Smart512 Mini Beam User Manual

8 AFTER SERVICE

○

1 Our company offer technical consultation to customers for ever.

○2 If the machine is wrong and need repairment, please truthfully fill in the related content and

feedback us the problems timely, as well as we have to improve the product.

○

3 In addition to the lamp, also matching accessories are as follows：

accessories：Power line 1 piece Optional parts：(customers）
Signal line Users manual 1 sheet

Light hook

Note:

Based on our company continue to improve the product, the statement containing data may have
changed, and will not notice the change any more. Company retains its right to change specifications
related when product is improved. Thanks for your understanding

Innovation, Quality, Performance

User Manual

Mini moving head led beam

Professional Entertainment Equipment

TABLE OF CONTENTS

1. Safety Instructions

2. Technical Specifications

3. How To Set The Unit

4. Channel modes

5. DMX512 Signal Connection

6. Troubleshooting

7. Fixture Cleaning

8. After Service

6.Throubleshooting

Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work

1. Check the connection of power and main fuse.

2. Measure the mains voltage on the main connector.

3. Check the power on LED.

B. Not responding to DMX controller

1. DMX LED should be on. If not, check DMX connectors, cables to see if link properly.

2. If the DMX LED is on and no response to the channel, check the address settings and
DMX polarity.

3. If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
unit or the previous one.

4. Try to use another DMX controller.

5. Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.

C. Some units don’t respond to the easy controller

1. You may have a break in the DMX cabling. Check the LED for the response of the master/
slave mode signal.

2. Wrong DMX address in the unit. Set the proper address.

D. No response to the sound

1. Make sure the unit does not receive DMX signal.

2. Check microphone to see if it is good by tapping the microphone

E. One of the channels is not working well

1. The stepper motor might be damaged or the cable connected to the PCB is broken.

2. The motor’s drive IC on the PCB might be out of condition

7 Fixture Cleaning

The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit’soptics.

Clean with soft cloth using normal glass cleaning fluid.

 Always dry the parts carefully.
 Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days.