Sky Phone SKYPLATE5 User Manual

User Manual

Design

To turn on the device, keep the ON button
pressed for a couple of seconds.

1 USB Port 6 Volume +/­2 Earphone Jack 7 Power key
3 Receiver 8 Microphone
4 Proximity Sensor 9 Rear camera
5 Front camera 10 Speaker

How to install SIM card and battery

Follow the steps shown on the image located in
the back part. Please note that the device has 2
slots for SIM cards.

Make sure that the back cover is well placed and
closed after you insert the SIM card(s).

How to proceed if the device gets blocked?

1. Press RESET button

2. Press ON button for a couple of
seconds

3. Take out the battery

Charge the battery

Before using the device for the first time or if
the battery has not been used for a long time,
you need to charge the battery.

Use only approved chargers, batteries and
cables. Unapproved chargers or batteries can
damage the battery or the device.

Connect the small end part of the charger to the
device’s multifunction slot and the big end part
of the charger to an electric source.

If you connect the charger in a wrong way, you
can seriously damage the device. The warranty
does not cover damage caused by an
inappropriate use.

After charging is complete, disconnect the
device from the charger. Disconnect first the
charger from the device and then from the
electric source. Do not take out the battery
before disconnecting the charger. This can
damage the device.

The charger does not have ON/OFF button, so,
in order to cut the electrical supply, the end user
should disconnect the charger from the electric
source. Please keep the charging cable close to
the device when it is charging, to avoid it to be
tight. To save energy, disconnect the charger
when it is not in use.

Information about
security

This section contains information about mobile
security. Some content may not apply to your
device. To avoid injury to yourself and others, or
damage to the device, read the safety
information before using the device.

Warning Failure to comply with these rules and
security warnings, the end user could suffer
serious injury or death.

Do not use damaged power cables or
connectors or loose plugs. Insecure connections

can cause electrical shock or fire

Do not touch the power cord with wet hands or
pull the cord to disconnect the charger. Doing

so could end up in electrocution.

Do not bend or damage the power cord. Doing
so could cause electric shock or fire.

Do not touch the power cord with wet
hands or pull the cord to disconnect the

charger. Doing so could cause an electric

shock.

Do not short-circuit the charger or the device.
Doing so could cause electric shock or fire, or
the battery may malfunction or explode.

Do not use the device outdoors during a
thunderstorm. Doing so could cause electric

shock, or the device may malfunction.

Use batteries, chargers, accessories and
supplies approved by the manufacturer.
Do not knock or drop the charger or device.

Handle and dispose of the device and the
charger with caution

Protect the device, battery and charger to
avoid damage

Do not store the device in heaters, microwaves,
hot cooking equipment, or high pressure
containers, or near them

Do not use or store the device in areas with
high concentrations of dust or airborne
materials

Do not bite or suck on the device or battery

Do not insert the device or supplied accessories
into the eyes, ears and mouth

Do not handle damaged batteries lithium ion or
leaking

Do not use the device in a hospital, on a plane
or car that could be interfered with by radio
frequency

Do not expose the device to heavy smoke or
fumes

If you use a hearing aid, contact the
manufacturer for information about radio
interference

Do not use the device near other equipment or
devices emitting radio frequency, such as
sound systems or radio towers

Turn off the device in potentially explosive
environments

If you notice that the device or battery emits
strange smells or sounds, or see smoke or
liquid leaving the device or battery, stop using
the device immediately