Skytec 178.403,KA-06,178.406,KA-08,178.409,KA-10,178.412,KA-12,178.415,KA-26,178.418,KA-28,178.421,KA210,178.528,SPD-8V,178.530,SPD-10V,178.532,SPD-28V,178.534,SPD-210V Instruction Manual

KA-SERIES

SPD-Series (VHF)

178.403 KA-06

178.406 KA-08

178.409 KA-10

178.412 KA-12

178.415 KA-26

178.418 KA-28

178.421 KA210

178.528 SPD-8V

178.530 SPD-10V

178.532 SPD-28V

178.534 SPD-210V

Instruction Manual

Gebruiksaanwijzing

Gebrauchsanleitung

SPECIFICATION:

Model KA-06 KA-08 KA-10 KA-12 KA-26 KA-28 KA-210
Ref.

178.403 178.406 178.409 178.412 178.415 178.418 178.421

Power max. Total 400W 600W 800W 1200W 800W 1200W 1600W
Frequency Response:

55Hz-

20kHz

50Hz-

20kHz

40Hz-

20kHz

30Hz-

20kHz

55Hz-

20kHz

50Hz-

20kHz

40Hz-

20kHz

SPL max 120dB 123dB 125dB 128dB 120dB 123dB 125dB
Impedance 8 Ohms
Input Sound Source: Line Input
Woofer size inch : 6,5" 8" 10" 12" 2 x 6,5" 2 x 8" 2 x 10"
Woofer size cm : 16 20 25 30 2 x 16 2 x 20 2 x 25
Tweeter type: Piezo Tweeter

Car reader memory
medium:

MMC Card, SD Card

Power supply: 230VAC at 50Hz

Model

SPD-8V SPD-10V SPD-28V SPD-210V

Ref.

178.528 178.530 178.532 178.534

Power max. Total 600W 800W 1200W 1600W
Frequency Response:

50Hz-

20kHz

40Hz-

20kHz

50Hz-

20kHz

40Hz-

20kHz

SPL max 123dB 125dB 120dB 123dB
Impedance 8 Ohms
Input Sound Source: Line Input
Woofer size inch : 8" 10" 2 x 8" 2 x 10"
Woofer size cm : 20 25 2 x 20 2 x 25
Tweeter type: Piezo Tweeter

Car reader memory
medium:

MMC Card, SD Card

Power supply: 230VAC at 50Hz
Wireless mic1. Freq. 200.175 MHz
Wireless mic2. Freq. 201.400 MHz

GB

Congratulations on the purchase of this SkyTec Karaoke set.
Please read this manual carefully prior to using the unit.

Warning:

- Read the manual prior to using the unit.

- Keep the manual for future reference.

- Keep the packaging for safer transport in its original packaging

- Prior to the first use, have the unit checked by a qualified person.

- The unit contains voltage carrying parts. DO NOT open the unit.

- When you unplug the unit from the mains always pull the plug, never the lead.

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualified
technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit
into a mains outlet.

- Repairs have to be carried out by a qualified technician.

- Only connect this unit to an earthed mains outlet of 230Vac/50Hz and 10-16A.

- Do no place the unit near heat sources.

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside
the housing. Please let the unit reach room temperature prior to use.

- To avoid accidents in public premises, the legal requirements must be fulfilled and
instructions/warnings must be adhered to.

- Keep out of the reach of children.

- All volume controls must be set to zero prior to switching the unit on.

- Do not use cleaning sprays for the slider controls. The residues of these spray cause
dust deposits in the controls. If a problem occurs, please consult a specialist.

- Do not clean the unit with chemical solutions. This might damage the finish. Only use a
dry cloth for cleaning.

PARTS DESCRIPTION

Thanks you for choosing our products.
Please take a few moments to read these instructions carefully, as we want you to enjoy your
new products quickly and to the full. The series of amplifier with new design of model and nice
looking, can suit different occasions, especially for office, meeting, exhibition, outside party,
teaching etc. The series is provided with wired, amplifying and amusement; fully embody high
quality, low price, portability and convenience. We believe firmly that the series of amplifier will
become your good assistant and friend because of its advantages.

FRONT PANEL:

1. Microphone delay knob

2. Microphone volume knob

3. Echo control knob

4. Master volume control

5. Input selector

6. LED power meter

7. Microphone input sockets

8. MP3 player

9. Master 2 x 3-Band EQ

1. Guitar Input

2. Guitar Volume knob

3. Equalizer On/Off switch

4. Microphone bass control

5. Microphone treble control

6. Master volume control

7. Input selector

8. LED power meter

9. Microphone input sockets

10. Microphone volume knob

11. Echo control knob

12. MP3 player

13. Master 7-band equalizer

BACK PANEL:

OPERATION:

Connect the passive speaker with a good quality speaker cable to the speaker output connector
(21). WARNING: only connected the original slave speaker on the speaker output terminal!
If required connect an external signal source like a CD-layer to LINE IN (20).
Connect the device with an electric outlet (230VAC / 50Hz)

LINE INPUT (DVD, CD-player etc.):

1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel

2. Push the input selector to Audio position.

USB/SD:

1. Push the input selector to USB position.

2. Press PLAY button, MP3 begin to play.

MICROPHONE:

1. Inset the microphone to the MIC1, MIC2, MIC3 jack.

2. Adjust the MIC volume and tone control.

3. Adjust the echo control.

FINAL:
Adjust the master VOLUME
Adjust the master Equalizer (13) to get the right sound

20. Aux input

21. Speaker output

22. Power switch

23. AC (220V-240V) input