Skytec STM-3005REC Instructions Manual

4 CHANNEL PROFESSIONAL MIXER

STM-3005REC

172.916

INSTRUCTIONS

FEATURES：：：：

1. MICPHONES:

DJ/Mc have their own dedicated level control. Microphones have individual 2 band EQ section

2. TALKOVER

This is a two position switch OFF/ON

3. TRIM CONTROLS

Each of the music channels has a rotary trim control. The gain control adjusts the input level allowing the user to reduce or increase
the sound level. NOTE: care should be taken not to produce distortion with these controls as this could result in damage to both the
unit and any external equipment connected.

4. TONE CONTROLS

Each channel has dedicated Bass, Mid and High controls. NOTE: Care should be taken not to distort the output signal using these
controls.

5. CHANNEL LEVEL

These are used to adjust the output level for each channel.

6. CROSSFADER

The crossfader allows the mixing of one source into another .The crossfader in your unit is removable and can be easily replaced if
needed.

7. CHANNEL SELECTORS

These are used to switch between Line input and PHONO、MIC input on each channel.

8. ASSIGN SWITCHES

Any of the four music channels can be assigned to either side of the crossfader by the setting of these switches.

9. LED DISPLAYER:

The unit has two LED displays Left output, Right output the left and right output display shows the
output level of the mixer.

10. POWER:

Power switch

11. MASTER:

This controls the overall output from the mixer, master output to the PA system

12. PHONES LEVEL

This controls the output volume of the headphones. Care should be taken not to have this set to high as
it could result in damage to both the hearing of the user and the headphones. The channel to be monitored is selected via the cue
assign control Knob.

13. CUE SELECTOR

Select each channel of the CUE signal

14. HEADPHONE

1/4' jack headphone out

15. MP3 MODE

This mode can be loading or recording MP3 from the USB stick.

16. MP3 DISPLAYER

17. POWER INPUT

Please ensure the correct voltage is selected for your country. Failure to set the correct voltage will cause damage to the unit.

18. MIC 2 INPUT

1/4” Jack input.

19. CHANNEL 1

PHONO 1 INPUT/line1 JACKS

20. CHANNEL 2

PHONO 2 INPUT/line2 JACKS

21. CHANNEL 3

Line3 JACKS

22. CHANNEL 4

Line4 input/mic2 JACKS

23. REC OUT

Line level unbalanced RCA connectors.

24. MASTER OUTPUTS

Left & Right line level Unbalanced RCA outputs.

SPECIFICATIONS:
INPUTS:
DJ MIC………………………………………………………………..……1.5mv/1K Ohm unbalanced
PHONO……………………………………………………………………………………3mv/680 Ohm
LINE…………………………………………………………………………………….150mv/27K Ohm
OUTPUTS:
REC……………………………………………………………………………….………350mv/5K6 Ohm
MASTER……………………………………………………………………………………. 1V/5K6 Ohm
GENERAL:
Frequency Response…………………………………………………………..….20Hz-20KHz @ ±±±±2dB
THD………………………………………………………………………………….………..……… 0.1%
S/N Ratio…………………………………………………………………………………….…..….>80 d B
Headphone Impedance…………………………………………………………………….………32 Ohm