Smeg C36GGXU Installation manual

Table of Contents - Important Safety Instructions

1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................. 4

2. DIMENSION REQUIREMENTS ............................................................................................... 7

3. UNPACKING, MOVING AND POSITIONING THE RANGE .................................................... 9

4. WALL ATTACHMENT AND THE ANTI-TIP DEVICE ............................................................ 10

5. ELECTRICAL REQUIREMENTS ........................................................................................... 13

6. GAS SUPPLY REQUIREMENTS .......................................................................................... 14

WARNING: If the instructions contained in this manual are not followed

precisely, fire or explosion may result causing property damage, personal injury or loss of life.

- Do not store or use gasoline or other flammable vapors or liquids near this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switches.

• Do not use any telephones in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

- Installation and service must be performed by a qualified installer, service agency or gas supplier.

NOTE: THIS APPLIANCE MUST BE INSTALLED SOLELY AND EXCLUSIVELY BY A QUALIFIED TECHNICIAN. ANY TECHNICAL PROCEDURES MUST BE CARRIED OUT BY AN AUTHORIZED TECHNICIAN.

INSTRUCTIONS FOR THE USER: these instructions contain user advice, a description of the controls

and the correct procedures for cleaning and maintenance of the appliance.

Important Safety Instructions

1. IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very important.

We have provided many important safety messages throughout this manual and on the appliance. Read all the instructions before using the appliance and always obey all safety messages.

RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can result in severe personal injury or loss of life.

UNDERSTAND SIGNAL WORDS A signal word – DANGER, WARNING, or CAUTION – is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you could lose your life or be seriously injured if you do not immediately the instructions are not followed. CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor to moderate injury.

The safety messages will inform you of potential hazards, on how to avoid the risk of injury and what can occur if the instructions are not followed.

IMPORTANT: Installation, gas connections and grounding must conform to applicable codes. Observe all governing codes and ordinances.

follow the instructions. WARNING means you could lose your life or be seriously injured if

WARNING: For your safety, the instructions in this manual must be followed to minimize the risk of fire or explosion and to prevent property damage, personal injury or loss of life.

- This appliance is intended for home use only.

- Use this appliance only for its intended purpose. The manufacturer cannot be

held liable for damage caused by improper use of this range.

WARNING

NOTE: This range is manufactured for use with natural gas. To convert the appliance to LP/Propane gas, see the instructions in the Gas Conversion Kit provided in the literature package.

The proper gas supply connection must be available. See "Gas supply requirements”.

In the State of Massachusetts, the following installation instructions apply:

- Installation and repairs must be performed by a Massachusetts qualified or licensed contractor, plumber, or gas fitter.

- If using a ball valve, it shall be the T-handle type.

- A flexible gas connector, when used, must not exceed 3 feet.

- This appliance complies with current safety regulations. Improper use of this

range can result in personal injury and material damage.

- Read all the instructions before installing or using the range for the first time.

- Keep these operating instructions in a safe place and pass them on to any future user.

Important Safety Instructions

TIP OVER HAZARD

- A child or adult can tip the range and be killed.

WARNING

- Make sure that the anti-tip device has been properly installed and engaged. The wall-mounted brackets should anchor the sides of the range (primary system) or, in case of floor-mounted brackets, they should anchor the rear of the range to the ground.

- Make sure that the anti-tip device is re-engaged when the range is moved. The wall-mounted brackets should anchor the sides of the range (primary system) or, in case of floor-mounted brackets, they should anchor the rear of the range to the ground.

- Do not operate the range without the anti-tip device in place and engaged.

- Failure to do so can result in death or serious burns to children or adults.

PRIMARY FASTENING SYSTEM:

Visually check that the wall-mounted brackets are inserted into the appropriate lateral hooks (on both sides).

NOTE: This range is NOT designed for installation in manufactured (mobile) homes or in recreational vehicles (RVs).

DO NOT install this range outdoors.

To reduce the risk of fire, electrical shock, personal injury, or damage when

WARNING

- Read all instructions

- Proper installation is your responsibility. Have a qualified technician install and ground this appliance in accordance with these installation instructions.

- It is the responsibility of the installer to comply with installation information specified on the model/ serial ID plate. This plate is visibly positioned in the oven door frame and must not be removed.

CAUTION: To eliminate the risk of burns or fire caused by reaching over hot surface burners, do not store items directly above the rangetop.

installing the range, some basic safety precautions must be followed, including:

Important Safety Instructions

- ELECTRICAL GROUNDING REQUIRED: See the “Electrical Requirements” section. It is the customer’s responsibility: 1 To contact a qualified electrician to install the appliance 2 To ensure that the electrical system is adequate and conforms with the national ANSI / NFPA 70

ELECTRICAL CODE – latest edition – Or the CANADIAN ELECTRICAL CODE, C22.11 – 1 and C22.2 No. 01982 – or latest edition – and all local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances.

- Before you plug the electrical cord into an outlet, make sure that all the appliance controls are in the OFF position.

- Never modify or alter the construction of the appliance. For example, do not remove adjustable legs, panels, wiring or anti-tip brackets/screws.

CAUTION: This unit is designed as a cooking appliance. For safety purposes, never use it for warming the room or as a space heater.

- Do not obstruct oven vents or openings for heat exhaust.

- Test the appliance immediately after installation, following the instructions in this booklet. If the appliance does not work properly, disconnect it from the electrical power supply and call the service center. DO NOT attempt to repair the appliance.

- All adjustments and servicing must be performed by qualified installers or service technicians.

- Do not leave the packing material around the home. Sort the various items of waste and take them to the nearest specialized waste collection facility.

WARNING

SAVE THESE INSTRUCTIONS

- This appliance is intended for home use only.

- Use this appliance only for its intended purpose. The manufacturer cannot be held liable for damage caused by improper use of this range.

- This appliance complies with current safety regulations. Improper use of this range can result in personal injury and material damage.

- Read all the instructions before installing or using the range for the first time.

- Keep these operating instructions in a safe place and pass them on to any future user.

Instructions for the installer

2. DIMENSION REQUIREMENTS

CLEARANCE

MODEL

C24GGXU

C36GGXU

A B

612 mm

24 ”

912 mm

”

636 mm

25 “

636 mm

25 ”

(5)

216 mm

/2 ”

216 mm

/2 ”

1 min. when bottom of wood or metal cabinet is protected by not less than ¼” (0.64 cm) flame retardant

millboard covered with not less than No. 28 MSG sheet steel, 0.015” (0.4 mm) stainless steel, 0.024” (0.6 mm) aluminum or 0.020” (0.5 mm) copper. 35” (889 mm) min. clearance between the top of the

cooking surface and the bottom of an unprotected wood or metal cabinet. 2 max. upper cabinet depth; 3 min. cabinet opening width; 4 upper cabinet to countertop; 5 min. clearance from the sides of range to side wall or other combustible material;

NOTE: Install with zero clearance sides and back.

(3)

612 mm

24 “

912 mm

457 mm

”

(4)

18 “

18 ”

(1)

610 mm

24 “

610 mm

24 ”

(2)

330 mm

13 “

330 mm

13 ”

150 mm

/16”

”

Grounded outlet

Position within 11

/8” (300 mm) from the

left rear corner of the range.

Gas supply line

Position within 11 7/8” (300 mm) from the

right rear corner of the range.

Instructions for the installer

2.1 Product dimensions

Overall dimensions: location of electrical connection points.

60 mm - 2 3/8 ”

698 mm - 27 7/

753 mm - 29

155 mm - 6 1/8 ”

157 mm - 6 3/

212 mm - 8

55 mm - 2 1/8 ”

698 mm - 27 7/

753 mm - 29

155 mm - 6 1/8 ”

157 mm - 6 3/

212 mm - 8

/8 “

/8 ”

/8 “

/8 ”

“

”

“

”

Check the location where the range is to be installed. The range should be positioned for convenient access in the kitchen.

NOTE: Observe all governing codes and ordinances.

Any openings in the wall or floor where the range is to be installed must be sealed.

Some cabinet and building materials are not designed to withstand the heat that the oven produces during baking. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.

The cabinet opening dimensions that are shown must be used. The indicated dimensions are the minimum clearances. When installing a range under existing cabinets that do not satisfy the minimum cabinet clearances, install a rangehood over the cooking surface to avoid burn hazards. An air curtain or other overhead range hood, which operates by blowing a downward airflow onto a range, shall not be used in conjunction with the gas range unless the hood and range have been designed, tested in accordance with ANSI Z21.1 and listed by an independent testing laboratory for combination use. This type of ventilation system may cause ignition and combustion problems with the gas cooking appliance resulting in personal injury or unintended operation

Instructions for the installer

3. UNPACKING, MOVING AND POSITIONING THE RANGE

CAUTION: This unit is designed as a cooking appliance. For safety purposes, never use it for warming

the room or as a space heater.

- It is recommended that the grates, the griddle plate and burner heads, burner caps, front kick panel and oven racks be removed to facilitate handling. This will reduce the weight for moving.

- Remove the outer carton and packing material from the shipping base.

- Remove angle-mounting brackets from the range.

- Due to the weight, a dolly/fork lift with soft rubber tread wheels should be used to move this unit. The weight must be supported uniformly across the bottom.

- The floor under the legs should be protected (wood, strips, carpet, paneling, etc.) before pushing the unit into position.

- The anti-tip device must be installed, and the gas and electrical connections should be made before the range is placed in its final position.

- Ensure that the burner caps are correctly positioned on the burner bases on the rangetop.

- Legs should be installed near to where the appliance will be used as they are not secure for long transit. Keep the unit raised so the legs can be screwed into their couplings, then lower the range gently to prevent the legs and mounting hardware from being subject to any undue strain. Instead of tilting the unit, it is recommended that a pallet or lift jack be used.

- For proper performance the range must be leveled. The range is leveled by adjusting the four legs to ensure that the unit is on a perfectly level plane. To accomplish this, screw or unscrew the second part of the legs. The adjustment range of the screw is

1.37 inches (35 mm).

NOTE: this appliance must only use the specific leveling legs provided by the manufacturer.

Instructions for the installer

4. WALL ATTACHMENT AND THE ANTI-TIP DEVICE

TIP OVER HAZARD

- A child or adult can tip the range and be killed.

WARNING

- Do not operate the range without the anti-tip device in place and engaged.

- Failure to do so can result in death or serious burns to children or adults.

PRIMARY FASTENING SYSTEM:

Visually check that the wall-mounted brackets are inserted into the appropriate lateral hooks (on both sides).

ELECTRICAL SHOCK HAZARD

WARNING

CAUTION: PROPERTY DAMAGE

- Contact a qualified installer or contractor to determine the proper method for drilling holes through the wall or floor material (such as ceramic tile, hardwood, etc.)

- Failure to follow these instructions may result in damage to wall or floor coverings.

- Use extreme caution when drilling holes into the wall or floor. There may be concealed electrical wiring located behind the wall or under the floor.

- Identify the location of the electrical circuits that could be affected by the installation of the anti-tip device, then turn off power to these circuits.

- Failure to follow these instructions may result in electrical shock or other personal injury.

+ 16 hidden pages