SLS SL4081BD, SL4081BN Datasheet

SL4081B

Semiconductor

Quad 2-Input AND Gate

High-Voltage Silicon-Gate CMOS

The SL4081B AND gates provide the system designer with direct

emplementation of the AND function.

• Operating Voltage Range: 3.0 to 18 V

• Maximum input current of 1 µA at 18 V over full package-
temperature range; 100 nA at 18 V and 25°C

• Noise margin (over full package temperature range):

1.0 V min @ 5.0 V supply

2.0 V min @ 10.0 V supply

2.5 V min @ 15.0 V supply

LOGIC DIAGRAM

ORDERING INFORMATION

SL4081BN Plastic

SL4081BD SOIC

TA = -55° to 125° C for all packages

PIN ASSIGNMENT

PIN 14 =VCC

PIN 7 = GND

FUNCTION TABLE

Inputs Output

A B Y

L L L

L H L
H L L
H H H

System Logic

SLS

SL4081B

Semiconductor

MAXIMUM RATINGS*

Symbol Parameter Value Unit

VCC DC Supply Voltage (Referenced to GND) -0.5 to +20 V
VIN DC Input Voltage (Referenced to GND) -0.5 to VCC +0.5 V

V

DC Output Voltage (Referenced to GND) -0.5 to VCC +0.5 V

OUT

IIN DC Input Current, per Pin ±10 mA
PD Power Dissipation in Still Air, Plastic DIP+

SOIC Package+

PD Power Dissipation per Output Transistor 100 mW

Tstg Storage Temperature -65 to +150 °C

TL Lead Temperature, 1 mm from Case for 10 Seconds

(Plastic DIP or SOIC Package)

*

Maximum Ratings are those values beyond whi ch damage to the device may occur.

Functional operation should be restricted to the Recommended Operating Conditions.
+Derating - Plastic DIP: - 10 mW/°C from 65° to 125°C

SOIC Package: : - 7 mW/°C from 65° to 125°C

750
500

260 °C

RECOMMENDED OPERATING CONDITIONS

Symbol Parameter Min Max Unit

VCC DC Supply Voltage (Referenced to GND) 3.0 18 V

VIN, V

DC Input Voltage, Output Voltage (Referenced to GND) 0 VCC V

OUT

TA Operating Temperature, All Package Types -55 +125 °C

mW

This device contains protection circuitry to guard against damage due to high static voltages or electric
fields. However, precautions must be taken to avoid applications of any voltage higher than maximum rated
voltages to this high-impedance circuit. For proper operation, VIN and V
GND≤(VIN or V

Unused inputs must always be tied to an appropriate logic voltage level (e.g., either GND or VCC).
Unused outputs must be left open.

System Logic

SLS

OUT

)≤VCC.

should be constrained to the range

OUT