Smart Avi HDX-PRO User Manual

Page 1
User Manual
HDX-PRO
Use a single CAT5 to broadcast high
resolution HDTV Video, Stereo Audio,
RS232 and IR up to 1000ft away.
2840 N. Naomi Ave.
Burbank, California 91504
www.smartavi.com
Facsimile: (818) 565-0020
© Copyright 2007 Smart-AVI, All Rights Reserved
Technical Specifications
TRANSMITTER AND RECEIVER
Notice
Video
Bandwidth 400MHz
Analog signal Level 1 volt
Impedance 75 ohms
Connector
The information contained in this document is
subject to change without notice. Smart-AVI makes
no warranty of any kind with regard to this material,
including but not limited to, implied warranties of
merchantability and fitness for any particular
purpose.
3 RCA
Format
YPbPr analog component video
Audio
Bandwidth 20 KHz
Signal level OdB
Impedance 10K ohms
Smart-AVI will not be liable for errors contained
connection with the furnishing, performance or use
herein or for incidental or consequential damages in
of this material.
No part of this document may be photocopied,
reproduced ortranslated into another language with
out prior written consent from Smart-AVI.
Connector RCA Left and Right
System and Cable
Type Cat5 UTP EIA 568A
Connector RJ45
Power
Requirements 5V DC @500mA
Connector 5x2.1 DC Jack
RS232
DB9 Male/Female
For the complete manual, visit www.smartavi.com.
Recieve on DB9 Male
baudrate up to 115,000bps
IR
IR Emitter Output
IR Frequency Range 30KHz to 80KHz
Emitter Distance Up to 10’
Connector 3.5mm stereo jack for emitter
m_hdxpro-062509
9BDnoataDevieceR
noitpircseD
noitpircseDnoitpircseD
emaNemaN
emaN
emaNemaNnoitpircseDnoitpircseD
.oN.oN
.oN
.oN.oN
niPniP
niP
niPniP
5DNGSdnuorG
3DxeTlaM9BDnoataDtimsnarT
2DxeRlaM
Transmit on DB9 Female
eF9BDnoataDtimsnarT
noitpircseD
noitpircseDnoitpircseD
emaNemaN
emaN
emaNemaNnoitpircseDnoitpircseD
.oN.oN
.oN
.oN.oN
niPniP
niP
niPniP
5DNGSdnuorG
3DxeRlameF9BDnoataDeveiceR
2DxeTlam
Page 2
t
o
o eatu
e
ioatio
iaDi
IR
DVD Player
Video
Audio
HDX-PRO Transmitter Unit
Cat 5
Preparing & Connecting System CAT5 CablePreparing & Connecting System CAT5 Cable
Adjusting and Tuning the SignalAdjusting and Tuning the Signal
Adjusting and Tuning the SignalAdjusting and Tuning the Signal
In order to fine tune the signal, adjust the individual
Adjusting and Tuning the Signal
IR
HDX-PRO Reciever Unit
Audio
Video
dials one at a time starting with GREEN, then BLUE,
and lastly RED. As you turn the dials you will notice
the colors slightly change as you increase or decrease
the strength. All dials should be around the same
distance.
Preparing & Connecting System CAT5 CablePreparing & Connecting System CAT5 Cable
Preparing & Connecting System CAT5 Cable
Following is the wiring standard for terminating CAT 5 cable
using RJ-45 connector:
Conductor Gauge:Conductor Gauge:
Connectors:Connectors:
Connectors:Connectors:
Capacitance:Capacitance:
Capacitance:Capacitance:
Conductor Gauge:Conductor Gauge:
Pair 1 Pins 1 & 2
Pair 2 Pins 3 & 6
Pair 3 Pins 4 & 5
Pair 4 Pins 7 & 8
Connectors: RJ-45
Capacitance: 14 pf/ft (46.2 pf/m)
Conductor Gauge: 24 AWG
a
D
t
tata
n i
Remote Monitor
Speakers
Connecting The Transmitter
1. Connect the output of component video source to the
video input of the transmitter using RCA to RCA cable
2. Connect audio source to
x
the audio input of the transmitter using audio rca cable
5. In the back of the unit connect the CAT5 cable that
will connect to the receiver (XTPRO-RX).
*NOTE: You can not use RS232 and IR at the same time.
Connecting The Receiver
1. Connect CAT5 cable (coming from the transmitter) to
the back of the receiver.
2. Connect display monitors to the RCA
tnetnoCegakcaPtnetnoCegakcaP
tnetnoCegakcaPtnetnoCegakcaPHDX-PROX
tnetnoCegakcaP
connectors on the front of the receiver.
3. Connect a sets of external speakers to the audio
.oNtraP.oNtraP
.oNtraP
smetIsmet.IoNtraP.oNtraP
smetI
output connections on the front of the unit.
)1tf6(elbac
AGVelamotelam51DD6H0-MMAGV-CC
y2lppusrewopcdtlovS5U-A1D5-SP
lanoitpOlanoitpO
lanoitpO
lanoitpOlanoitpO
e1lbacgulpinimoeretsmm5.3oidu6A0MMDA-CC
.1tf69BDf/mlaire6S0FMRESCC
r In
The HDX-PRO range of products allows the extension
of a wide range of video and audio formats, RS232,
and IR via a single Category 5 Unshielded Twisted
r
Supports HDTV Screen
F
Pair (UTP) cable.
Output reaches up to 1,000 feet (300 m).
Uses easy to install, inexpensive CAT-5/5e/6/7/8.
Y,Pb, Pr
300 MHz Bandwidth.
Resolutions up to 1900x1200.
Audio, RS232 and IR
Sends high-resolution HDTV component, Stereo
High ground loop immunity.
Compatible with Line Level Stereo Audio Signals.
Built-in lightning, power surge and transient
protection.
Designated trimmer in the remote unit to
Compact Metal Case Enclosure.
compensate for cable length.
Supports RS232 and IR
HDX-PRO
Please check the contents of the package before
beginning installation.
ytQytQ
ytQ
ytQytsQmetIsmetI
1 HDX-PRO Transmitter Unit HDX-PRO-TX
1 HDX-PRO Receiver Unit HDX-PRO-RX
1revieceREYEREIYE-MS
1rettimERDIEL-MS
Loading...