Smart Power Systems LC Plus User Manual

LC
ISOL ATION TR ANSFORM ER-BAS ED
LINE C ONDI TIONER
With
SMART
GROUND
COMPUTER-GRADE
LINE CONDITIONING
LINE CONDITIONERS
Reduces the need for a dedicated line where voltage on ground is present. This transformer isolation technology is an option to expensive rewiring where poor wiring conditions exist on older or renovated buildings.
OTHER POWER PROTECTION PRODUCTS
TRANSFORMER BASED FILTER SERIES (TBF™) POWER FILTERS
Considered to be one of the most significant developments in the power protection industry. TBF™ Filters contain innovative technology that combines Surge Suppression and Noise Isolation which filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682). Exclusive "POVP" Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the output power if voltage exceeds 155 volts. Exclusive Smart Technology (US Patent #5721661) protects microprocessor based equipment against reverse polarity or no ground. The patented TBF™ filters prevent 90% of the power problems experienced by your POS system, computer, copier and facsimile machine.
AUTOMATIC VOLTAGE REGULATOR - AVR SERIES Regulates the voltage to protect equipment against voltage sags and brownouts. Electronic systems are designed to operate based on a clean and constant supply of AC voltage. Smart Power Systems' AVR line provides boost & buck capability to eliminate under or over voltage fluctuations.
UNINTERRUPTIBLE POWER SUPPLIES - UPS SERIES Smart Power Systems' Uninterruptible Power Supplies (UPS) integrated TBF™ Technology provide on-line power conditioning.
WARRANTY
5 year product warranty
Smart Power Systems warrants that our LC Plus Series Line Conditioners are free of defects in material and workmanship for 5 years --or, they will be repaired or replaced free of charge. See our website for more details - www.smartpowersystems.com
$25,000 Connected Equipment Warranty
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and damage the connected equipment, Smart Power Systems will pay for the repair or replacement of the connected equipment of the original purchaser . See our website for more details ­www.smartpowersystems.com
USER'S GUIDE
USER'S GUIDE
User's guide for the following models:
LC70SG-2R, LC100SG-2R, LC180SG-4R,
LC200SG-4R, LC300SG-4R
Thank you for purchasing this LC Plus. Smart Power Systems is dedicated to developing and manufacturing the highest performance power protection and filtration devices for your electronic equipment. Proper use of this device will provide the protection needed for your connected equipment.
16000900 Rev.05/09
If for any reason you need to return the LC Plus unit to the manufacturer, you should obtain an RMA (Return Material Authorization) number before returning the unit. To request an RMA number please call 1-800-772-7633 or visit the website at www.smartpowersystems.com/rma.htm
LC Plus Unit
1760 Stebbins Drive - Houston, Texas 77043 - Tel:(713)464-8000 - Fax:(713)984-0841 E-mail: support@smartpowersystems.com - www.smartpowersystems.com 1-800-882-8285
IMPORTANT
INSIDE THE BOX
User's Manual CAT.5 Patch Cord
CAUTION
• Use indoors only
• Avoid dropping the unit.
• Only plug the LC Plus into a three pronged grounded outlet. This unit is not to be used with any type of ground “lift” or pin eliminator.
• Do not open the LC Plus unit, there are no serviceable parts inside. Opening the unit will void your warranty.
INSTALLATION
1. Turn off and unplug your equipment.
2. Plug your equipment into the LC Plus unit.
3. Plug the LC Plus unit into a properly grounded power outlet.
4. Turn on your equipment. Your equipment is now fully protected from disruptive and destructive power disturbances.
If you have any questions call us at our Tech Support line toll free 1-800-772-7633 or email us at upport@smartpowersystems.comS
IMPORTANT SAFETY INSTRUCTIONS
WARNING
• SAVE THESE INSTRUCTIONS: This manual contains important instructions that should be
followed during installation and maintenance of the LC Plus.
• Install this unit in a controlled environment.
CAUTION
• For indoor use only.
• Plug the LC Plus unit into a three pronged 120VAC power outlet.
• Use of adapters or ground pin eliminators will void your warranty.
• Risk of electric shock, do not remove cover. No user serviceable parts inside. Refer servicing to qualified service personnel.
• Avoid exposing the LC Plus to direct sunlight, stoves or any other heat source.
• To prevent overheating, make sure that the ventilation openings of the unit are not covered.
• Keep unit away from moisture and dust.
FEATURES
Magnetic Isolation Transformer For Noise Filtration
SPECIFICATIONS
MODEL
Output Current (Amps)
Power Rating (VA)
Input Voltage
Output Voltage
Input/Output Frequency
Typical Noise Rejection:
Cooling
Input Cord Length
Input Plug
Output Receptacle
Overload Protection
Color
Size D x W x H (In)
Net Weight (Lbs.)
Operating Environment
WARRANTY
All models include Smart Ground (Patent Pending). Specifications subjects to change without notice.
LC70SG-2R
0.7 1 1.5 2
84 120180 240
Common mode noise rejection >100dB (Less than 0.5 Volts pass through voltage) - Normal mode noise rejection >65dB (Less than 10 Volts pass through voltage)
(2) 5-15R
5.85 6.30 9.70 10.45
LC100SG-2R LC180SG-4R LC200SG-4R
SYSTEM DESCRIPTION
FRONT REAR
1
2
3
1. Normal
2. Power On
3. No Ground
120V
120V
60Hz (Optional 50Hz)
Convection
6 ft.
5-15P
Circuit Breaker & Electronic
Black
7.9 x 5.5 x 4.5 (200 x 139 x 114)
0-40°C at full load, 0-90% relative humidity (non condensing)
5 years
LC70 to LC300
1
1. Output Receptacles
2. Circuit Breaker
3. Input Power Cord
4. Network Protection
(4) 5-15R
4 RECEPTACLE MODEL
4
2
3
1
1. Output Receptacles
2. Circuit Breaker
3. Input Power Cord
4. Network Protection
LC300SG-4R
2.5
30024018012084
13.45
4
2
3
Loading...