SLX SLx, Designer Indoor TV Aerial User Manual

Designer Indoor TV Aerial

USER GUIDE

Setting up your aerial

27772RG

Philex Customer Careline: 08457 573 479

4. Power ON/
Gain Adjust Knob

1. Socket for
12VDC/50mA
Power Adaptor

LED Power
Indicator

2. Coax Cable
Signal Out
To TV

1. Plug the lead from the 12VDC/50mA Power Adaptor (supplied) into the
DC in socket on the back of your aerial.

2. Plug the coax cable running from the back of the aerial into the ANT IN (aerial input)
on the back of your television (or VCR/Satellite Receiver/PVR if preferred).

3. Plug the 12VDC/50mA Power Adaptor into
a mains wall socket and switch on.

4. Turn the Power ON/Gain adjust knob to MAX
(as far to the right as it will go). The LED on the
front of the aerial will light up to indicate that
the power is on.

5. Position the aerial to obtain the best reception.
If there is no picture or the picture breaks up/
freezes reduce the gain a little (turn knob to the
left) and try again. Repeat the process until you
nd the optimum aerial position and amount
of gain..

Ready

Troubleshooting

Other Recommendations

Place the antenna away from metal surfaces to
avoid interference.
For the best reception choose a position for your
aerial near a window which faces the nearest
transmitter. Check neighboring outdoor aerials
to nd the direction of the transmitter.*

Safety Precautions

This appliance is not waterproof. It is for indoor
use only and must not be positioned where it
could be exposed to dripping or splashing water.
Objects containing liquids should not be placed
on or near the appliance.
To prevent risk of re, keep the unit and attached
wiring well away from naked ames.
Don’t attempt to open this product - there are no
user serviceable parts.

Care

To clean wipe gently with a soft non- abrasive
cloth. The cloth can be slightly moistened with
a diluted mild detergent solution providing the
aerial is rst switched o and disconnected from
the power adaptor.

LED does not light up

1. Check the mains and power adaptor connection and fuse.

Problems with DTT (Digital TV)

Unlike analogue terrestrial television, it is not possible to view DTT channel under weak signal strength
conditions. Therefore, typically you will either receive DTT channels with a clear picture and sound or
you will not receive any channels at all.

A weak digital signal can cause occasional blocking, freezing or

complete loss of picture. Try the following to improve the picture:

1. Adjust gain control.

2. Reposition the aerial at greater or lesser distance (vertically and horizontally) from your TV.

Blocking, freezing or complete loss of picture can also occur when a digital signal is too strong.

1. Adjust Gain control to obtain best picture result.

Useful Websites for Digital Advice:

*To conrm that your home is in a coverage
area, to nd out what DTT channels should be
available locally and to nd out where your
nearest transmitter is visit:

www.dtg.org.uk/retailer/coverage

To nd out your nearest transmitter’s distance
and compass bearing visit:

www.wolfbane.com/cgi-bin/tvd.exe?

This aerial is 4G Ready - built-in lter removes
interference and channel loss caused by 4G
mobile phone signals

Recommendations, Safety, Care and Support

© Philex Electronic Ltd. 2013 v1 MK42 0NX

Waste electrical and electronic products
should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority for recycling advice.

For further information or any queries please contact

Customer Careline: 08457 573 479 (Local rate – UK only)
Technical Support: www.philex.com/support

.