Page 1
49 1/2"
(125.7 cm)
85 3/4" (217.8 cm)
#2
690
×2
×12 ×12
SB690-MP
SMART GoWire™ auto-launch cable
1
SMART GoWire™ Auto-Launch Cable
(GW-MP, GW-MPP)
SMART GoWire™ Auto-Launch Cable
(GW-MP, GW-MPP)
Limited Equipment Warranty
Thank you for your recent purchase. In the unlikely event that you have problems with your equipment, SMART’s technical support personnel
are available to assist you. The terms and conditions of SMART’s warranty are set forth below – please review them carefully. Please see the
reverse side of this page for warranty-claim procedures.
Limited Warranty to End-User Purchaser
Subject to the exceptions noted below, this limited warranty (the “Warranty”) covers all defects in materials and workmanship of your new
SMART hardware product, together with included software distribution media, pens, eraser and cables (the “Equipment”). SMART extends the
Warranty to the end-user purchaser (the “Purchaser”) of the Equipment.
The duration of the Warranty (the “Warranty Period”), commencing on the date of new purchase, is ONE YEAR for optional
accessories (including room control modules, wireless serial or USB connections, floor stands, speakers, cables, USB adapters,
keyboards, etc.) and service repair parts, with the following exceptions:
Fully discharged SMART Slate™ lithium ion batteries are not covered by warranty.
Projector lamps (used under normal projector operating conditions, not in excess of 8 hours per day and 260 days per year) are
covered by warranty for 500 hours or 90 days, whichever comes first.
THE WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT
LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. ANY REPRESENTATION
OR WARRANTY, OR AFFIRMATION OF FACT, MADE BY ANY SALES REPRESENTATIVE OR OTHER AGENT OF SMART, INCLUDING
BUT NOT LIMITED TO STATEMENTS REGARDING CAPACITY, SUITABILITY FOR USE OR PERFORMANCE, EXPRESS OR IMPLIED,
WHICH IS NOT SPECIFICALLY SET FORTH HEREIN WILL NOT BE BINDING UPON SMART.
SMART has not authorized any other party to alter, modify, extend, enhance or limit the Warranty and SMART will not assume any
responsibility or liability for any statements or representations made by any other persons or entities.
Repair or Replace
The Purchaser’s exclusive remedy and SMART’s sole obligation during the Warranty Period shall be for SMART to repair or, at its option,
replace the Equipment that has failed or that has proven to be defective at no cost to the Purchaser except for the one-way shipping cost of the
Equipment to a SMART-authorized service center. Any charges associated with a rush-requested order, such as air express, are the
responsibility of the Purchaser. Prior to returning any equipment under the Warranty, the Purchaser must render proof of the original
purchase date and must thereafter obtain from SMART a Return of Merchandise Authorization (RMA) number. The RMA number shall
be clearly marked on the packaging of the Equipment being returned. All returned Equipment that is replaced under the Warranty shall become
the property of SMART.
Limitation of Damages
The liability of SMART to the Purchaser arising out of the purchase and supply of the Equipment or its use, whether based upon Warranty,
contract, tort (including, without limitation, negligence) or otherwise, shall not in any case exceed the original cost to the Purchaser of the
Equipment, and upon expiration of the Warranty Period such liability will terminate.
SMART shall not be liable, whether in contract or on any other basis, for any damages sustained by the Purchaser or any other person arising
from or related to loss of use, failure or interruption in the operation of the Equipment, delay in repair or replacement or for incidental,
SBX800i4
consequential, indirect or special damages or liabilities, loss of revenue, loss of business or other financial loss arising out of or in connection
with the sale, lease, maintenance, use, performance failure or interruption of the Equipment.
Warranty Exclusions
The Warranty will not apply to and SMART will not be liable for (i) any Equipment which is not purchased from an authorized SMART dealer or
distributor; (ii) Equipment that has been damaged by accident, abuse, neglect, misuse or causes other than ordinary use (see manuals that
ship with Equipment for further detail), including the direct application of any cleaning liquids, substances or abrasives to the hardware or onto
any display surface other than in accordance with the cleaning and care instructions included in the User’s Guide for the Equipment; (iii)
Equipment which has been altered, changed, serviced or repaired by anyone other than SMART-authorized repair personnel; or (iv) any
Equipment on which the serial number has been defaced, modified or removed. Warranty service hereunder shall not operate to extend the
original Warranty Period. The Warranty excludes damage incurred in shipment to or from SMART. If the Equipment is received by the
Purchaser in a damaged condition, the carrier and SMART must be notified immediately. Purchasers located outside the U.S. or Canada
should instead contact the carrier and their SMART dealer or distributor.
Third-Party Equipment Warranty Extension and Exception
For equipment sold by SMART to the Purchaser but manufactured by a corporation other than SMART (such as wall-mounted cabinets,
carrying cases and other specified components), SMART shall extend to the Purchaser, to the extent permitted, any and all applicable warranty
provisions provided to SMART by the third-party manufacturer. The extension of any and all applicable third-party manufacturer warranty
provisions shall be an exception to this Warranty and represents SMART’s sole responsibility with respect to such equipment.
SBX800i4
×2
2 3 4
6" (15.3 cm)
77 1/2"
(196.9 cm)
5 6
×2
A B
7 8 9
Page 2
10
SB690
11
12
SB690 SB690-MP
WARNING
Failure to follow the installation instructions shipped with your SMART product could result in personal injury and damage to the product.
Refer to the safety warnings and precautions published by the projector manufacturer. Do not stare (or allow children to stare) directly into the projector’s
beam of light.
Do not climb (or allow children to climb) on your SMART Board interactive whiteboard. Climbing on the product could result in personal injury and product damage.
Do not stand (or allow children to stand) on a chair to touch the surface of your SMART product. Rather, wall-mount the product at the appropriate height.
To reduce the risk of fi re or electric shock, do not expose your SMART product to rain or moisture.
Two people are required to mount your SMART product because it may be too heavy for one person to safely maneuver.
Ensure that any cables extending across the fl oor to your SMART product are properly bundled and marked to prevent a tripping hazard.
Do not mount the SMART Board 690 interactive whiteboard on a fl oor stand.
-MP
IMPORTANT
You must connect the USB cable that came with your SMART Board interactive whiteboard to a computer that has a USB compliant port and that bears the USB
logo. In addition, the USB source computer must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or UL Mark(s) for CSA/UL 60950.
This is for operating safety and to prevent damage to the SMART Board interactive whiteboard.
If your product requires replacement parts, make sure the service technician uses replacement parts specifi ed by SMART Technologies or parts with the same
characteristics as the original.
For cautions and warnings, see the SMART Board 600 and SBD600 Series Interactive Whiteboard Installation and User’s Guide (smarttech.com/kb/001414).
Hardware environmental compliance
SMART Technologies supports global efforts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and environmentally friendly manner.
Waste Electrical and Electronic Equipment Regulations (WEEE directive)
Waste Electrical and Electronic Equipment regulations apply to all electrical and electronic equipment sold within the European Union. When you dispose of any electrical
or electronic equipment, including SMART Technologies products, we strongly encourage you to properly recycle the electronic product when it has reached the end of its
life. If you require further information, please contact your reseller or SMART Technologies for information on which recycling agency to contact.
Restriction of Certain Hazardous Substances (RoHS directive)
This product meets the requirements of the European Union’s Restriction of Certain Hazardous Substances (RoHS) Directive 2002/95/EC. Consequently, this product also complies
with other regulations that have arisen in various geographical areas, and that reference the European Union’s RoHS directive.
Packaging
Many countries have regulations restricting the use of certain heavy metals in product packaging. The packaging used by SMART Technologies to ship products complies with
packaging laws.
China’s Electronic Information Products Regulations
China regulates products that are classifi ed as Electronic Information Products (EIP). SMART Technologies products fall under this classifi cation and meet the requirements for
China’s EIP regulations.
U.S. Consumer Product Safety Improvement Act
The United States has enacted the Consumer Product Safety Improvement Act which limits the lead (Pb) content in products used by children. SMART
Technologies is committed to complying with this initiative.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
*99-00736-23-B0*
www.smarttech.com/support www.smarttech.com/contactsupport
© 2009–2011 SMART Technologies ULC. All rights reserved. SMART Board, SMART GoWire, smarttech and the SMART logo are trademarks
or registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party product and company names may be
trademarks of their respective owners. Patent No. US5448263; US6141000; US6320597; US6326954; US6337681; US6741267; US6747636;
US7151533; US7289113; US7499033; US7626577; US7757001; US7687736; CA2058219 and CA2252302. Other patents pending. Contents
are subject to change without notice. 03/2011.
99-00736-23 B0
Loading...