SLS SL4066BD, SL4066BN Datasheet
SL4066B
Semiconductor
Quad Bilateral Switch
High-Voltage Silicon-Gate CMOS
The SL4066B is a quad bilateral switch intended for the
transmission or multiplexing of analog or digital signals. In addition, the
on-state resistance is relatively constant over the full input-signal
range.
The SL4066B consists of four independent bilateral switches. A
single control signal is required per switch. Both the p and the n device
in a given switch are biased on or off simultaneously by the control
signal.(As show in Fig.1.)The well of the n-channel device on each
switch is either tied to the input when the switch is on or to GND when
the switch is off. This configuration eliminates the variation of the
switch-transistor threshold voltage with input signal, and thus keeps
the on-state resistance low over the full operating-signal range.
The advantages over single -channel switches include peak inputsignal voltage swings equal to the full supply voltage, and more
constant on-state impedance over the input-signal range.
• Operating Voltage Range: 3.0 to 18 V
• Maximum input current of 1 µA at 18 V over full package-
temperature range; 100 nA at 18 V and 25°C
• Noise margin (over full package temperature range) :
1.0 V min @ 5.0 V supply
2.0 V min @ 10.0 V supply
2.5 V min @ 15.0 V supply
ORDERING INFORMATION
SL4066BN Plastic
SL4066BD SOIC
TA = -55° to 125° C for all packages
PIN ASSIGNMENT
LOGIC DIAGRAM
PIN 14 =VCC
PIN 7 = GND
FUNCTION TABLE
On/Off Control
Input
L Off
H On
State of
Analog Switch
SLS
System Logic
SL4066B
Semiconductor
MAXIMUM RATINGS*
Symbol Parameter Value Unit
VCC DC Supply Voltage (Referenced to GND) -0.5 to +20 V
VIN DC Input Voltage (Referenced to GND) -0.5 to VCC +0.5 V
V
DC Output Voltage (Referenced to GND) -0.5 to VCC +0.5 V
OUT
IIN DC Input Current, per Pin ±10 mA
PD Power Dissipation in Still Air, Plastic DIP+
SOIC Package+
PD Power Dissipation per Output Transistor 100 mW
Tstg Storage Temperature -65 to +150 °C
TL Lead Temperature, 1 mm from Case for 10 Seconds
(Plastic DIP or SOIC Package)
*
Maximum Ratings are those values beyond which damage to the device may occur.
Functional operation should be restricted to the Recommended Operating Conditions.
+Derating - Plastic DIP: - 10 mW/°C from 65° to 125°C
SOIC Package: : - 7 mW/°C from 65° to 125°C
750
500
260 °C
RECOMMENDED OPERATING CONDITIONS
Symbol Parameter Min Max Unit
VCC DC Supply Voltage (Referenced to GND) 3.0 18 V
VIN, V
DC Input Voltage, Output Voltage (Referenced to GND) 0 VCC V
OUT
TA Operating Temperature, All Package Types -55 +125 °C
mW
This device contains protection circuitry to guard against damage due to high static voltages or electric
fields. However, precautions must be taken to avoid applications of any voltage higher than maximum rated
voltages to this high-impedance circuit. For proper operation, VIN and V
GND≤(VIN or V
Unused inputs must always be tied to an appropriate logic voltage level (e.g., either GND or VCC).
Unused outputs must be left open.
System Logic
SLS
OUT
)≤VCC.
should be constrained to the range
OUT
Loading...