Slick CPP2600 User Manual

Charging the Power Pack

Using the Power Pack

POWER PACK

For Smartphones

Using the Power Pack (cont’d)

USB

PC

Charging Other Devices

CPP2600

Charging the Power Pack

MICRO USB INPUT
CHARGING PORT

USB OUTPUT
CHARGING PORT

Power Pack

Caution: Any changes or modications not expressly approved could void the user's

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment o and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

1

2

3

1. Flip-out phone stand

2. LED indicator light

3. Micro USB input charging port - for charging the
Power Pack

4. USB output charging port (1.0A) - for charging devices
such as smartphon

es

4

To charge the Power Pack:

1. Connect the small end of the included Micro USB cable to the Micro
USB input charging port on the Power Pack.

2. Connect the large end of the included Micro USB cable to an available
USB port on your computer or an AC power adapter (not included).

3. The LED indicator light will ash RED every two seconds when charging
to display device’s power level:

One Flash: The Power pack is approximately at 25% Charge.
Two ashes: The Power pack is approximately at 50% Charge.
Three Flashes: The Power pack is approximately at 75% Charge.
Four Flashes: The Power pack is approximately at 100% Charge.

4. When done charging, remove the cable from the ports.

To check if the Power Pack is charged:

Press the LED indicator light once. If it lights up BLUE, it is charged. The
LED indicator light will ash according to its level of power (see above).
Press again to turn the light o.

• Call the Customer Support number located below, or go to our website portal to receive an

SRO number.

To charge devices with the Power Pack:

1. Connect the USB end of your device’s charging cable to the USB output
charging port on the Power Pack.

2. Connect the other end of your device’s charging cable to your device’s
charging port (please refer to your device’s user guide for charging).

NOTE: If the device you are charging draws too much power from the
Power Pack, it will stop charging and go into standby mode. If this
happens, unplug the device from the Power Pack, then recharge the
Power Pack to get it back into charging mode.

Using the phone stand:

Flip out the built-in phone stand
to use as a cradle for your
smartphone.

Customer Support:

Phone: [phone]
Monday-Friday 8AM-10PM(EST)

www.southerntelecom.com
Click on “Product Support”