SKY WING Communication Electronics SK 258 User Manual

SKY WING SK-258B

SKYWING COMMUNICATION ELECTRONICS CO.,LTD.

How to pair with The Bluetooth enabled devices

Every SK-258B Bluetooth

TM

device has a unique name, Enabling devices to recognize each
other, and then connect them.
Step1. Open the toggle switch to ON, the blue LED will flash 6 times then press the” Play
Pause” button,

The blue LED will flash with the red LED, the Bluetooth is in pair mode.
Step2.Set your devices “Bluetooth switched on”, and then search new devices
Step3.The Bluetooth device SK-258B will find a new headset named ” 258B”, enter a

PIN“0000”,and then connect with Bluetooth speaker(for 99% of Bluetooth speaker, this

code is“0000”)

Step4.The Bluetooth device and speaker would connect, and you should get a connection

message like “Hands Free Connection Established” or something like that
Step5.That's it! The Bluetooth devices are now paired.

Tips:

1. Provided you set the Bluetooth power to“On”,after the initial connection has been made, the

Bluetooth device will automatically re—connect to the Speaker.

2. Test Your Connection: Turn off the speaker and observe the Bluetooth device to

say“Disconnected”.Then turn on the speaker again and the Bluetooth device should be

connected automatically and displays “Bluetooth Connected”.

Button function:

1. “ ”: VOL+/Next, long press ;Volume up ,short press: Next song

2. “ ”: VOL-/Previous, long press; Volume down, short press: Previous song

3. “ ”: short press: Pause/Play/Answer/End, double-click: Last number redial，Long press

3 seconds：Reject Calls

Interface:

1. “OFF/ON”; Turn off and Turn on the speaker

2. “AUX”: With 3.5mm audio jack, connect to MP3/MP4/CD/PC/MAC/PSP,etc.

3. “DC5V”Charge the battery by using USB cable

Warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.

.