESULTING FROM THE FAILURE TO EARTH THE APPLIANCE OR FROM A DEFECTIVE EARTH CONNECTION.

IF THE APPLIANCE IS NOT CONNECTED TO THE ELECTRICAL POWER SUPPLY BY MEANS OF A PLUG, IT IS NECESSARY TO INSTALL AN ISOLATION SWITCH WITH A CONTACT OPENING GAP OF AT LEAST 3 MM.

THE PLUG ON THE POWER CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE, AND MUST CONFORM TO THE REGULATIONS IN FORCE. CHECK THAT THE VOLTAGE AND FREQUENCY OF THE ELECTRICAL POWER SUPPLY MATCH THE RATINGS ON THE NAME PLATE. AVOID USING ADAPTORS OR SHUNT CONNECTIONS.

NEVER UNPLUG THE APPLIANCE BY PULLING THE POWER CORD.

• AFTER INSTALLATION, THE PLUG MUST REMAIN ACCESSIBLE.

• IN THE EVENT OF DAMAGE TO THE POWER CORD, HAVE IT REPLACED BY A QUALIFIED TECHNICIAN.

IF THE APPLIANCE IS INSTALLED ON A CARPETED OR COVERED FLOOR, ENSURE THAT THE OPENINGS ON ITS UNDERSIDE ARE NOT OBSTRUCTED.

ALWAYS SWITCH OFF THE DISHWASHER AFTER EACH USE TO AVOID WASTING ELECTRICITY.

OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THE APPLIANCE MUST THEN BE TAKEN TO A SORTED WASTE COLLECTION CENTRE.

IN THE EVENT OF A FAULT, DISCONNECT THE DISHWASHER FROM THE ELECTRICAL POWER SUPPLY AND SHUT OFF THE WATER TAP. THEN CALL IN A QUALIFIED TECHNICIAN.

Safety instructions

DO NOT USE APPLIANCES WHICH HAVE BEEN DAMAGED DURING TRANSIT! IF IN DOUBT, CONSULT YOUR DEALER. THE APPLIANCE MUST BE INSTALLED AND CONNECTED IN ACCORDANCE WITH THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER OR BY A QUALIFIED TECHNICIAN.

THE APPLIANCE IS INTENDED FOR USE BY ADULTS.

THE DISHWASHER. KEEP CHILDREN AWAY FROM DETERGENTS AND FROM THE OPEN DISHWASHER DOOR. THE PACKAGING MATERIALS (PLASTIC BAGS, POLYSTYRENE, METAL BARS, ETC.) MUST NOT BE LEFT WITHIN THE REACH OF CHILDREN. KEEP CHILDREN AWAY FROM THE OPEN DISHWASHER. THE APPLIANCE MAY CONTAIN RESIDUES OF DETERGENT WHICH CAN CAUSE IRREVERSIBLE DAMAGE TO THE EYES, MOUTH, AND THROAT, AS WELL AS POSSIBLE DEATH BY SUFFOCATION.

DO NOT INTRODUCE SOLVENTS SUCH AS ALCOHOL OR TURPENTINE WHICH MAY CAUSE AN EXPLOSION.

DO NOT LOAD DISHES THAT ARE SOILED WITH ASH, WAX OR PAINTS.

LEARNING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK.

DO NOT UNDER ANY CIRCUMSTANCES TOUCH THE HEATING ELEMENT IMMEDIATELY AFTER THE END OF A WASHING PROGRAM.

OVER TIME, THE DISHWASHER HEATING ELEMENTS MAY CHANGE COLOUR, IN PART OR OVERALL. THIS IS PERFECTLY NORMAL AND DOES NOT IN ANY WAY AFFECT THE OPERATION OF THE APPLIANCE.

DO NOT ALLOW CHILDREN TO COME NEAR OR PLAY WITH

DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE.

AQUASTOP M ODE LS

THE AQUASTOP DEVICE PREVENTS FLOODING IN THE EVENT OF A WATER LEAK. WHEN THE AQUASTOP DEVICE IS TRIPPED, CALL IN A QUALIFIED TECHNICIAN TO IDENTIFY AND REPAIR THE FAULT. IN MODELS EQUIPPED WITH THE AQUSTOP DEVICE, THERE IS A SOLENOID VALVE INSIDE THE WATER INTAKE HOSE.

DO NOT CUT THE HOSE AND DO NOT ALLOW THE SOLENOID VALVE TO DROP INTO WATER.

EVENT OF DAMAGE TO THE WATER INTAKE HOSE, DISCONNECT THE APPLIANCE FROM THE ELECTRICAL POWER SUPPLY AND FROM THE WATER SUPPLY.

IMMEDIATELY AFTER INSTALLING THE DISHWASHER, PERFORM A QUICK TEST OF THE APPLIANCE FOLLOWING THE INSTRUCTIONS BELOW. IF THE DISHWASHER FAILS TO OPERATE CORRECTLY, DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY AND CALL THE NEAREST TECHNICAL SERVICE CENTRE.

DO NOT ATTEMPT TO REPAIR THE APPLIANCE.

THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY A TRAINED AND AUTHORISED TECHNICIAN:

INVALIDATE THE WARRANTY, AS WELL AS POSING A POTENTI AL HAZARD TO THE USER.

The manufacturer declines all responsibility

REPAIRS CARRIED OUT BY UNAUTHORISED PERSONS WILL

for damage to persons or property resulting from failure to

IN THE

observe the above precautions, from tampering with even a single component of the appliance, or from the use of non original spare parts.

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Some models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.

2.1 Water supply connection

Preventing the risk of clogging or damage:

long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY

Connect the intake hose to a cold water supply with 3/4” gas thread, inserting the filter A supplied with the dishwasher.

Take care to screw the hose firmly into place with your hands and then complete by tightening about 1/4 of a turn with pliers. In dishwashers equipped with the ACQUASTOP device, the filters is already fitted inside the threaded ring.

if the water pipe is new or has not been used for a

The dishwasher can also be connected to a hot water supply appliance with hot water cuts down the washing time by approximately 20 minutes, but slightly reduces its effectiveness. Make the connection to the domestic hot water supply using the same procedure described for connecting to the cold water supply.

not exceeding 60°C

. Supplying the

Installation instructions

DRAIN CONNECTION

Insert the dishwasher’s drain hose into a drain pipe having a diameter of at least place it inside the kitchen sink using the plastic support provided, taking care not to crush or excessively bend the hose. It is important to prevent the hose from coming loose and falling. For this purpose, the plastic support is equipped with a hole for tying it to the wall or water tap. The free end should be positioned at a height of between submerged in water. If a horizontal drain extension hose is used (for a maximum of 3 m) the drain hose can be placed at a maximum height of

30 and 100 cm

85 cm

4 cm

, or alternatively,

, and should never be

from the ground.

2.2 Electrical connection

Plug the power cord into a suitable electrical outlet, according to the instructions given in chapter "1. Safety and operating instructions".

User instructions

3. Description of the controls

3.1 Front panel

All the dishwasher controls are grouped on the front panel, which is of different shape depending on the model.

CONTROL LEGEND (for models with ½ load function)

WASHING PROGRAM

SELECTED PROGRAM

ON/OFF

½ LOAD WASH

ECO (55°C) PROGRAM

SUPER PROGRAM

RAPID PROGRAMME

POWER ON

SALT

RINSE AID

10 11

RECESSED DOOR HANDLE

BUTTON

LIGHT

WARNING LIGHT

SELECTOR

INDICATOR DISC (certain models only)

BUTTON

CONTROL LEGEND (for models without ½ load function)

WASHING PROGRAM

SELECTED PROGRAM

ON/OFF

ECO (55°C) PROGRAM

SUPER PROGRAM

RAPID PROGRAMME

not present

POWER ON

SALT

RINSE AID

10 11

RECESSED DOOR HANDLE

BUTTON

LIGHT

WARNING LIGHT

SELECTOR

INDICATOR DISC (certain models only)

BUTTON

User instructions

SETTING THE WASHING PROGRAM

To select the most suitable washing program, refer to the table below which indicates the recommended washing according to dish type and the degree of soiling.

After using the table to identify the most appropriate washing program, turn the

SELECTION

knob number. If necessary, depending on the programme selected, press one of the keys selection of the If the appliance is fitted with the number of the program set. Now simply pressing the

PILOT LIGHT (8)

The

TABLE OF PROGRAMS

CYCLE SWITCH BUTTON TYPE AND DEGREE

SOAK

SUPER

BIO 55°C

(*)

SUPER

(65°C)

(1/2)

ECO

55°C (1/2)

OF DIRT ON DISHES

PANS AND DISHES WHILE WAIT ING FOR LOAD TO BE COMPLETED

HEAVILY SOILED PANS AND DISHES, INCLUDING DRIED-ON RESIDUE

NORMALLY SOILED PANS AND DISHES, INCLUDING DRIED-ON RESIDUE

(1)

½ LOAD

lights up.

PROGRAM

to set the program of choice by aligning the pointer with the program

(4,5,6

or 7) allowing

55°C

wash, or the

SELECTED PROGRAM (2)

AMOUNT OF DETERGENT

GRAMS PREWASH WASH COLD

10 + 25 45°C 65°C 2 65°C YES 110' 22 1,65

COLD

SUPER

RAPID

programmes.

indicator disc, this will show the

ON/OFF

PROGR AM SEQUE NCE DURATION CONSUMPTION

RINSE

_ _ _ _

55°C 1 65°C YES 96' 18 1,28

key

HOT

RINSE

(3)

will start the program.

DRYING MINUTES

(2)

6' 4

WATER

LITRES (1)

POWER KWh (2)

NORMAL

65°C

ECO 55°C

(**) EN 50242

DAILY

65°C

DELICATE

45°C

RAPID

45°C

Only

run the soak program with half loads.

HALF LOAD

The

(1/2) NORMALLY SOILED PANS AND

DISHES

ECO

SLIGHTLY SOILED PANS AND

55°C

DISHES, INCLUDING DRIED-ON

(1/2)

RESIDUE

(1/2) NORMALLY SOILED PANS AND

DISHES

(1/2) SLIGHTLY SOILED DISHES

RAPID

DISHES WITH LITTLE DIRT AND

(1/2)

DELICATE ITEMS

(4)

option

is available for all programs

COLD

65°C 1 65°C YES 100' 18 1,45

55°C 1 65°C YES 90' 16 1,24

65°C 1 65°C YES 92' 16 1,40

45°C 1 65°C YES 62' 13 1,10

45°C 2

except the soak program

_ _

30' 13 0,50

(*) Program recommended when using “new generation” detergents containing enzymes. (**) Reference program as per EN 50242 standard.

–

(

) Not present.

(1) Average power consumption with the softener set on

level 2

(2) The cycle duration and power consumption may vary according to the water and room temperatures, and the type and amount of dishes.

+ 17 hidden pages