Skypatrol SP4700 User Manual

SP4700s

s products

user manua

1

SP4700 User manual

SP4700s

s products

user manua

2

Copyright and Disclaimer

The user manual may be changed without notice.

Without prior written consent of Skypatrol LLC Company Ltd., this user manual, or any

part thereof, may not be reproduced for any purpose whatsoever, or transmitted in

any form, either electronically or mechanically, including photocopying and recording.
Skypatrol LLC Company Ltd. shall not be liable for direct, indirect, special, incidental, or

consequential damages (including but not limited to economic losses, personal

injuries, and loss of assets and property) caused by the u e, inability, or illegality to

use the product or documentation.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposur limits set forth for an
uncontrolled environment. This equipment should be installed and
minimum distance 20cm between the radiator & your body.

operated with

FCC Warning

This device complies with Part 15
following two conditions:

of the FCC Rules. Operation is subject to the

(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

NOTE: Any changes or modifications to this unit not expressly approved by the arty
responsible for compliance could void the user's authority to operate the equipment.

SP4700s

s products

user manua

3

INSTRUCTIONS OF SAFETY

This chapter contains information on how to operate “SP4700 series product” safely.

By following these requirements and recommendations you will avoid dangerous

situations. You must read these instructions carefully and

operating the device!

ollow them strictly before

The built‐in battery of device need to be charged regularly every two months to

avoid over‐discharge and need to be stored in the dry and cool place.

The device uses 8V‐32V DC power supply. The nominal voltage is 12V DC.

It is advised to transport the device in an impact‐proof package.

Before usage, the device should be placed properly to ensure LED indicators (device

operation status) are visible.
Before demounting the device from the vehic e, it should be disconnecting all the

connection first.

SP4700s

s products

user manua

4

CONTENTS

1. SP4700 Series Introduction..................................................................................... 5

2. SP4700 series products specifications ....................................................................... 6

3. Product overview ....................................................................................................... 7

3.1 Check Part List ................................................................................................. 7

3.2 Open the device cap ......................................................................................... 9

3.3 Install SIM card.............................................................................................. 10

3.4 Connect USB data line ................................................................................... 10

3.5 Close the case ................................................................................................. 11

3.6 Installation Direction ..................................................................................... 12

4. Interface Definition & Cable Color ......................................................................... 13

5. User Combine Command ......................................................................................... 13

5.1 Command Error SMS .................................................................................... 14

5.2 Command Success SMS ................................................................................ 14

6. SMS Report Explanation ......................................................................................... 15

6.1 “W” Mode Report .......................................................................................... 15

6.2 “T” Mode GPS Report ................................................................................... 16

6.3 “T” Mode LBS Report ................................................................................... 17

7. Common commands ................................................................................................ 18

7.1 Set User Cell Phone Number ......................................................................... 18

7.2 Set User Password.......................................................................................... 19

7.3 Set Report Interval Mode Switching Condition. ............................................ 20

7.4 Set timing Report Interval to User ................................................................. 21

7.5 Set SIM Card APN. ........................................................................................ 22

7.6 Set GPRS Main erver ................................................................................... 23

7.7 Set GPRS Backup Server ............................................................................... 24

7.8 Set Timing Report Interval to GRPS Server .................................................. 26

8. LED Indicator Behavior ........................................................................................... 27

SP4700s

s products

user manua

5

1. SP4700 Series Introduction

The SP4700 series products are new generation vehicle or asset trackers and
telemetry device designed for maximum autonomy and ease for use. It is intended

for use to

protect and trace items such as containers‐caravan ‐fixed plant‐construction

equipment‐in

shore boats and truck trailers. It can also be used for temporary

tracking of vehicles for onsignment purposes as well as covert “slap and track”

operations. The features as follows:

 Double GPRS servers

 Flexible packet

 Dynamic report

 Profile

 Private hour mode

 Driving behavior

 Accident detection

 Single event

 Combination event

 Event flow

 Output wave shape

 Geo‐fence

 Firmware OTA

SP4700s

s products

user manua

6

2. SP4700 series products specifications

Specification
Dimension

94(L)X47(W)X20.5(H)mm

Weight

~83g (With battery)

Environment

Operating

temperature

‐40°C ~+80°C (without backup battery)
‐10°C ~+50°C (with backup battery)

USB

Mini USB

2.0

CPU

ARM

STM32F103

LED indicator

3 LED indicators

GSM & GPS & POWER

Power supply

External

DC 8 to 32V

Backup battery

Type :

Rechargeable, Li‐Po .7V, 750mAh

Power

consumption

≥230mA (Active Tracking)

≥25mA (Power Saving Mode)

≥10mA (Deep Sleeping Mode)

GSM/GPRS

Model (3G)

Built‐In

Air Prime HL8548

Band: GSM 850/900/1800/1900MHz

UMTS 850/900/1800/1900/2100MHz

Multiple‐slot Class 8 (dual band)/10 (quad band)

GPRS class 10/Station class B

TCP/IP over PPP

Model(2G)

Built‐In

Air Prime HL6528

Band : GSM 850/900/1800/1900MHz

Multiple‐slot Class 8 (dual band)/10 (quad band)

GPRS class 10/Station lass B

TCP/IP over PPP

SIM card

1.8V & 3. V

GPS
Internal antenna

25*25 with amplifier

External antenna

N/A

SP4700s

s products

user manua

7

Model 1

U‐Blox NEO 6M

Channel

50 Parallel Channels

Accuracy

Autonomous<2.5M

Sensitivity

‐162dBm

Sensor

Accelerate sensor

Built‐In, 3‐axis

Flash storage

16Mbits

Built‐In

3. Product overview

3.1 Check Part List

Before starting, check all the following items

missing, please contact your supplier.

have been included. If anythi g is

①Standard Part List

SP4700s

s products

user manua

8

②Optional Part List

Fuse

USB cable

Relay

Fasten tape

SP4700s

s products

user manua

9

3.2 Open the device cap

(Take G3C US‐3G product for example)

Remove screws in the back of device first. Then force to open the device cap as the

arrow direction.

Remove the device cap carefully.