Skywell 5TE Quick Start User Manual

SKYWELL 5TE
Quick Start User Guide

Atmospheric Water Generator

5T INFORMATION AVAILABLE AT SKYWELL.COM

Administrator Manual
Quick Start User Guide

When using electrical appliances, basic safety precautions should be followed to
reduce the risk of fire, electric shock and injury to persons or property.

If the Skywell 5T is without power for more than 4 consecutive hours:
DO NOT drink the water.
Contact your dealer technician to fully clean the Skywell 5TE.

Version August 6, 2018

DISPENSE WATER

Dispense Cold Water
After water generation, it may take up to 90 minutes for the water to reach its

maximum cold temperature of 2.7° Celsius (36°F). During this time, the compressor
may run continuously. Cold water available for dispense will be aligned with
overall water generation, which is influenced by the ambient conditions.

1.

Place your cup on the center of the drip tray.

2.

Press the blue circle button to the right of the touch screen to dispense cold
water.

3.

Press the blue circle button for the duration of the dispense until the desired fill
level is obtained

Child Safety Lock
Hot Dispense Button

Cold Dispense Button

Dispense Hot Water
After water generation, the Skywell is able to heat the water up to 97.7°

Celsius/208°F within 15-20 m inutes. Hot water available for dispense will be al igned
with overall water generation, which is influenced by the ambient conditions.

1.

Place your cup on the center of the drip tray.

2.

Press and release the top red unlock button (Child Safety Lock) on the left of
the touchscreen. You have approximately 10 seconds to begin hot water
dispense before the red unl ock button will need to be pressed again.

3.

Press the bottom red circle button (below the red unlock button) to dispense
hot water. U se with caution.

4.

Press the red circle button for the duration of the dispense until the desired fill
level is obtained.

5.

Never allow children to dispense hot water without proper and direct adult
supervision.