Skyrc SK-910013 Sparrow Instruction Manual
THINGS YOU’LL NEED
PWM Receiver
or
S-BUS Receiver
Remote Control
3S LiPo Battery
LiPo Battery Charger
FPV Monitor
HD FPV Goggle
or
IN THE PACKAGE
L Wrench
PWM Receiver Cable
SBUS Receiver Cable
3020 Propeller x 8
Socket Screw x 8
Main Body
-1- -2-
INSTRODUCTION
INSTRUCTIONMANUAL
Sparrow FPV Racer SK-910013
The SkyRC Sparrow FPV racer is designed for both indoor and outdoor FPV experience. Its
wheelbase is 120mm with pre-installed FC, ESC, Motors, Camera and advanced 5.8G Video
Transmitter. There are 4 LED indicators on the front and rear arms (front red, rear green).
Please carefully read the manual before operating, wish you enjoy your flights!
3020 Propeller
1105 3800KV
Brushless Motor
Mini Camera
Carbon Board
Carbon Board
6A ESC
Landing Arm
Naze32 Rev6
Flight Controller
25/200mW
5.8G Video TX
The Sparrow FPV Racer is not a toy. It is not suitable for using by any children under 14
years of age. During the flying, the propellers of Sparrow FPV Racer could cause injury to
people, animals and property. Do not touch Sparrow FPV Racer when propellers are
spinning and wait until the propellers have completely stopped before handing it.
Do not fly your FPV Racer over any public area, such as beaches, stadiums, populated
parks, or other people’s backyards and private areas. Do not fly near airport. In some
country, you need get appropriate authorisation from local government before your flying.
You are responsible for your own safety. You are responsible to take adequate precaution
by using the proper equipment and safety gear, and determining whether you have
adequate skill and experience. SkyRC disclaims all responsibility for any resulting
damage, injury, or expense. It is your responsibility to make sure that your activities
comply with applicable laws.
SAFETY PRECAUTIONS
FLIGHT CONTROLLER AND POWER DISTRIBUTION BOARD
VCCGND
LED Lights
PPM Receiver
SCL
SDA
GND
VCC
RC-CH1
RC-CH8
RC-CH7
RC-CH6
RC-CH5
RC-CH4
RC-CH3
RC-CH2
PWM
Receiver
I2C
Extension
Mini CameraFPV Interface
Parameter Setting
VCC
GND
VIDEO IN
VCC
GND
VIDEO OUT
SBUS Receiver
Signal VCC GND
LED Lights
Signal VCC GND
Signal
VCC
GND
Signal
VCC
GND
Signal
VCC
GND
ESC Connection ESC Connection
Front
Back
Signal
VCC
GND
Signal
VCC
GND
ESC Connection ESC Connection
ATTACHING PROPELLERS
1
2
3
4
To attach the propellers correctly, you need match the spin direction on the propellers with the number.
Peel off the number sticker before flying.
ADJUST CAMERA ANGLE
20°=Perfect 2nd stage FPV experience10°= flat vision, ideal to start and learn
CONNECTING RECEIVER
L Wrench
PPM Receiver
GND
VCC
RC-CH1
RC-CH8
RC-CH7
RC-CH6
RC-CH5
RC-CH4
RC-CH3
RC-CH2
PWM
Receiver
SBUS Receiver
Signal VCC GND
Signal
VCC
GND
Install 2.4G receiver:
Sparrow is compatible with three kinds of
2.4GHz receivers PPM/ SBUS/ PWM.
You can adjust camera angle between 10°and 20°.
-3- -4-
3S LiPo Battery
Loading...