Page 1
USER'S GUIDE
USER'S GUIDE
Smart30
3-PHAS E
30 AMPS
30 AMPS
SINGLE PHASE
Thank you for purchasing this Smart30. Smart Power
Systems is dedicated to developing and manufacturing
the highest performance power protection and filtration
devices for your electronic equipment. Proper use of this
device will provide the protection needed for your
connected equipment.
P.N.16001090 Rev.11/14
Page 2
Use this user's guide for the following products:
MODEL
S30-1P120
S30-1P240
S30-1P120-240
S30-3P240
S30-3P120-208
30 Amp, Single Phase 120 Volts, 2 wire + Ground
OUTPUT
RECEPTACLE
30 Amp, Single Phase 240 Volts, 2 wire + Ground
OUTPUT
RECEPTACLE
30 Amp, Single Phase 120/240 Volts, 3 wire + Ground
OUTPUT
RECEPTACLE
30 Amp, 3 phase 240 Volts, 3 wire + Ground
OUTPUT
RECEPTACLE
30 Amp, 3 phase 120/208 Volts, 4 wire + Ground
OUTPUT
RECEPTACLE
DESCRIPTION
L5-30R
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
PLUG
TYPE
L5-30P
L6-30PL6-30R
L14-30PL14-30R
L15-30PL15-30R
L21-30PL21-30R
CAUTION
• Use only in dry locations indoors.
• Avoid dropping the unit.
• Only plug the Smart30 into a three pronged grounded outlet. This unit is not to be
used with any type of ground “lift” or pin eliminator.
• Do not open the Smart30 unit, there are no serviceable parts inside. Opening the unit
will void your warranty.
CAUTION
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
CAUTION
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
ATTENTION
• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Ne branchez le Smart30 dans une prise de terre à trois pronged. Cette unité ne doit pas être
utilisé avec tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité Smart30, il n'y a pas de pièces réparables. Ouverture de l'unité annulera
votre garantie.
ATTENTION
Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection
contre les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant
sans protection. Si cette situation est souhaitable pour l'application, suivez les instructions du
fabricant pour le remplacement de l'appareil.
ATTENTION
Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la
prise électrique et le panneau de service électrique.
Page 3
WALL MOUNT INSTALLATION
To mount your Smart30 unit to a wall or
other surface, first, install four screws (not
included) on the wall, where monitoring
lights can be observed. Leave 1/4 inch of
the screw exposed. Use the two mounting
holes in the back of the Smart30 by sliding
them into the exposed part of the screws
and lock into place.
BACK OF UNIT
INSTALLATION OF SMART30
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Smart30 .
3. Plug the Smart30 unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Smart30 where monitoring lights can
be observed.
Unit
Connected
Equipment
3-PHASE
FRONT VIEW
3-PHASE
REAR VIEW
CAUTION
Power Cord
PHASE
SEQUENCE
INDICATORS
NORMAL
REVERSE
OUTPUT
RECEPTACLE
POWER LINE INDICATORS
Smart30
PHASE SEQUENCE INDICATORS
NORMAL REVERSE
LINE 1
LINE 1 LINE 2
LINE 2
LINE 3
Power Cord
LINE 3
INPUT PLUG
WITH CORD
In case of reverse phase sequence in 3 phase models (RED LED ON), the phase sequence should
be corrected at the wall outlet by a certified electrician. Reverse phase sequence might lead to
malfunction of the 3 phase equipment.
ATTENTION
En cas de séquence de phase inverse en 3 modèles de phase (LED rouge sur), la séquence de
phase devrait être corrigé à la prise murale par un électricien certifié. Séquence de phase inverse
peut entraîner un dysfonctionnement de l'équipement en 3 phases.
SINGLE PHASE
FRONT VIEW
SINGLE PHASE
REAR VIEW
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at support@smartpowersystems.com
FAULT
OUTPUT RECEPTACLE
ON
INPUT PLUG WITH CORD
Page 4
OTHER POWER PROTECTION PRODUCTS
TRANSFORMER BASED FILTER SERIES (TBF™) POWER FILTERS
Considered to be one of the most significant developments in the power protection industry.
TBF™ Filters contain innovative technology that combines Surge Suppression and Noise
Isolation which filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682).
Exclusive "POVP" Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the
output power if voltage exceeds 155 volts. Exclusive Smart Technology (US Patent
#5721661) protects microprocessor based equipment against reverse polarity or no ground.
The patented TBF™ filters prevent 90% of the power problems experienced by your POS
system, computer, copier and facsimile machine.
LINE CONDITIONERS
Reduces the need for a dedicated line where voltage on ground is present. This transformer
isolation technology is an option to expensive rewiring where poor wiring conditions exist on
older or renovated buildings.
UNINTERRUPTIBLE POWER SUPPLIES - UPS SERIES
Smart Power Systems' Uninterruptible Power Supplies (UPS) integrated TBF™ Technology
provide on-line power conditioning.
WARRANTY
All Smart30 units are guaranteed free of defects in material or workmanship for 5 years. See our
website for more details - www.smartpowersystems.com
$25,000 Connected Equipment Warranty
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and
damage the connected equipment, Smart Power Systems will pay for the repair or replacement of
the connected equipment of the original purchaser . See our website for more details www.smartpowersystems.com
IMPORTANT
If for any reason you need to return the Smart30 unit to the manufacturer, you should
obtain an RMA (Return Material Authorization) number before returning the unit. To
request an RMA number please call 1-800-772-7633 or visit the website at
www.smartpowersystems.com/rma.htm
Meets
UL 1449 3rd. Edition
Requirements
1760 Stebbins Drive - Houston, Texas 77043 - Tel:(713)464-8000 - Fax:(713)984-0841
E-mail: support@smartpowersystems.com - www.smartpowersystems.com 1-800-882-8285
Loading...