Smeg CIR64X3 User manual [GB]

Contents

3

1 INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 4
2 INSTRUCTIONS FOR DISPOSAL – OUR ENVIROMENTAL CARE _______ 7
3 POSITIONING OF THE HOB _____________________________________ 8
4 ELECTRICAL CONNECTION ___________________________________ 13
5 GAS CONNECTION ___________________________________________ 14
6 ADAPTATION TO DIFFERENT TYPES OF GAS_____________________ 16
7 FINAL OPERATIONS __________________________________________ 19
8 USING THE HOB _____________________________________________ 21
9 CLEANING AND MAINTENANCE ________________________________ 24

THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES
WHOSE IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS
MANUAL.

INSTRUCTIONS FOR THE INSTALLER: these are intended for the
authorized person who is to check the gas supply system and install,
commission and test the appliance.

INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for cleaning
and maintenance of the appliance.

Further product information is available from the website www.smeg.com

Precautions for Safety and Use

4

1 INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND
THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE
PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE
ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS
THEREIN BEFORE USING THE COOKING HOB. ALSO KEEP THE SERIES
OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY
QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN
FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND
CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE
HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS:
COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE
CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL
RESPONSIBILITY FOR IMPROPER USE.

THIS APPLIANCE HAS BEEN MANUFACTURED TO COOK FOOD, DO
NOT USE THE APPLIANCE TO HEAT ROOMS.

TO BE INSTALLED ONLY BY AN AUTHORIZED PERSON.

NEVER LEAVE PACKAGING RESIDUES UNATTENDED IN THE HOME.
SEPARATE WASTE PACKAGING MATERIALS BY TYPE AND CONSIGN
THEM TO THE NEAREST SEPARATE DISPOSAL CENTRE.

REPLACED APPLIANCES MUST BE TAKEN TO A SPECIAL GARBAGE
COLLECTION CENTRE.

THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE
WITH ELECTRICAL SYSTEM SAFETY REGULATIONS.

THE PLUG TO BE CONNECTED TO THE POWER SUPPLY LEAD AND
THE RELATIVE SOCKET MUST BE OF THE SAME TYPE AND COMPLY
WITH THE RELEVANT REGULATIONS. THE SOCKET MUST BE
ACCESSIBLE AFTER THE APPLIANCE IS BUILT IN.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY
LEAD.

Precautions for Safety and Use

5

IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON
THE APPLIANCE FOLLOWING THE INSTRUCTIONS PROVIDED LATER IN
THIS MANUAL. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT
IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL
ASSISTANCE CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.

AFTER EACH USE OF THE APPLIACE, ALWAYS CHECK THAT THE
CONTROL KNOBS ARE TURNED TO OFF

NEVER PLACE FLAMMABLE OBJECTS IN THE OVEN: IF IT SHOULD
ACCIDENTALLY BE SWITCHED ON, THIS MIGHT CAUSE A FIRE.

THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER
AND MARKING IS CLEARLY VISIBLE UNDER THE CASING.

THE DUPLICATE DATA PLATE MUST BE ATTACHED TO AN ADJACENT
SURFACE.

BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN
REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING
THE LABEL UNDER THE HOB.

NEVER PLACE PANS WITH BOTTOMS WHICH ARE NOT PERFECTLY
FLAT AND SMOOTH ON THE HOB GRIDS.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE
NEVER TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. TO
AVOID BURNS AND SCALDS CHILDREN SHOULD BE KEPT AWAY.

INSTALL THE APPLIANCE SO THAT WHEN DRAWERS OR DOORS OF
UNITS INSTALLED AT HOB HEIGHT ARE OPENED, ACCIDENTAL
CONTACT WITH PANS ON THE HOB IS NOT POSSIBLE.

WARNING - IN ORDER TO PREVENT ACCIDENTAL TIPPING OF THE
APPLIANCE, FOR EXAMPLE BY A CHILD CLIMBING ONTO THE OPEN
OVEN DOOR, THE STABILIZING MEANS MUST BE INSTALLED. PLEASE
REFER TO INSTRUCTIONS FOR INSTALLATION.

NEVER USE PANS OR GRIDDLE PLATES WHICH PROJECT BEYOND
THE OUTSIDE EDGE OF THE HOB.

ALL SERVICING AND MAINTENANCE ARE TO BE COMPLETED BY
THE MANUFACTURER’S AUTHORISED PERSONNEL ONLY.

Precautions for Safety and Use

6

THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR
INFIRM PERSONS UNLESS THEY HAVE BEEN ADEQUATELY
SUPERVISED BY A RESPONSIBLE PERSON TO ENSURE THEY CAN USE
THE APPLIANCE SAFELY. YOUNG CHILDREN SHOULD BE SUPERVISED
TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE.

DO NOT SPRAY ANY SPRAY PRODUCTS NEAR THE ELECTRICAL
APPLIANCE WHILE IT IS IN OPERATION.
DO NOT USE SPRAY PRODUCTS WHILE THE PRODUCT IS STILL HOT.

WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR
CARAVANS, IT SHALL NOT BE USED AS A SPACE HEATER.

DO NOT MODIFY THIS APPLIANCE.

DO NOT USE STEAM JETS FOR CLEANING THE APPLIANCE.
THE STEAM COULD REACH THE ELECTRONICS, DAMAGING THEM
AND CAUSING SHORT-CIRCUITS.

DO NOT STORE FLAMMABLE MATERIALS IN THE APPLIANCE
STORAGE DRAWER OR NEAR THIS APPLIANCE.

THE INSTRUCTIONS PACKAGED WITH THIS APPLIANCE CONTAIN
IMPORTANT INFORMATION ABOUT INSTALLATION AND USE.

UNSUITABLE FOR USE IN MARINE CRAFT, CARAVANS OR MOBILE
HOMES, UNLESS EACH BURNER IS FITTED WITH A FLAME
SAFEGUARD

IN CASE OF SERVICE, CONTACT YOUR NEAREST SERVICE AGENT
OR DISTRIBUTOR LISTED ON THE WARRANTY CARD.

The manufacturer declines all responsibility for injury or damage
caused by failure to comply with the above regulations or deriving from
tampering with even just one part of the appliance and the use of non­original spare parts.

Instructions for disposal

7

2 ENVIROMENTAL RESPONSIBILITY

Our product's packing is made of non-polluting materials, which are
therefore compatible with the environment and recyclable. Please
help by disposing of the packaging correctly. You can obtain the
addresses of collection, recycling and disposal centres from your
retailer or from the competent local organisations.

Do not discard the packaging or any part of it, or leave it
unattended. It can constitute a suffocation hazard for children,
especially the plastic bags.

Your old appliance also needs to be disposed of correctly.
Important: hand over your appliance to the local agency authorised
for the collection of electrical appliances no longer in use. Correct
disposal enables intelligent recovery of valuable materials.
Before disposing of your appliance it is important to remove doors
and leave shelves in the same position as for use, to ensure that
children cannot accidentally become trapped inside during play. It is
also necessary to cut the connecting cable to the power grid,
removing it along with the plug.

Instructions for the Installer

8

3 POSITIONING OF THE HOB

It is the law that all gas appliances are installed by authorised
persons.

Clearance around the appliance must comply with the requirements of
AS5601.
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman. Installation can be carried
out on various materials such as masonry, metal, solid wood or plastic
laminated wood as long as they are heat resistant (T 90°C).

3.1 Attachment to support structure

Create an opening in the top surface of the counter, keeping a
minimum distance of 50 mm from the rear border.

This appliance is classified as “type Y” in relation to fire hazards

and can therefore be mounted against walls higher than the work
surface on condition that a certain distance be kept between the
appliance and the wall in accordance with AS/NZS5601 so as to
avoid damage from overheating.

Make sure there is a minimum of 600 mm between the hot plate flames
and any combustible shelf or overhanging combustible material
that may be installed directly above them.

Carefully position the insulating seal supplied on the outer perimeter of
the hole made in the counter top as shown in figure 4 (the dimensions
in the figure refer from the hole to the inside of the seal), trying to
ensure that it sticks across the whole of its surface by applying light
pressure with your hands. Fix the hob to the unit using the appropriate
brackets B and spacer A as shown in figures 1, 2 and 3. Spacer A will
help to keep the hob top at the right distance from the edge of the
counter top to avoid future overheating during operation and must be
used solely in the front left-hand corner of the appliance. Carefully
trim the surplus away from edge C beyond the seal (Fig.5).

Instructions for the Installer

9

Fig.1

Fig.2

Fig.3

Fig.4

Fig.5

Instructions for the Installer

10

Overall dimensions: location of gas and electrical connection points (all
measures in mm).

3.2 Clearances above and around domestic appliances

Extract from AS5601

60 cm

hob

90 cm

hob

A 35 105

B 65 50

C 30 50

D 80 75

Instructions for the Installer

11

REQUIREMENTS

1. Overhead clearances – (Measurement A)
Range hoods and exhaust fans shall be installed in
accordance with the manufacturer’s instructions. However,
in no case shall the clearance between the highest part of
the highest burner of the cooking appliance and a range
hood be less than 600 mm or, for an overhead exhaust fan,
750 mm.

Any other downward facing combustible surface less than
600 mm above the highest part of the hob shall be
protected for the full width and depth of the cooking surface
area in accordance with Clause 5.12.1.2. However, in no
case shall this clearance to any surface be less than 450
mm.

2. Side clearances – (Measurements B & C)
Where B, measured from the periphery of the nearest
burner to any vertical combustible surface, is less than 200
mm, the surface shall be protected in accordance with
Clause 5.12.1.2 to a height C of not less than 150 mm
above the hob for the full dimension (width or depth) of the
cooking surface area. Where the cooking appliance is fitted
with a ‘splashback’, protection of the rear wall is not
required.

3. Additional requirements for Freestanding and Elevated
Cooking
Appliaces – (Measurements D & E)
Where D, the distance from the periphery of the nearest
burner to a horizontal combustible surface is less than 200
mm, then E shall be 10 mm or more, or the horizontal
surface shall be above the trivet. See insets above.