SmartLabs 4773 Users Manual

Quick-Start Guide

In-Line Switch, 277V

Model: 4773

Tools Needed

• Phillips screwdriver

• Wire cutter / stripper

• Voltage tester

• Non-conductive probe

Set button

Installation

1) Be sure to write down the INSTEON ID and location of

the fixture you’ll be controlling (e.g., 01.F7.G5, Mike’s
bedroom light)

2) At the circuit breaker or fuse panel, disable the circuit

supplying power to the fixture

3) Remove the wallplate from the fixture you are replacing.

Then, unscrew the fixture itself and pull it out from the
junction box.

4) Disconnect the wires from the fixture you will be

controlling and ensure you have 1/2” of bare wire on the
ends. If the wires cannot be detached by unscrewing
them, cut the wires where they enter the switch and
then strip ½ inch of insulation off the ends.

5) See Figure 1 to identify and connect the LINE, LOAD,

NEUTRAL, and GROUND wires on In-Line Switch. Be sure
you have correctly identified the wires in the junction
box before connecting them.

6) After you have connected all the wires, ensure that the

wire connectors are firmly attached and that there is no
exposed copper except for the GROUND wire

7) Prior to reinstalling the fixture, enable power to the

fixture from the circuit breaker or fuse panel

8) Use the On/Off buttons to test that the module is

working and controlling the load

9) Link In-Line Switch to the desired INSTEON Controllers:

10) Gently place In-Line Switch into the junction box,

11) Reinstall the fixture

a. Set the Controller to Linking Mode.* (For most

Controllers, press & hold an On or Scene button
for 10 seconds or the Set button for 3 seconds.)

b. Press & hold the Set button on In-Line Switch

until it double-beeps (3 seconds)

The In-Line Switch Status LED will flash once
and then turn on solid if the load is off or turn
off if the load is on

c. Confirm that Linking was successful by tapping

the button you just Linked to on the Controller

In-Line Switch will respond appropriately

making sure that nothing could accidentally be pressing
any of the buttons on its face

Complete Instructions, Troubleshooting, and Tech Support

Call: Tech. Support @ 866-883-9220
Contact Us Online:

*Setup Modes will automatically time out after 4 minutes.

www.smartproline.com

NOTE: Home’s wire color and wire location may vary

Wiring Diagram

On button

Off button

Figure 1

Page 1 of 1
Rev. 04-29-2011

SMART Limited Warranty – SMART warrants to original consum er of this product for a period of 2 years from date of purchase, this pr oduct will be free from
defects in material & workmans hip & will perform in substantial confor mity with its Installation and Progr amming Guide. Warranty shall not apply to defects
caused by misuse or neglect.
U.S. Patent No. 7,345,998, International patents pending © Copyright 201 1
SMART, 16542 Millikan Ave., Irvine, C A 92606, 866-883-9220