SMC Networks SMCGS501P User Manual
USER GUIDE
EZ SwitchTM 10/100/1000
5-Port Gigabit Ethernet PoE Switch
SMCGS501P
EZ Switch
TM
10/100/1000
User Guide
From SMC’s EZ line of low-cost workgroup LAN solutions
No. 1, Creation Road III,
Hsinchu Science Park,
30077, Taiwan, R.O.C.
TEL: +886 3 5638888
Fax: +886 3 6686111
September 2014
E092014-AP-R01
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate
and reliable. However, no responsibility is assumed by SMC for its use, nor for
any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwis e under any patent
or patent rights of SMC. SMC reserves the right to change specifications at any
time without notice.
Copyright © 2014 by
SMC Networks, Inc.
No. 1, Creation Road III,
Hsinchu Science Park,
30077, Taiwan, R.O.C.
All rights reserved
Trademarks:
SMC is a registered trademark; and EZ Switch, TigerStack and TigerSwitch are
trademarks of SMC Networks, Inc. Other product and company names are
trademarks or registered trademarks of their respective holders.
W
ARRANTY AND PRODUCT REGISTRATION
To register SMC products and to review the detailed warranty statement, please
refer to the Support Section of the SMC Website at http://www.smc.com.
– 4 –
COMPLIANCES AND SAFETY
STATEMENTS
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
◆ Reorient or relocate the receiving antenna
◆ Increase the separation between the equipment and receiver
◆ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
◆ Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
N
OTE
:
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user’s authority to operate the
equipment.
– 5 –
C
OMPLIANCES AND SAFETY STATEMENTS
CE MARK DECLARATION OF CONFORMANCE FOR EMI AND SAFETY (EEC)
Declaration of Conformity (DoC) can be obtained from www.smc.com -> support
-> download
This information technology equipment complies with the requirements of the
Council Directive 89/336/EEC on the Approximation of the laws of the Member
States relating to Electromagnetic Compatibility an d 73/23/EEC for electrical
equipment used within certain voltage limits and the Amendment Directive 93/
68/EEC. For the ev aluation of the compliance with these Directiv es, the following
standards were applied:
RFI Emission:
Immunity:
◆ Limit according to EN 55022:2010
◆ Limit for harmonic current emission according to EN 61000-3-
2:2006+A1:2009 + A2:2009
◆ Limitation of voltage fluctuation and flicker in low-voltage supply
system according to EN 61000-3-3:2008
◆ Product family standard according to EN 55024:2010
◆ Electrostatic Discharge according to IEC 61000-4-2: 2008
◆ Radio-frequency electromagnetic field according to IEC 61000-4-3:
2010
◆ Electrical fast trsnsient/burst according to IEC 61000-4-4: 2012
◆ Surge immunity test according to IEC 61000-5: 2005
◆ Immunity to conducted disturbances, Induced by radio-frequency
fields: IEC 61000-4-6: 2008
◆ Power frequency magnetic field immunity test according to IEC
61000-4-8: 2009
◆ Voltage dips, short interruptions and voltage variations immunity test
according to IEC 61000-4-11: 2004
LVD:
◆ EN60950-1:2006+A11:2009+A1:2010+A12:2011
We hereby certify that this product has been tested by SMC and complies with
FCC official limits. The product can be marketed in the US in accordance with
FCC Rules based on standards 47 CFR Part 2 and Part 15 Class A Equipment
Regulations. The tests were performed in accordance with the procedures from
ANSI C63.4-2009. The test data and results are issued on test report no.
ACSF13133.
– 6 –
C
OMPLIANCES AND SAFETY STATEMENTS
CLASS A
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus as set out in the interference-causing
equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of
Communications.
Cet appareil numérique respecte les limites de bruits radioélectriques
applicables aux appareils numériques de Classe A prescrites dans la norme sur
le matériel brouilleur: “Appareils Numériques,” NMB-003 édictée par le ministère
des Communications.
PLEASE READ THE FOLLOWING SAFETY INFORMATION CAREFULLY BEFORE
INSTALLING THE SWITCH:
W
ARNING: Installation and removal of the unit must be carried out by qualified
personnel only.
◆ This guide is intended for use by network administrators who are
responsible for setting up and installing network equipm ent; consequent ly it
assumes a basic working knowledge of LANs (Local Area Networks).
◆ The unit must be connected to an earthed (grounded) outlet to comply with
international safety standards.
◆ Do not connect unit to an A.C outlet (power supply) without an earth
(ground) connection.
◆ The socket outlet must be near to the unit and easily accessi b le. You can
only remove power from the unit by disconnecting the power cord from the
outlet.
◆ This unit operates under SELV (Safety Extra Low Voltage) conditions
according to IEC 60950. The conditions are only maintained if the
equipment to which it is connected also operates under SELV conditions.
SAFETY PRECAUTIONS
Read the following information carefully before operating the device. Please
follow the following precaution items to protect the device from risks and
damage caused by fire and electric power:
◆ Use the power adapter that is included with the device package.
– 7 –
C
OMPLIANCES AND SAFETY STATEMENTS
◆ Pay attention to the power load of the outlet or prolonged lines. An
overburdened power outlet or damaged cords and plugs may cause electric
shock or fire. Check the power cords regularly, if you find any damage,
replace it at once.
◆ Proper space for heat dissipation is necessary to avoid any damage caused
by device overheating. The ventilation holes on the device are designed for
heat dissipation to ensure that the device works normally. Do not cover
these ventilation holes.
◆ Do not put this device close to a place where a heat source exits or high
temperature occurs. Avoid placing the device in direct sunshine.
◆ Do not put this device close to a place which is damp or wet. Do not spill
any fluid on this device.
◆ Please follow the instructions in the user manual/quick install guide carefully
to connect the device to your PC or other electronic product. Any invalid
connection may cause a power or fire risk.
◆ Do not place this device on an unstable surface or support.
PRÉCAUTIONS DE SÉCURITÉ
Lisez attentivement les informations suivantes avant d’utiliser votre appareil.
Respectez toutes les précautions afin de protéger l’appareil des risques et dégâts
provoqués par un incendie et l’alimen tation électrique :
◆ Utilisez exclusivement l’adaptateur d’alimentation fourni avec cet appareil.
◆ Faites attention à la puissance de charge de la prise de courant ou des
rallonges électriques. Une prise surchargée ou des cordons et des fiches
endommagés peuvent provoquer une électrocution ou un incendie. Vérifiez
régulièrement votre câble électrique. Si vous constatiez le moindre défaut,
remplacez-le immédiatement.
◆ Il est primordial de laisser suffisamment d’espace autour de l’appareil pour
permettre la dissipation de la chaleur et éviter les dégâts provoqués par une
surchauffe de l’appareil. Les orifices de ventilation de l’appareil sont conçus
pour permettre la dissipation thermique et garantir le bon fonctionnement
de l’appareil. Ne couvrez jamais ces orifices.
◆ Ne placez pas cet appareil à proximité d’une source de chaleur ou dans un
endroit exposé à des températures élevées. Evitez également de l’exposer à
la lumière directe du soleil.
– 8 –
C
OMPLIANCES AND SAFETY STATEMENTS
◆ Ne placez pas cet appareil à proximité d’un lieu humide ou mouillé. Prenez
garde à ne renverser aucun liquide sur cet appareil.
◆ Merci de suivre les instructions du manuel d'utilisateur / guide d’installation
rapide attentivement pour connecter l'appareil à votre PC ou à tout autre
produit électronique. Toute connexion non valide peut provoquer un
problème électrique ou un risque d'incendie.
◆ Ne placez pas cet appareil sur une surface ou un support instable.
SICHERHEITSMAßNAHMEN
Lesen Sie vor der Inbetriebnahme des Gerätes aufmerksam die nachstehenden
Informationen. Bitte befolgen Sie die nachstehenden Sicherheitsmaßnahmen,
damit das Gerät nicht beschädigt wird oder Gefahren durch Brand oder
elektrische Energie entstehen:
◆ Verwenden Sie nur das beim Gerät mitgelieferte Netzteil.
◆ Achten Sie auf die Last der Steckdose oder des Verlängerungskabels. Eine
überlastete Steckdose oder beschädigte Kabel und Stecker können
Stromschläge und Brand verursachen. Prüfen Sie die Netzkabel regelmäßig.
Ersetzen Sie sie umgehend, falls sie beschädigt sind.
◆ Achten Sie zur Vermeidung von Geräteschäden aufgrund von Überhitzung
darauf, dass genügend Freiraum zur Wärmeabfuhr vorhanden ist. Die
Belüftungsöffnungen am Gerät dienen der Wärmeabfuhr und damit der
Gewährleistung eines normalen Gerätebetriebs. Decken Sie diese
Belüftungsöffnungen nicht ab.
◆ Stellen Sie dieses Gerät nicht i n der Nähe v o n Wärme quell en ode r an Orten
mit hohen Temperaturen auf. Platzieren Sie das Gerät nicht im direkten
Sonnenlicht.
◆ Stellen Sie dieses Gerät nicht an feuchten oder nassen Orten auf. Achten
Sie darauf, keine Flüssigkeiten über dem Gerät zu verschütten.
◆ Befolgen Sie die Hinweise im Benutzerhandbuch (bzw. in der Kurzanleitung)
zum Anschluß des Gerätes an einen PC oder ein anderes Elektrogerät.
Jegliche unzulässige Verbindung birgt die Gefahr von Stromschlägen und
Brandgefahr.
◆ Platzieren Sie dieses Gerät nicht auf einer instabilen Oberfläche oder
Halterung.
– 9 –
Loading...