Smart MN600 DATASHEET

MN600 Cinema STEREOCHECK

Dual 6 Channel Active Cinema Booth Monitor

The MN600 Cinema STEREOCHECK is a new booth monitor designed to complement the MOD VI
stereo processor in both form and function. This monitor employs a solid state mono bridged ampli­fier and a high efficiency 2.5 inch speaker mounted on a 3.5 inch high rack mount panel. The MN600
can monitor any of six channels (LEFT, CENTER, RIGHT, LEFT SURROUND, RIGHT SURROUND, and
SUBWOOFER) on both amplifier and processor outputs. Bi-amped LEFT, CENTER, and RIGHT ampli­fier signals can be monitored through terminal strip hookups.

Connections. The MN600 provides a variety of interfaces on the rear panel for easy connection to any

processor and amplifier combination. A 9 pin D-type subminiature connector
(shown at the left) is provided for connection through a standard cable to
SMART’s TA6300 Six Channel Amplifier. The 25 pin D-type shown below
allows for connection to the MOD VI’s Digital Smart Port using a standard 25

pin cable. Additionally, a 16
position terminal strip provides redundant signal connec­tions for nonstandard cable hookups. The inputs are
clearly labeled on the back
of the MN600, with all the
amplifier inputs suffixed by
“AMP” and all the proces­sor inputs suffixed by
“PROC.”

Power. The MN600 is powered by the power supply
provided with the MOD VI. The PROCESSOR IN port
receives a 15 Volt supply through pin 12. For applications
not using the PROCESSOR IN port, the two position termi­nal strip labeled “+15VDC” and “GND” may be used with
a 15VDC, 500mA power supply.

(800) 45-SMART

Devices, Inc.

[phone]

PIN SIGNAL
1 LEFT
2 CENTER
3 RIGHT
4 LEFT SURROUND
5 RIGHT SURROUND
6 SUBWOOFER
7-9 GROUND

PIN SIGNAL
12 +15VDC
15 SUBWOOFER
17 RIGHT SURROUND
19 LEFT SURROUND
21 RIGHT
23 CENTER
25 LEFT
16,18,20,22,24 GROUND

AMP IN - DB9 Input

PROCESSOR IN - DB25 Input