Skyrocket Toys 01942RX24G User Manual

A

U

TO

R

LAUNCH

LAND

DASH

R

LAUNCH

LAND

R

L

AU

T

O

MA

N

UA

L

F

L

IGHT

MOD

E

LAUNCH

LAND

R

L

A

U

T

O

M

AN

U

A

L

FLIGHT MODE

LAUNCH

LAND

NANO DRONE

POWERING UP AND PAIRING REMOTE

OFF ON

FLYING GUIDE

Turn the drone on. (Be sure that
drone is completely charged.

Place the drone on level surface for
calibration.

Se e re ver se .)

FLIGHT BASICS

To make flying easier, place the drone on the ground in front of you
with the drone facing away from you (green blades forward). You
should be facing the same way the drone is facing.

Press L AUNCH to aut omatically launch a few feet off the ground.

L

Turn on controller. (Before initial use,
install new batteries into controller.
Se e Reve rse.)

FLIGHT CONTROLS

Up

Rotate
Left

Down

Stunt Button

Power

Rotation Trim

Auto Mode Indicator

Rotate
Right

When LEDs turn solid, the drone is ready t o fly.

Fly For ward

Fly RightFly Left

Fly Back ward

Forward/

Ba ck war d Tri m

Left/Right Trim

Move LEFT ( Thr ot tle) thumbstick up or down to make drone fly
higher or lower and left or right to rotate.

R

Use RIGHT (Directional) thumbstick to fl y forwar d,
backward, left or right.

R

LAUNCH

LAND

Press L AND to automaticall y land.

Flight Mode

Manual Mode Indicator

LAUNCH/LAND BUTTON

To change the speed of
the drone, hold STUNT,

• Reset controller t o
factory settings:

Hold F Trim, B Trim,
and Power for

3 seconds.

PRESS TO LAUNCH

PRESS TO LAND

, and . The LED on
the controller will blink
once for slow, twice for
medium, and thr ee
times for fast.

If for any reason you need to immediately stop the drone, hold down the stunt
button (for drones that don't have a stunt button, use the video but ton) and
move bot h thumbsticks down and away from the center of the controller.

ONE TOUCH STUNTS

NOTE:

Once a stunt has been initiated, DO NOT adjust Throt tle or press any ot her controls until the stunt has been completed.

BARREL ROLL L EFT OR RIGHT

While flying forward (or reverse), tap the STUNT butt on.

Alternatively you can use the left thumbstick to land
the drone. Hold the lef t thumbstick all the way down
for about 2.5 seconds after the drone has safely
reached the ground, and the motors w ill stop spinning.

AUTO AND MANUAL FLIGHT MODES

AUTO mode is best for new
pilots. Begin by pressing the
LAUNCH button for takeoff.
The drone will hold its altitude,
and gradually fly up or down
when you press up or down on
the left thumbstick.

MANUAL mode is better for
experienced pilots. When the
left thumbstick is pushed all
the way up the drone will spin
its motors as fast as it can
while maintaining stability, and
when the left thumbstick is
pushed all the way down the
motors will stop spinning

019 42

completely.

FLIP IN 4 DIRECTIONS

1 Bring the drone to a mid-air hover without flying in any

direc tion. Remove finger from the RIGHT thumbstick .

2 While hovering, press and hold t he STUNT button.

3 Then quickly tap the RIGHT thumbstick in the direction

you want the drone t o flip.

CAUT ION!

The drone should be flying at least 6 feet in the air wi th a minimum clearance of 6 feet in all directions before
attempting stunt functions.

REPLACING DAMAGED BL ADES

Using a for k or tool,
gently pry the blade
from t he motor shaft.

Front

A

B

B

A

_

AAA/LR03/ R03 1.5V +

_

AAA/LR03/ R03 1.5V +

+ AAA/LR03/ R03 1.5V

_

DASH

NANO DRONE

MAINTENANCE

CONTENTS

• Nano Drone

• USB Charging Cable

• Controller

• 4 Replacement Blades

FAILSAFE GUIDE

When the drone

turns upside down,

the mot ors will

stop spinning.

When the drone goes out of range of the

controller, it will automatically land i tself

in its c urrent position. If the contr oller

comes back into range before the drone

lands, it is possible to cancel this

automatic landing by pressing up on the

left thumbstick.

TRIM ADJUSTMENTS

IF THE DRONE DRIFTS FORWARD: Press
"B" button several times until the dr one
stops drifting for ward.

IF THE DRONE DRIFTS BACK WARD:
Press "F" button several times until the
drone stops drifting backward.

Propellers Not Spinning?

If one or more of your drone's propellers will not spin, check for foreign objects

on or around the motor and pr opeller. Remove the pr opeller with a fork or

tweezers, clear debris, and then replace the pr opeller. Do not use excessive

force when putting the propeller on the motor.

When the drone's bat tery

is at 10% or less, the LEDs

on the dr one will begin to

blink rapidly until the

drone is turned of f.

IF THE DRONE DRIFTS LEFT: Press
"R" button several times until the
drone stops drifting left.

IF THE DRONE DRIFTS RIGHT: Press
"L" button several times until the
drone stops drifting right.

When the drone's bat tery is

depleted, the drone will

automaticall y land itself in its

current position. This

automatic landing cannot be

interrupted with the

controller.

If the dr one detects that no

input has been received by

the con troller f or 15

second s, the drone w ill

automaticall y land itself in

its current position.

IF THE DRONE SPINS COUNTER-CLOCK­WISE (VIEWED FROM ABOVE): Press the

button several times until the dr one stops
spinning.

IF THE DRONE SPINS CLOCKWISE

(VIEWED FROM ABOVE): Press the button
several times until the drone stops spinning.

TIPS:

#1: When the
controller LED flashes
3 times quickly, the
trim is at middle of
trim range.

#2: If you are
uncomfortable
trimming the drone in
flight, you can land
onto a f lat surface and
make your t rim
adjustments.

#3: To reset trim
adjustments, hold the
and the bu ttons

R

down for 2 seconds.

WE’RE HERE TO HELP

For que stions a bout
this p roduct:

Online: skyviper.com/support

Em ail:
[e-mail]

Phone:
1-888-674-5650

M-F 9am t o 6pm PST

Online V ideo Instructions &

Flying Tips av ailable no w at

SK YVIP ER.C OM

CONTROLLER MODE SET-UP

When the controller is OFF, press and hold
the flight mode button, L AUNCH/LAND
button, and POWER butt on for thr ee seconds
to toggle between mode 1 and mode 2.

Mode 2 (default, most commonly used)

LEFT thumbstick makes the drone go
up/down, and r otat e
clockwise/counter-clock wise. RIGHT
thumbs tick makes the drone fly for ward,
backward, lef t, and right.

Mode 1 (used in Australlia and most
Asian & European countries)

LEFT thumbstick makes the drone fly
forward/backward, and rotate
clockwise/counter-clock wise. RIGHT
thumbs tick makes the drone go up/down,
and fly left and right.

INSTALLING BATTERIES IN THE CONTROLLER

3 x1.5 V AAA (LR03)

*Screwdri ver not included. *Batter ies not included.

ADULT SUPERVISION REQUIRED

Befor e each use, an adult should check this product and the LiPo battery t o ensure no damage or hazar ds
exist. Drone has rotating blades that move at high speed, posing danger of damage and injury. Pilots are
responsible for any actions that result in damage or injury from the improper operation of drone.
Adequate flying space is required. Avoid flying near interior fans and/or vents as they may make flying
difficult t o contr ol. Keep a safe distance away from streets, public thoroughfares and power lines. Never
att empt to retrieve drone from any location higher than your reach (such as rooftops or trees) or from
any location that poses a safety hazard. Never fly drone at night. Keep drone in sight at all times during
operation. Discontinue operation immediately if drone flies out of your field of view. Do not fly near
spectators or animals. Keep spinning rotors away from fingers, hair, eyes and other body part s. Alway s
launch from a flat surface. Never leave drone unat tended while it is t urned on. Read all enclosed
information before operating.

THIS PRODUCT CONTAINS A LITHIUM-POLYMER BATTERY3.7V 100mAh:

LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused. They may

explode, overheat or ignite.Read all following precautions and instructions regarding the care and use
of LiPo batteries. 

The LiPo battery is only to be used with the drone and charger included with this product.

• Keep away from flammable materials.

• Do not expose to direct sunlight.

• Do not place in fire or leave in hot places.

• Do not drop or make subject to strong impact.

• Keep dry and away from water.

• Remove exhausted battery as soon as possible and discard properly.

• Remove battery from the compartment if toy is not used for a long period of time.

• The supply terminals are not to be short circuited.

• Never throw battery in a fire or attempt to open outer casing.

• Do not leave battery connected to drone when not in use.

• Do not stress, press or drop the battery.

• Never charge battery unattended. When charging battery you should always remain in constant observa­tion to monitor the charging process and react to potential problems that may occur.

• Disconnect with the charging wire if the battery is fully charged.

• Never store or charge battery inside the car in extreme temperatures, since extreme temperature could
ignite fire.

• Use caution to avoid puncture of the battery. Puncture of battery may cause a fire.

LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly. They should not be
disposed of with other household waste. Check your local laws and regulations for correct recycling
and/or battery disposal.

AAA BATTERY CAUTIONS

• Do not use rechargeable batteries.

• Different types of batteries or new and old batteries are not to be mixed.

• Batteries are to be inserted using correct polarity.

• Remove exhausted batteries as soon as possible and discard properly.

• Remove all batteries from compartment if toy is not used for a long period of time.

• Never throw batteries in a fire or attempt to open the outer casing.

• Non-rechargeable batteries are not to be recharged.

• The supply terminals are not to be short circuited.

• Batteries should be replaced by an adult.

CHARGING THE DRONE

Insert charging cable.

Computer or
charging block.

OFF ON

Turn the drone off.

Red light = charging
Green light = fully charged

CHARGING PRECAUTIONS:

• After use, allow drone (battery on bot tom) to cool down to room temperature
before charging again.

• Charge battery in an isolated area, away from excessive heat or moisture.

• If you suspect that the batter y is damaged or swelling, discard the battery in accordance with
your country’s recycling laws.

• Do not modify, heat, or wet the battery in any way. Only recharge with provided char ger.

This devi ce complies with PART 15 of the FCC Ru les. Operati on is subject to the f ollowing two co nditions. (1) This de vice may not cause
harmful i nterference, a nd (2) this device m ust accept any inter ference recei ved, including i nterference th at may cause undesi red operation .

CAUTIO N: Changes or mo dificatio ns to this unit not exp ressly approved b y the party res ponsible
for compl iance could void the u ser’s authorit y to operate the e quipment.

NOTE: T his equipment ha s been tested and f ound to comply wit h the limits for a Cla ss B digital devic e, pursuant to Par t 15 of the FCC Rul es.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generat es, uses and can ra diate radio freq uency energ y and, if not instal led and used in acco rdance with the ins tructions, m ay cause harmful
interf erence to radio com munications. H owever, there is no guar antee that inter ference will not o ccur in a particul ar installatio n. If this
equipm ent does cause har mful interfer ence to radio or tel evision recepti on, which can be de termined by tur ning the equipme nt off and on,
the user is e ncouraged to tr y to correct the in terference by o ne or more of the fol lowing measures : Reorient or r elocate the rece iving
antenna - In crease the separ ation betwe en the equipment a nd receiver - Conn ect the equipm ent into an outlet on a c ircuit diffe rent from
that to whic h the receiver is conn ected - Consult t he dealer or an exp erienced rad io/TV te chnician for hel p.

This equi pment complies w ith FCC radiation ex posure limits s et forth for an un controlled envi ronment.
This trans mitter must not b e co-locate d or operating in co njunction wit h any other antenna or t ransmitter.
For Drone：This equipme nt should be inst alled and opera ted with minimum d istance 20cm bet ween the radia tor& your body.

When you use Spiderman Remote on hand, please keep 20cm from your body.

Remove all packaging attachments before giving the toy to a child.

Not suitable for children under 3 years due to small parts that could be swallowed.

Conforms to product safety standards ASTM F963.

Keep instructions for future reference. Do not discard.

©2018 Skyrocket LLC, Los Angeles CA 90066 USA. All Rights Reserved. Sky Viper and Skyrocket and their respective
logos are trademarks and/or registered trademarks of Skyrocket Toys LLC. All other trademark s, logos and copyrights
are the property of their respective owners, and there is no relationship express or implied with Skyrocket Toys LLC.

MADE IN CHINA .

WARNING:Batteries are harmful if swallowed. Please keep away from children.

Battery Disposal: Dispose of batteries according to the local laws and regulations of your region. Some
batteries may be recycled, and may be accepted for disposal at your local recycling center. If you are not
able to identify the applicable rules in your area, please check the instructions of the battery manufacturer.

Google Play and the Google Play logo are trademarks of Google Inc.

Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a ser vice
mark of Apple Inc., registered in the U.S. and other countries.