SLS SL4013BD, SL4013BN Datasheet
Semiconductor
Dual D Flip-Flop
High-Voltage Silicon-Gate CMOS
The SL4013B consists of two identical, independent data-type flipflops. Each flip-flop has independent data, set, reset, and clock inputs
and Q and Q outputs. These devices can be used for shift register
applications, and, by connecting Q output to the data input, for
counter and toggle applications. The logic level present at the D input
is transferred to the Q output during the positive-going transition of
the clock pulse. Setting or resetting is independent of the clock and is
accomplished by a high level on the set or reset line, respectively.
• Operating Voltage Range: 3.0 to 18 V
• Maximum input current of 1 µA at 18 V over full package-
temperature range; 100 nA at 18 V and 25°C
• Noise margin (over full package temperature range):
1.0 V min @ 5.0 V supply
2.0 V min @ 10.0 V supply
SL4013B
ORDERING INFORMATION
SL4013BN Plastic
SL4013BD SOIC
TA = -55° to 125° C for all packages
LOGIC DIAGRAM
PIN ASSIGNMENT
2.5 V min @ 15.0 V supply
FUNCTION TABLE
Inputs Outputs
Clock Data Reset Set Q Q
L L L L H
H L L H L
X L L Q Q
X X H L L H
SLS
System Logic
PIN 14 =V
PIN 7 = GND
CC
X X L H H L
X X H H H H
X = don’t care
SL4013B
Semiconductor
MAXIMUM RATINGS
*
Symbol Parameter Value Unit
V
CC
V
IN
V
OUT
I
IN
P
P
DC Supply Voltage (Referenced to GND) -0.5 to +20 V
DC Input Voltage (Referenced to GND) -0.5 to VCC +0.5 V
DC Output Voltage (Referenced to GND) -0.5 to VCC +0.5 V
DC Input Current, per Pin ±10 mA
Power Dissipation in Still Air, Plastic DIP+
D
SOIC Package+
Power Dissipation per Output Transistor 100 mW
D
750
500
Tstg Storage Temperature -65 to +150 °C
T
Lead Temperature, 1 mm from Case for 10 Seconds
L
260 °C
(Plastic DIP or SOIC Package)
*
Maximum Ratings are those values beyond which damage to the device may occur.
Functional operation should be restricted to the Recommended Operating Conditions.
+Derating - Plastic DIP: - 10 mW/°C from 65° to 125°C
SOIC Package: : - 7 mW/°C from 65° to 125°C
mW
RECOMMENDED OPERATING CONDITIONS
Symbol Parameter Min Max Unit
V
CC
VIN, V
OUT
T
A
This device contains protection circuitry to guard against damage due to high static voltages or electric
fields. However, precautions must be taken to avoid applications of any voltage higher than maximum rated
voltages to this high-impedance circuit. For proper operation, VIN and V
GND≤(VIN or V
Unused inputs must always be tied to an appropriate logic voltage level (e.g., either GND or VCC).
Unused outputs must be left open.
DC Supply Voltage (Referenced to GND) 3.0 18 V
DC Input Voltage, Output Voltage (Referenced to GND) 0 V
CC
Operating Temperature, All Package Types -55 +125 °C
should be constrained to the range
OUT
)≤VCC.
OUT
V
SLS
System Logic
Loading...