
Mifare & ISO14443A-4 UID Slender Series Reader
Design & Technologies
Read both CSN and Sector of Mifare card and
FULL UID of Mifare Plus and DesFire card.
Support on-site Reader Configuration Card to
change certain parameters.
Tamper protection
APINcanbesetinsidethecardto
authenticate with the reader so that “Card +
PIN” mode can be implemented without
Friendly Installation
“Touch” number pad does not
carry any moving parts, which
implies more durable.
Economical mullion mounts type.
Design with customer logo is possible.
Door Bell function for Number pad reader.
Number pad use “touching sensor”, the latest
technology and individual number backlit when
touch.
Easily see under dark environment.
Could be use as a door location
Universal back plate allows
thereaderbeinstalledon
different size of gang box.
Reverse power protection.
All weather proof design with
IP65 certificate.
All inputs are 12Vdc
protected.
Non-drop bottom screw made
servicing handier.
All input and output signals are
protected against static
charges.
Stainless steel Security
screw is an option

FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Model Number: X1X2N1N2N3–N4X
3
RF Technologies Reader Appearance and Function
N13 = Normal Reader
N25 = Normal Reader
X1X2MW = Mifare + Mifare UID +DesFire UID
2 = Read UID / Card Number
N
3
3 = Reader Sector (HF Only)
N48 = Pigtail
X3N = No Number pad; K = Number pad