SMART-AVI DVX500 User Manual

Page 1
© Copyright 2007 Smart-AVI, All Rights Reserved
Notice
The information contained in this document is subject to change without notice. Smart-AVI makes no warranty of any kind with regard to this material, including but not limited to, implied warranties of merchantability and fitness for any particular purpose.
Smart-AVI will not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance or use of this material.
No part of this document may be photocopied, reproduced or translated into another language with out prior written consent from Smart-AVI.
The DVX500 extends any DVI-D signal,
with keyboard and mouse to 500ft with
UTP Cat5e cable
DVX500
www.smartavi.com
User Manual
2840 N. Naomi Ave.
Burbank, California 91504
Phone: (818) 565-0011
Facsimile: (818) 565-0020
Technical Specifications
Input/Output Signal
Pin # Signa l Pin # Signa l
1 T.M.D. S Data 2- 16 Hot Plug Detect 2 T.M.D.S Data 2+ 17 T.M.D.S Data 0­3 T.M.D.S Data 2/4 Shield 18 T.M.D.S Data 0+ 4 T.M.D.S Data 4- 19 T.M.D.S Data 0/5 Shield 5 T.M.D.S Data 4+ 20 T.M.D.S Data 5­6 DDC Clock 21 T.M.D.S Data 5+ 7 DDC Data 22 T.M.D.S Clock Shie ld 8 Analog Vert. Sync 23 T.M.D.S Clock+ 9 T.M.D.S Data 1- 24 T.M.D.S Clock -
10 T.M.D. S Data 1+ 11 T.M.D.S Da ta 1/3 Shie ld C1 Anal og Red 12 T.M.D.S Data 3- C2 Analog Green 13 T.M.D.S Data 3+ C3 Analog Blue 14 +5V Power C4 Analog Horz Sync 15 GND C5 Analog Ground
Resolutions
Supported by the internal EDID configuration
640 x 480 85 Hz 800 x 600 85 Hz 1024 x 768 85 Hz 1152 x 870 75 Hz 1280 x 768 75 Hz 1280 x 960 60 Hz 1280 x 1024 60 Hz 1600 x 1200 60 Hz
Resolution Refresh Rate
Page 2
Introduction
The DV500 extends any DVI-D signal with PS/2 mouse and keyboard up to 500ft with single UTP Cat5 cable.
Features
Top Image Quality at all Resolutions.Video Resolutions up to 1600 x 1200 @
60Hz (1280 x 1024 @ 75Hz). on all distances up to the maximum distance.
User selectable: DCC-Information used from
the remotely located monitor, from the locally located Monitor or from an internal DDC Table.
Basic device to remotely locate Touch Screen
and Sound.
PS/2 Mouse.Maximum Screen Resolution on all distances:
500 ft w/ STP Cat5e.
Compatible with all operating systems.
Applications
Perfect Image Quality at all Resolutions. Call Centers (co-locate user’s computers). Industrial (protection against pollution). Information Terminals & Kiosks. Airports (air traffic control, passenger
information systems).
Medical - using computer tomographs generates
strong magnetic fields, which make it impossible to use monitors.
Installation
To install your DVX500
1.
Turn off computer and monitor.
2. Connect your keyboard, monitor(s) and mouse
to the remote unit (depending on device type). Please insure that the mouse and keyboard are connected properly.
3. Using the supplied CPU KVM cable, connect the
keyboard, monitor(s) and mouse connectors on the computer. Please insure that the mouse and keyboard are connected properly.
4. Connect a shielded Cat 5e cable
between the DVX500-TX and the DVX500-RX
7. Connect the power supplies to the transmitter
and receiver.
8. Turn on the monitor and computer.
Installation Diagram
Pair 1 Pins 1 & 2 Pair 2 Pins 3 & 6 Pair 3 Pins 4 & 5 Pair 4 Pins 7 & 8
Connectors: RJ-45 Capacitance: 14 pf/ft (46.2 pf/m) Conductor Gauge: 24 AWG Impedance: 100 +/- 15 ohms 4 - Pair, (stranded) Foil Shielded
Prepairing System CAT5e Cable
Keyboard MouseDVI
DVI In
DVI Out
PS/2 Mouse / Keyboard
Power 5V Power 5
V
UTP Cat5e
Keyboard M ouse
OutputInput
PS/2 Keyboard
PS/2 Mouse
DVID
DVI
DVX500 Transmitter DVX500 Reciever
Loading...