SkyRC LiPoPal User Manual

INSTRUCTION MANUAL
LiPoPal
INTRODUCTION
Thank you for purchasing SkyRC's LiPoPal (SK-500007). Please read this entire operating manual completely and attentively as it contains important information and safety notes. LiPoPal is a very sophisticated electronic device that controlled by high performance microprocessor and precise resistors.
Wrist Strap Eyelet
Battery Capacity Gauge
FlightPower/ Thunder Power Adapter
FUNTIONS
There are two functions of this compact device:
Battery Checker
1. The LiPoPal can check the voltage of each cell of a lithium battery pack and remaining capacity in percentage %.
Self Voltage Balancer
2. This program can equalize the individual voltages to their lowest one. Balance operation automatically starts about 5 seconds after the battery pack is connected. When the voltage difference between cells over 0.02V, the balancer will start to work. The corresponding “V” will be blinking when it is balancing. When the voltage difference between cells reaches
0.01V or less, balance operation ends and the device enters the sleep mode and “SLP” will be displayed on the LCD.
Self Blancing
HOW TO USE
Simply connect the battery pack to 7 pins connector (XH type). Please note the negative lead or pin of the LiPo connector should match the “Negative” marked on the shell of LiPoPal. After the LiPo is connected, the LCD display the voltage of each cell and the built in balance will check the voltage. If the pack is not balanced, the balancer will start working. For TP/FP batteries, please use conversion adaptor which is included in this package.
Battery Checker & Balancer
%
v
v
v v
v v
LCD Display
Cell Voltage
Sleep Mode
%
Battery Connector Pitch 2.54mm
v
v
v v
v v
Wrist Strap
SAFETY NOTE AND CAUTION
The LiPoPal battery checker can only be used with the lithium polymer battery packs up to 6 cells. It cannot handle batteries of other cell sizes and types. During the measurement, the voltage of each cell may change time to time due to the battery itself and the ambient temperature, etc. The remaining capacity (Battery Fuel Gauge) display is based on voltage at no load. Since it may differ largely from actual remaining capacity according to the battery type, use it as a reference only.
%
v
v
Never connect the battery in reverse. Reverse connection may damage the inside of the device. Never get the LiPoPal wet. The LiPoPal houses precision electronic circuits which may malfunction if water or other solution enters the case. Do not use the LiPoPal by placing it on a combustible material. There is the danger of abnormal heating of the battery for some reason. Be careful not to cause a short circuit by pinching the cord of the battery pack. Shorting may cause abnormal heating or sparking of the battery. Disconnect the battery pack after use.
SPECIFICATIONS
Applicable Battery Pack: 2-6S LiPo Voltage Display Tolerance: +/-1.5% Voltage Display Resolution: 0.01v Voltage Display Range: 0-5v Balancing Current: 50mA
WARRANTY AND SERVICE
We guarantee this product to be free of manufacturing and assembly defects for a period of one year from the time of purchase. The warranty only applies to material or operational defects, which are present at the time of purchase. During that period, we will repair or replace free of service charge for products deemed defective due to those causes. You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any damage or subsequent damage arising as a result of misuse, modification or as a result of failure to observe the procedures outlined in this manual.
v v
v v
Case Size: 70x38x11mm Weight: 23g Operating Temperature: 10~+45°C Storage Temperature: -20~+60°C
Manufactured by SKYRC TECHNOLOGY CO., LTD. www.skyrc.com
- 1 - - 2 -
7504-0266-02
Loading...