Smarfid Security Equipment MF34X8 Users Manual

Mifare Contactless Reader (MW3528) Operation Manual
ver1.0

Model：MW3528

General

This is a Mifare flash reader. When a card is being read by the reader, the reader will lit up.

Reader Start up

When reader power up, the reader will lit ON. The Red LED will blinks for 5 seconds. After 5 seconds, the reader
will ‘beep’ to indicate the start up procedures is finished.

Installation Diagram

1. The back part shall fit on the wall.

2. The cover shall clip on the upper edge of the back part first.

3. Af ter, tighten the screw goes underneath of the reader to fix the reader with the back part.

Operating Specification:

Operating Voltage

Operating current

Operating Temperature

120mA

9-13VDC

-20℃ - 60℃

Typical read range

Standard Color

Exterior dimension

5cm

Black

150mm×53mm×25mm

SIEMENS Mifare Contactless Reader Operation Manual ver1.0

Function Description

Wiring Connection Table

Color Label Description

Red +12Vdc Power Supply to the reader

Black GND Signal GND

Green Data0 Wiegand Output data, D0

White Data1 Wiegand Output data, D1

Yellow R_LED No use

Blue B_LED Blue LED control, active low

Brown Buzzer Can be control by outside device, active low

Grey No use No use

Physical Dimension