SMC Networks SMC-QCA9880DB5 User Manual

SMC-QCA9880DB5

User Manual

802.11 a/n/ac Wireless Mini PCIE

SMC Networks

20 Mason

Irvine, CA 92618

U.S.A.

Copyright © 2014 SMC Networks

All Rights Reserved

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no
responsibility is assumed by SMC for its use, or for any infringements of patents or other rights of third parties
which may result from its use. N o lic ense is gran ted b y imp lic at ion or otherwise under any patent or pate nt right s
of SMC. SMC reserves the right to change specifications at any time without notice

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or stored in a database or retrieval system for any purpose
without the express written permission of SMC.

Microsoft and Windows are registered trademarks of Microsoft Corporation. Apple and Macintosh are registe re d
trademarks of Apple, Inc. All other brands, product names, trademarks, or service marks are property of their
respective owners.

iii

SMCD3GNV5 A dministrator Manual

Compliance

Federal

Communication Commission

Interference

Statement

This equipment has been tested and found to comply with the limits for a

Class

B digital device,

pursuant to Part 15 of the FCC Rules. These limits

are

designed to provide reasonable protection

against ha rmful in terfer ence in

a

residential installation. This equipment generates uses and can

radiate

radio

frequency energy and, if not installed and used in accordance with

the

instructions,

may cause harmful interference to radio

communications.

However, there is no guarantee that

interference will not occur in a

particular

installation. If this equipment does cause harmful

interference to radio

or

television reception, which can be determined by turning the equipment off

and

on, the user is encouraged t o try to correct t he interfer ence by one of

the

following

measures:

- Reorient or relocate the receiving

antenna.

- Increase the separation between the equipment and

receiver.

- Connect the equipment into an outlet on a circuit different from

that

to which the receiver is

connected.

- Consult the dealer or an experi enced radio/TV t echnician for

help.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the

following two

conditions: (1) This devic e may not cause harmful

interference,

and (2) this device must accept any

interference received,

including interference

that may cause undesired

operation.

FCC Caution: Any changes or modifications not expressly approved by

the

party responsible for

compliance could void the user's authority to operate

this equipment

.

iv

JI5-QCA8990DB5 User Manual

IMPORTANT

NOTE:

FCC

Radiation Exposure St

atement:

This equipment complies with FCC radiation exposure limits set forth for

an

uncontrolled environment.

This equipment should be installed and

operated

with minimum distance 20cm between the radiator &

your

body.

This device and its antenna(s) must not be co-located with any other transmitters except in accordance
with FCC multi-transmitter product procedures.

Refering to the multi-transmitter policy, multiple-transmitter(s) and module(s) can be operated
simultaneously without C2P.

This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor
environment only.

IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to

all the rules that apply to the prod uc t into which this certified RF module is integrated.

Additional testing and certification may be necessary when multiple modules are used.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, t he end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The e nd user has to be
informed that the FCC radio-frequency exposure guidelines for an uncontroll ed environment can be
satisfied. The end user has to also be informed that any cha n ges or modifications not expressly
approved by the manufacturer could void the user's authority to o pe r a t e t h is equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.1 9 statement is required to be
available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired operation.