Smart Watch KW17 User Manual

KW17

Smart Watch

User Manual

Please refer to this manual before using the product

V1.0

Notes:

1.The company reserves the right to modify the contents of this manual without any further notification. It is normal that some functions may vary in certain versions of software.

2.Please charge this product with the configured charger for no less than 2 hours before using it.

3.Please connect with the APP and set personal information to sync time before use. Please refer to the instructions of the subsequent synchronization software for details.

4.Lights up when charging and phone push. Bright red during charging, green after fulling charged, and the phone pushes with flicker color.

1. Product Overview

Display zoneTouch screenButton

Magnet charging portHeart rate sensor

Models can be paired with:

Android phones: support OS 5.0 and above

Iphones:Support OS 9.0 and above

2.APP download and connection

1.Please scan the QR code below to download APP

It is recommended to use a browser to scan and download. Currently, WeChat scan download is not supported. Please give the corresponding permissions of this software in the download and installation process for BT connection.

The APP name is “Da Fit”.

( Da Fit QR code)

Notes:

1.For Apple phone users: If it is in standby or hibernation state for a long time (for example,

2hours or more) on Apple phone, (the phone has not been using, and it is in a black screen state), Da Fit will be cleaned up by IOS system, then the APP application and watch disconnect in between, the functions on APP are not available to use. Please re-open the watch and it will be automatically reconnected.

2.For Android phone users: After installing the APP software on the Android phone, you need to enable the background application launch permission in the settings of your phone. Each smart phone has a difference. Take Huawei phone as an example. The steps are as follows:

Settings--Application--Application Launch Management-- Da Fit, find the APP application, change the automatic management to manual management, open all permissions (allow Auto-launch,Secondary launch, Run in background). This is only for the APP application to maintain the Bluetooth connection with the watch while the phone is in standby (the phone does not have a bright screen), and will not be cleaned up by the Android system. Will not use network traffic in the background, nor does it affect the power consumption of the phone.